net: dsa: bcm_sf2: Do not override speed settings

The SF2 driver currently overrides speed settings for its port
configured using a fixed PHY, this is both unnecessary and incorrect,
because we keep feedback to the hardware parameters that we read from
the PHY device, which in the case of a fixed PHY cannot possibly change
speed.

This is a required change to allow the fixed PHY code to allow
registering a PHY with a link configured as DOWN by default and avoid
some sort of circular dependency where we require the link_update
callback to run to program the hardware, and we then utilize the fixed
PHY parameters to program the hardware with the same settings.

Fixes: 246d7f77 ("net: dsa: add Broadcom SF2 switch driver")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dsa/bcm_sf2.c

@@ -890,15 +890,11 @@ static void bcm_sf2_sw_fixed_link_update(struct dsa_switch *ds, int port,
 					 struct fixed_phy_status *status)
 {
 	struct bcm_sf2_priv *priv = ds_to_priv(ds);
-	u32 duplex, pause, speed;
+	u32 duplex, pause;
 	u32 reg;
 
 	duplex = core_readl(priv, CORE_DUPSTS);
 	pause = core_readl(priv, CORE_PAUSESTS);
-	speed = core_readl(priv, CORE_SPDSTS);
-
-	speed >>= (port * SPDSTS_SHIFT);
-	speed &= SPDSTS_MASK;
 
 	status->link = 0;
 
@@ -933,18 +929,6 @@ static void bcm_sf2_sw_fixed_link_update(struct dsa_switch *ds, int port,
 		reg &= ~LINK_STS;
 	core_writel(priv, reg, CORE_STS_OVERRIDE_GMIIP_PORT(port));
 
-	switch (speed) {
-	case SPDSTS_10:
-		status->speed = SPEED_10;
-		break;
-	case SPDSTS_100:
-		status->speed = SPEED_100;
-		break;
-	case SPDSTS_1000:
-		status->speed = SPEED_1000;
-		break;
-	}
-
 	if ((pause & (1 << port)) &&
 	    (pause & (1 << (port + PAUSESTS_TX_PAUSE_SHIFT)))) {
 		status->asym_pause = 1;