Commit d3233433 authored by Alexander Shiyan's avatar Alexander Shiyan Committed by Mark Brown

regmap: irq: Allow using zero value for ack_base

In some cases, clear interrupt register may be at address 0.
This patch allows to use such configurations by adding additional
configuration bit to indicate this.

[With doc fix from Levente Kurusa <levex@linux.com> -- broonie]
Signed-off-by: default avatarAlexander Shiyan <shc_work@mail.ru>
Signed-off-by: default avatarMark Brown <broonie@linaro.org>
parent 319e2e3f
......@@ -113,7 +113,7 @@ static void regmap_irq_sync_unlock(struct irq_data *data)
* OR if there is masked interrupt which hasn't been Acked,
* it'll be ignored in irq handler, then may introduce irq storm
*/
if (d->mask_buf[i] && d->chip->ack_base) {
if (d->mask_buf[i] && (d->chip->ack_base || d->chip->use_ack)) {
reg = d->chip->ack_base +
(i * map->reg_stride * d->irq_reg_stride);
ret = regmap_write(map, reg, d->mask_buf[i]);
......@@ -271,7 +271,7 @@ static irqreturn_t regmap_irq_thread(int irq, void *d)
for (i = 0; i < data->chip->num_regs; i++) {
data->status_buf[i] &= ~data->mask_buf[i];
if (data->status_buf[i] && chip->ack_base) {
if (data->status_buf[i] && (chip->ack_base || chip->use_ack)) {
reg = chip->ack_base +
(i * map->reg_stride * data->irq_reg_stride);
ret = regmap_write(map, reg, data->status_buf[i]);
......@@ -448,7 +448,7 @@ int regmap_add_irq_chip(struct regmap *map, int irq, int irq_flags,
goto err_alloc;
}
if (d->status_buf[i] && chip->ack_base) {
if (d->status_buf[i] && (chip->ack_base || chip->use_ack)) {
reg = chip->ack_base +
(i * map->reg_stride * d->irq_reg_stride);
ret = regmap_write(map, reg,
......
......@@ -497,11 +497,13 @@ struct regmap_irq {
*
* @status_base: Base status register address.
* @mask_base: Base mask register address.
* @ack_base: Base ack address. If zero then the chip is clear on read.
* @ack_base: Base ack address. If zero then the chip is clear on read.
* Using zero value is possible with @use_ack bit.
* @wake_base: Base address for wake enables. If zero unsupported.
* @irq_reg_stride: Stride to use for chips where registers are not contiguous.
* @init_ack_masked: Ack all masked interrupts once during initalization.
* @mask_invert: Inverted mask register: cleared bits are masked out.
* @use_ack: Use @ack register even if it is zero.
* @wake_invert: Inverted wake register: cleared bits are wake enabled.
* @runtime_pm: Hold a runtime PM lock on the device when accessing it.
*
......@@ -520,6 +522,7 @@ struct regmap_irq_chip {
unsigned int irq_reg_stride;
bool init_ack_masked:1;
bool mask_invert:1;
bool use_ack:1;
bool wake_invert:1;
bool runtime_pm:1;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment