i2c: designware: prevent early stop on TX FIFO empty

If the Designware core is configured with IC_EMPTYFIFO_HOLD_MASTER_EN
set to zero, allowing the TX FIFO to become empty causes a STOP
condition to be generated on the I2C bus. If the transmit FIFO
threshold is set too high, an erroneous STOP condition can be
generated on long transfers - particularly where the interrupt
latency is extended.
Signed-off-by: Andrew Jackson <Andrew.Jackson@arm.com>
Signed-off-by: Liviu Dudau <Liviu.Dudau@arm.com>
Tested-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-designware-core.c

@@ -359,7 +359,7 @@ int i2c_dw_init(struct dw_i2c_dev *dev)
 	}
 
 	/* Configure Tx/Rx FIFO threshold levels */
-	dw_writel(dev, dev->tx_fifo_depth - 1, DW_IC_TX_TL);
+	dw_writel(dev, dev->tx_fifo_depth / 2, DW_IC_TX_TL);
 	dw_writel(dev, 0, DW_IC_RX_TL);
 
 	/* configure the i2c master */