Commit d48e2074 authored by Emmanuel Grumbach's avatar Emmanuel Grumbach Committed by Wey-Yi Guy

iwlwifi: move the RF kill logic from iwl_probe to transport

This is another clean up of the proble flow.
Signed-off-by: default avatarEmmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: default avatarWey-Yi Guy <wey-yi.w.guy@intel.com>
parent cc56feb2
......@@ -1815,13 +1815,6 @@ int iwl_probe(struct iwl_bus *bus, const struct iwl_trans_ops *trans_ops,
spin_lock_init(&trans(priv)->reg_lock);
spin_lock_init(&priv->shrd->lock);
/*
* stop and reset the on-board processor just in case it is in a
* strange state ... like being left stranded by a primary kernel
* and this is now the kdump kernel trying to start up
*/
iwl_write32(trans(priv), CSR_RESET, CSR_RESET_REG_FLAG_NEVO_RESET);
/***********************
* 3. Read REV register
***********************/
......@@ -1890,22 +1883,6 @@ int iwl_probe(struct iwl_bus *bus, const struct iwl_trans_ops *trans_ops,
iwl_setup_rx_handlers(priv);
iwl_testmode_init(priv);
/*********************************************
* 8. Enable interrupts
*********************************************/
iwl_enable_rfkill_int(priv);
/* If platform's RF_KILL switch is NOT set to KILL */
if (iwl_read32(trans(priv),
CSR_GP_CNTRL) & CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW)
clear_bit(STATUS_RF_KILL_HW, &priv->shrd->status);
else
set_bit(STATUS_RF_KILL_HW, &priv->shrd->status);
wiphy_rfkill_set_hw_state(priv->hw->wiphy,
test_bit(STATUS_RF_KILL_HW, &priv->shrd->status));
iwl_power_initialize(priv);
iwl_tt_initialize(priv);
......
......@@ -1393,6 +1393,17 @@ static int iwl_trans_pcie_start_hw(struct iwl_trans *trans)
iwl_apm_init(trans);
/* If platform's RF_KILL switch is NOT set to KILL */
if (iwl_read32(trans,
CSR_GP_CNTRL) & CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW)
clear_bit(STATUS_RF_KILL_HW, &trans->shrd->status);
else
set_bit(STATUS_RF_KILL_HW, &trans->shrd->status);
iwl_set_hw_rfkill_state(priv(trans),
test_bit(STATUS_RF_KILL_HW,
&trans->shrd->status));
return err;
error:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment