powerpc: ptrace generic resume

This removes the handling for PTRACE_CONT et al from the powerpc
ptrace code, so it uses the new generic code via ptrace_request.
Signed-off-by: Roland McGrath <roland@redhat.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>

arch/powerpc/kernel/ptrace.c

@@ -445,52 +445,6 @@ long arch_ptrace(struct task_struct *child, long request, long addr, long data)
 		break;
 	}
 
-	case PTRACE_SYSCALL: /* continue and stop at next (return from) syscall */
-	case PTRACE_CONT: { /* restart after signal. */
-		ret = -EIO;
-		if (!valid_signal(data))
-			break;
-		if (request == PTRACE_SYSCALL)
-			set_tsk_thread_flag(child, TIF_SYSCALL_TRACE);
-		else
-			clear_tsk_thread_flag(child, TIF_SYSCALL_TRACE);
-		child->exit_code = data;
-		/* make sure the single step bit is not set. */
-		user_disable_single_step(child);
-		wake_up_process(child);
-		ret = 0;
-		break;
-	}
-
-/*
- * make the child exit.  Best I can do is send it a sigkill.
- * perhaps it should be put in the status that it wants to
- * exit.
- */
-	case PTRACE_KILL: {
-		ret = 0;
-		if (child->exit_state == EXIT_ZOMBIE)	/* already dead */
-			break;
-		child->exit_code = SIGKILL;
-		/* make sure the single step bit is not set. */
-		user_disable_single_step(child);
-		wake_up_process(child);
-		break;
-	}
-
-	case PTRACE_SINGLESTEP: {  /* set the trap flag. */
-		ret = -EIO;
-		if (!valid_signal(data))
-			break;
-		clear_tsk_thread_flag(child, TIF_SYSCALL_TRACE);
-		user_enable_single_step(child);
-		child->exit_code = data;
-		/* give it a chance to run. */
-		wake_up_process(child);
-		ret = 0;
-		break;
-	}
-
 	case PTRACE_GET_DEBUGREG: {
 		ret = -EINVAL;
 		/* We only support one DABR and no IABRS at the moment */