Commit db10e201 authored by Josh Wu's avatar Josh Wu Committed by Jonathan Cameron

iio: at91: fix adc_clk overflow

The adc_clk variable is currently defined using a 32-bits unsigned integer,
which will overflow under some very valid range of operations.

Such overflow will occur if, for example, the parent clock is set to a
20MHz frequency and the ADC startup time is larger than 215ns.

To fix this, introduce an intermediate variable holding the clock rate
in kHz.
Signed-off-by: default avatarJosh Wu <josh.wu@atmel.com>
Acked-by: default avatarMaxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
parent c3cb718a
......@@ -556,7 +556,7 @@ static const struct iio_info at91_adc_info = {
static int at91_adc_probe(struct platform_device *pdev)
{
unsigned int prsc, mstrclk, ticks, adc_clk, shtim;
unsigned int prsc, mstrclk, ticks, adc_clk, adc_clk_khz, shtim;
int ret;
struct iio_dev *idev;
struct at91_adc_state *st;
......@@ -649,6 +649,7 @@ static int at91_adc_probe(struct platform_device *pdev)
*/
mstrclk = clk_get_rate(st->clk);
adc_clk = clk_get_rate(st->adc_clk);
adc_clk_khz = adc_clk / 1000;
prsc = (mstrclk / (2 * adc_clk)) - 1;
if (!st->startup_time) {
......@@ -662,15 +663,15 @@ static int at91_adc_probe(struct platform_device *pdev)
* defined in the electrical characteristics of the board, divided by 8.
* The formula thus is : Startup Time = (ticks + 1) * 8 / ADC Clock
*/
ticks = round_up((st->startup_time * adc_clk /
1000000) - 1, 8) / 8;
ticks = round_up((st->startup_time * adc_clk_khz /
1000) - 1, 8) / 8;
/*
* a minimal Sample and Hold Time is necessary for the ADC to guarantee
* the best converted final value between two channels selection
* The formula thus is : Sample and Hold Time = (shtim + 1) / ADCClock
*/
shtim = round_up((st->sample_hold_time * adc_clk /
1000000) - 1, 1);
shtim = round_up((st->sample_hold_time * adc_clk_khz /
1000) - 1, 1);
reg = AT91_ADC_PRESCAL_(prsc) & st->registers->mr_prescal_mask;
reg |= AT91_ADC_STARTUP_(ticks) & st->registers->mr_startup_mask;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment