drm/i915: Restore rps/rc6 on reset

A check of rps/rc6 state after i915_reset determined that the ring
MAX_IDLE registers were returned to their hardware defaults and that
the GEN6_PMIMR register was set to mask all interrupts. This change
restores those values to their pre-reset states by re-initializing
rps/rc6 in i915_reset. A full re-initialization was opted for versus
a targeted set of restore operations for simplicity and maintain-
ability. Note that the re-initialization is not done for Ironlake,
due to a past comment that it causes problems.

Also updated the rps initialization sequence to preserve existing
min/max values in the case of a re-init. We assume the values were
validated upon being set and do not do further range checking. The
debugfs interface for changing min/max was updated with range
checking to ensure this condition (already present in sysfs
interface).

v2: fix rps logging to output hw_max and hw_min, not rps.max_delay
    and rps.min_delay which don't strictly represent hardware limits.
    Add igt testcase to signed-off-by section.

Testcase: igt/pm_rps/reset
Signed-off-by: Jeff McGee <jeff.mcgee@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>

drivers/gpu/drm/i915/i915_debugfs.c

@@ -3223,6 +3223,7 @@ i915_max_freq_set(void *data, u64 val)
 {
 	struct drm_device *dev = data;
 	struct drm_i915_private *dev_priv = dev->dev_private;
+	u32 rp_state_cap, hw_max, hw_min;
 	int ret;
 
 	if (!(IS_GEN6(dev) || IS_GEN7(dev)))
@@ -3241,14 +3242,29 @@ i915_max_freq_set(void *data, u64 val)
 	 */
 	if (IS_VALLEYVIEW(dev)) {
 		val = vlv_freq_opcode(dev_priv, val);
-		dev_priv->rps.max_delay = val;
-		valleyview_set_rps(dev, val);
+
+		hw_max = valleyview_rps_max_freq(dev_priv);
+		hw_min = valleyview_rps_min_freq(dev_priv);
 	} else {
 		do_div(val, GT_FREQUENCY_MULTIPLIER);
-		dev_priv->rps.max_delay = val;
-		gen6_set_rps(dev, val);
+
+		rp_state_cap = I915_READ(GEN6_RP_STATE_CAP);
+		hw_max = dev_priv->rps.hw_max;
+		hw_min = (rp_state_cap >> 16) & 0xff;
+	}
+
+	if (val < hw_min || val > hw_max || val < dev_priv->rps.min_delay) {
+		mutex_unlock(&dev_priv->rps.hw_lock);
+		return -EINVAL;
 	}
 
+	dev_priv->rps.max_delay = val;
+
+	if (IS_VALLEYVIEW(dev))
+		valleyview_set_rps(dev, val);
+	else
+		gen6_set_rps(dev, val);
+
 	mutex_unlock(&dev_priv->rps.hw_lock);
 
 	return 0;
@@ -3288,6 +3304,7 @@ i915_min_freq_set(void *data, u64 val)
 {
 	struct drm_device *dev = data;
 	struct drm_i915_private *dev_priv = dev->dev_private;
+	u32 rp_state_cap, hw_max, hw_min;
 	int ret;
 
 	if (!(IS_GEN6(dev) || IS_GEN7(dev)))
@@ -3306,13 +3323,29 @@ i915_min_freq_set(void *data, u64 val)
 	 */
 	if (IS_VALLEYVIEW(dev)) {
 		val = vlv_freq_opcode(dev_priv, val);
-		dev_priv->rps.min_delay = val;
-		valleyview_set_rps(dev, val);
+
+		hw_max = valleyview_rps_max_freq(dev_priv);
+		hw_min = valleyview_rps_min_freq(dev_priv);
 	} else {
 		do_div(val, GT_FREQUENCY_MULTIPLIER);
-		dev_priv->rps.min_delay = val;
-		gen6_set_rps(dev, val);
+
+		rp_state_cap = I915_READ(GEN6_RP_STATE_CAP);
+		hw_max = dev_priv->rps.hw_max;
+		hw_min = (rp_state_cap >> 16) & 0xff;
+	}
+
+	if (val < hw_min || val > hw_max || val > dev_priv->rps.max_delay) {
+		mutex_unlock(&dev_priv->rps.hw_lock);
+		return -EINVAL;
 	}
+
+	dev_priv->rps.min_delay = val;
+
+	if (IS_VALLEYVIEW(dev))
+		valleyview_set_rps(dev, val);
+	else
+		gen6_set_rps(dev, val);
+
 	mutex_unlock(&dev_priv->rps.hw_lock);
 
 	return 0;

drivers/gpu/drm/i915/i915_drv.c

@@ -728,6 +728,17 @@ int i915_reset(struct drm_device *dev)
 
 		drm_irq_uninstall(dev);
 		drm_irq_install(dev);
+
+		/* rps/rc6 re-init is necessary to restore state lost after the
+		 * reset and the re-install of drm irq. Skip for ironlake per
+		 * previous concerns that it doesn't respond well to some forms
+		 * of re-init after reset. */
+		if (INTEL_INFO(dev)->gen > 5) {
+			mutex_lock(&dev->struct_mutex);
+			intel_enable_gt_powersave(dev);
+			mutex_unlock(&dev->struct_mutex);
+		}
+
 		intel_hpd_init(dev);
 	} else {
 		mutex_unlock(&dev->struct_mutex);

drivers/gpu/drm/i915/intel_pm.c

@@ -3322,7 +3322,7 @@ static void gen6_enable_rps(struct drm_device *dev)
 {
 	struct drm_i915_private *dev_priv = dev->dev_private;
 	struct intel_ring_buffer *ring;
-	u32 rp_state_cap;
+	u32 rp_state_cap, hw_max, hw_min;
 	u32 gt_perf_status;
 	u32 rc6vids, pcu_mbox, rc6_mask = 0;
 	u32 gtfifodbg;
@@ -3351,13 +3351,20 @@ static void gen6_enable_rps(struct drm_device *dev)
 	gt_perf_status = I915_READ(GEN6_GT_PERF_STATUS);
 
 	/* In units of 50MHz */
-	dev_priv->rps.hw_max = dev_priv->rps.max_delay = rp_state_cap & 0xff;
-	dev_priv->rps.min_delay = (rp_state_cap >> 16) & 0xff;
+	dev_priv->rps.hw_max = hw_max = rp_state_cap & 0xff;
+	hw_min = (rp_state_cap >> 16) & 0xff;
 	dev_priv->rps.rp1_delay = (rp_state_cap >>  8) & 0xff;
 	dev_priv->rps.rp0_delay = (rp_state_cap >>  0) & 0xff;
 	dev_priv->rps.rpe_delay = dev_priv->rps.rp1_delay;
 	dev_priv->rps.cur_delay = 0;
 
+	/* Preserve min/max settings in case of re-init */
+	if (dev_priv->rps.max_delay == 0)
+		dev_priv->rps.max_delay = hw_max;
+
+	if (dev_priv->rps.min_delay == 0)
+		dev_priv->rps.min_delay = hw_min;
+
 	/* disable the counters and set deterministic thresholds */
 	I915_WRITE(GEN6_RC_CONTROL, 0);
 
@@ -3586,7 +3593,7 @@ static void valleyview_enable_rps(struct drm_device *dev)
 {
 	struct drm_i915_private *dev_priv = dev->dev_private;
 	struct intel_ring_buffer *ring;
-	u32 gtfifodbg, val, rc6_mode = 0;
+	u32 gtfifodbg, val, hw_max, hw_min, rc6_mode = 0;
 	int i;
 
 	WARN_ON(!mutex_is_locked(&dev_priv->rps.hw_lock));
@@ -3648,21 +3655,27 @@ static void valleyview_enable_rps(struct drm_device *dev)
 			 vlv_gpu_freq(dev_priv, dev_priv->rps.cur_delay),
 			 dev_priv->rps.cur_delay);
 
-	dev_priv->rps.max_delay = valleyview_rps_max_freq(dev_priv);
-	dev_priv->rps.hw_max = dev_priv->rps.max_delay;
+	dev_priv->rps.hw_max = hw_max = valleyview_rps_max_freq(dev_priv);
 	DRM_DEBUG_DRIVER("max GPU freq: %d MHz (%u)\n",
-			 vlv_gpu_freq(dev_priv, dev_priv->rps.max_delay),
-			 dev_priv->rps.max_delay);
+			 vlv_gpu_freq(dev_priv, hw_max),
+			 hw_max);
 
 	dev_priv->rps.rpe_delay = valleyview_rps_rpe_freq(dev_priv);
 	DRM_DEBUG_DRIVER("RPe GPU freq: %d MHz (%u)\n",
 			 vlv_gpu_freq(dev_priv, dev_priv->rps.rpe_delay),
 			 dev_priv->rps.rpe_delay);
 
-	dev_priv->rps.min_delay = valleyview_rps_min_freq(dev_priv);
+	hw_min = valleyview_rps_min_freq(dev_priv);
 	DRM_DEBUG_DRIVER("min GPU freq: %d MHz (%u)\n",
-			 vlv_gpu_freq(dev_priv, dev_priv->rps.min_delay),
-			 dev_priv->rps.min_delay);
+			 vlv_gpu_freq(dev_priv, hw_min),
+			 hw_min);
+
+	/* Preserve min/max settings in case of re-init */
+	if (dev_priv->rps.max_delay == 0)
+		dev_priv->rps.max_delay = hw_max;
+
+	if (dev_priv->rps.min_delay == 0)
+		dev_priv->rps.min_delay = hw_min;
 
 	DRM_DEBUG_DRIVER("setting GPU freq to %d MHz (%u)\n",
 			 vlv_gpu_freq(dev_priv, dev_priv->rps.rpe_delay),