Commit e327f115 authored by Mikko Perttunen's avatar Mikko Perttunen Committed by Tejun Heo

ata: ahci_tegra: Read calibration fuse

The original version of the driver did not read the SATA calibration
fuse to remove the dependency to the fuse driver. The fuse driver
is now merged, so add this functionality.

The calibration fuse contains a 2-bit value used to pick a set
of calibration values for the SATA pad.
Signed-off-by: default avatarMikko Perttunen <mperttunen@nvidia.com>
Acked-by: default avatarThierry Reding <treding@nvidia.com>
Signed-off-by: default avatarTejun Heo <tj@kernel.org>
parent 2a13772a
...@@ -18,14 +18,17 @@ ...@@ -18,14 +18,17 @@
*/ */
#include <linux/ahci_platform.h> #include <linux/ahci_platform.h>
#include <linux/reset.h>
#include <linux/errno.h> #include <linux/errno.h>
#include <linux/kernel.h> #include <linux/kernel.h>
#include <linux/module.h> #include <linux/module.h>
#include <linux/of_device.h> #include <linux/of_device.h>
#include <linux/platform_device.h> #include <linux/platform_device.h>
#include <linux/regulator/consumer.h> #include <linux/regulator/consumer.h>
#include <linux/reset.h>
#include <soc/tegra/fuse.h>
#include <soc/tegra/pmc.h> #include <soc/tegra/pmc.h>
#include "ahci.h" #include "ahci.h"
#define SATA_CONFIGURATION_0 0x180 #define SATA_CONFIGURATION_0 0x180
...@@ -180,9 +183,12 @@ static int tegra_ahci_controller_init(struct ahci_host_priv *hpriv) ...@@ -180,9 +183,12 @@ static int tegra_ahci_controller_init(struct ahci_host_priv *hpriv)
/* Pad calibration */ /* Pad calibration */
/* FIXME Always use calibration 0. Change this to read the calibration ret = tegra_fuse_readl(FUSE_SATA_CALIB, &val);
* fuse once the fuse driver has landed. */ if (ret) {
val = 0; dev_err(&tegra->pdev->dev,
"failed to read calibration fuse: %d\n", ret);
return ret;
}
calib = tegra124_pad_calibration[val & FUSE_SATA_CALIB_MASK]; calib = tegra124_pad_calibration[val & FUSE_SATA_CALIB_MASK];
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment