Commit e3b32922 authored by Dan Murphy's avatar Dan Murphy Committed by Marc Kleine-Budde

dt-bindings: can: tcan4x5x: Update binding to use interrupt property

Remove the data-ready-gpio property in favor of the DT standard
interrupt-parent and interrupts.
Signed-off-by: default avatarDan Murphy <dmurphy@ti.com>
Signed-off-by: default avatarMarc Kleine-Budde <mkl@pengutronix.de>
parent ec44dd57
......@@ -10,8 +10,10 @@ Required properties:
- #size-cells: 0
- spi-max-frequency: Maximum frequency of the SPI bus the chip can
operate at should be less than or equal to 18 MHz.
- data-ready-gpios: Interrupt GPIO for data and error reporting.
- device-wake-gpios: Wake up GPIO to wake up the TCAN device.
- interrupt-parent: the phandle to the interrupt controller which provides
the interrupt.
- interrupts: interrupt specification for data-ready.
See Documentation/devicetree/bindings/net/can/m_can.txt for additional
required property details.
......@@ -30,7 +32,8 @@ tcan4x5x: tcan4x5x@0 {
#size-cells = <1>;
spi-max-frequency = <10000000>;
bosch,mram-cfg = <0x0 0 0 32 0 0 1 1>;
data-ready-gpios = <&gpio1 14 GPIO_ACTIVE_LOW>;
interrupt-parent = <&gpio1>;
interrupts = <14 GPIO_ACTIVE_LOW>;
device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>;
reset-gpios = <&gpio1 27 GPIO_ACTIVE_LOW>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment