Commit ec078d94 authored by Juuso Oikarinen's avatar Juuso Oikarinen Committed by John W. Linville

wl1271: Change rates configured for templates

Previously a "firmware chooses" value was used for the rates of all control
message templates set to the firmware. This resulted in a too high rate to be
chosen to transmit those messages. Change this by configuring a fixed low rate
for the templates.
Signed-off-by: default avatarJuuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: default avatarLuciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: default avatarLuciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent e0d8bbf0
......@@ -78,7 +78,8 @@ static struct conf_drv_settings default_conf = {
.tx = {
.tx_energy_detection = 0,
.rc_conf = {
.enabled_rates = CONF_TX_RATE_MASK_UNSPECIFIED,
.enabled_rates = CONF_HW_BIT_RATE_1MBPS |
CONF_HW_BIT_RATE_2MBPS,
.short_retry_limit = 10,
.long_retry_limit = 10,
.aflags = 0
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment