wl1271: Change rates configured for templates

Previously a "firmware chooses" value was used for the rates of all control
message templates set to the firmware. This resulted in a too high rate to be
chosen to transmit those messages. Change this by configuring a fixed low rate
for the templates.
Signed-off-by: Juuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/wl12xx/wl1271_main.c

@@ -78,7 +78,8 @@ static struct conf_drv_settings default_conf = {
 	.tx = {
 		.tx_energy_detection         = 0,
 		.rc_conf                     = {
-			.enabled_rates       = CONF_TX_RATE_MASK_UNSPECIFIED,
+			.enabled_rates       = CONF_HW_BIT_RATE_1MBPS |
+					       CONF_HW_BIT_RATE_2MBPS,
 			.short_retry_limit   = 10,
 			.long_retry_limit    = 10,
 			.aflags              = 0