Commit ec1f3774 authored by Peng Li's avatar Peng Li Committed by David S. Miller

net: hdlc_x25: move out assignment in if condition

Should not use assignment in if condition.
Signed-off-by: default avatarPeng Li <lipeng321@huawei.com>
Signed-off-by: default avatarGuangbin Huang <huangguangbin2@huawei.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 579ebffe
......@@ -137,13 +137,15 @@ static netdev_tx_t x25_xmit(struct sk_buff *skb, struct net_device *dev)
switch (skb->data[0]) {
case X25_IFACE_DATA: /* Data to be transmitted */
skb_pull(skb, 1);
if ((result = lapb_data_request(dev, skb)) != LAPB_OK)
result = lapb_data_request(dev, skb);
if (result != LAPB_OK)
dev_kfree_skb(skb);
spin_unlock_bh(&x25st->up_lock);
return NETDEV_TX_OK;
case X25_IFACE_CONNECT:
if ((result = lapb_connect_request(dev))!= LAPB_OK) {
result = lapb_connect_request(dev);
if (result != LAPB_OK) {
if (result == LAPB_CONNECTED)
/* Send connect confirm. msg to level 3 */
x25_connected(dev, 0);
......@@ -154,7 +156,8 @@ static netdev_tx_t x25_xmit(struct sk_buff *skb, struct net_device *dev)
break;
case X25_IFACE_DISCONNECT:
if ((result = lapb_disconnect_request(dev)) != LAPB_OK) {
result = lapb_disconnect_request(dev);
if (result != LAPB_OK) {
if (result == LAPB_NOTCONNECTED)
/* Send disconnect confirm. msg to level 3 */
x25_disconnected(dev, 0);
......@@ -237,7 +240,8 @@ static int x25_rx(struct sk_buff *skb)
hdlc_device *hdlc = dev_to_hdlc(dev);
struct x25_state *x25st = state(hdlc);
if ((skb = skb_share_check(skb, GFP_ATOMIC)) == NULL) {
skb = skb_share_check(skb, GFP_ATOMIC);
if (!skb) {
dev->stats.rx_dropped++;
return NET_RX_DROP;
}
......@@ -333,8 +337,9 @@ static int x25_ioctl(struct net_device *dev, struct ifreq *ifr)
if (result)
return result;
if ((result = attach_hdlc_protocol(dev, &proto,
sizeof(struct x25_state))))
result = attach_hdlc_protocol(dev, &proto,
sizeof(struct x25_state));
if (result)
return result;
memcpy(&state(hdlc)->settings, &new_settings, size);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment