omap3: Zoom2/3: Update hsmmc board config params

Update the hsmmc zoom peripheral configuration to support:
Power saving mode
mmc2 8-bit support
Configure mmc2 as non removable
Signed-off-by: Madhusudhan Chikkature <madhu.cr@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap2/board-zoom-peripherals.c

@@ -152,14 +152,20 @@ static struct regulator_init_data zoom_vsim = {
 
 static struct twl4030_hsmmc_info mmc[] __initdata = {
 	{
+		.name		= "external",
 		.mmc		= 1,
 		.wires		= 4,
 		.gpio_wp	= -EINVAL,
+		.power_saving	= true,
 	},
 	{
+		.name		= "internal",
 		.mmc		= 2,
-		.wires		= 4,
+		.wires		= 8,
+		.gpio_cd	= -EINVAL,
 		.gpio_wp	= -EINVAL,
+		.nonremovable	= true,
+		.power_saving	= true,
 	},
 	{}      /* Terminator */
 };
@@ -167,11 +173,8 @@ static struct twl4030_hsmmc_info mmc[] __initdata = {
 static int zoom_twl_gpio_setup(struct device *dev,
 		unsigned gpio, unsigned ngpio)
 {
-	/* gpio + 0 is "mmc0_cd" (input/IRQ),
-	 * gpio + 1 is "mmc1_cd" (input/IRQ)
-	 */
+	/* gpio + 0 is "mmc0_cd" (input/IRQ) */
 	mmc[0].gpio_cd = gpio + 0;
-	mmc[1].gpio_cd = gpio + 1;
 	twl4030_mmc_init(mmc);
 
 	/* link regulators to MMC adapters ... we "know" the