Commit ee2e6114 authored by Robert Jennings's avatar Robert Jennings Committed by David S. Miller

ibmveth: lost IRQ while closing/opening device leads to service loss

The order of freeing the IRQ and freeing the device in firmware
in ibmveth_close can cause the adapter to become unusable after a
subsequent ibmveth_open.  Only a reboot of the OS will make the
network device usable again. This is seen when cycling the adapter
up and down while there is network activity.

There is a window where an IRQ will be left unserviced (H_EOI will not
be called).  The solution is to make a VIO_IRQ_DISABLE h_call, free the
device with firmware, and then call free_irq.
Signed-off-by: default avatarRobert Jennings <rcj@linux.vnet.ibm.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 0f6142fa
......@@ -677,7 +677,7 @@ static int ibmveth_close(struct net_device *netdev)
if (!adapter->pool_config)
netif_stop_queue(netdev);
free_irq(netdev->irq, netdev);
h_vio_signal(adapter->vdev->unit_address, VIO_IRQ_DISABLE);
do {
lpar_rc = h_free_logical_lan(adapter->vdev->unit_address);
......@@ -689,6 +689,8 @@ static int ibmveth_close(struct net_device *netdev)
lpar_rc);
}
free_irq(netdev->irq, netdev);
adapter->rx_no_buffer = *(u64*)(((char*)adapter->buffer_list_addr) + 4096 - 8);
ibmveth_cleanup(adapter);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment