Commit eee44da0 authored by Kishon Vijay Abraham I's avatar Kishon Vijay Abraham I Committed by Felipe Balbi

usb: musb: omap2430: replace *_* with *-* in property names

No functional change. Replace *_* with *-* in property names of otg to
follow the general convention.
Signed-off-by: default avatarKishon Vijay Abraham I <kishon@ti.com>
Signed-off-by: default avatarFelipe Balbi <balbi@ti.com>
parent c3ec830d
......@@ -8,10 +8,10 @@ OMAP MUSB GLUE
and disconnect.
- multipoint : Should be "1" indicating the musb controller supports
multipoint. This is a MUSB configuration-specific setting.
- num_eps : Specifies the number of endpoints. This is also a
- num-eps : Specifies the number of endpoints. This is also a
MUSB configuration-specific setting. Should be set to "16"
- ram_bits : Specifies the ram address size. Should be set to "12"
- interface_type : This is a board specific setting to describe the type of
- ram-bits : Specifies the ram address size. Should be set to "12"
- interface-type : This is a board specific setting to describe the type of
interface between the controller and the phy. It should be "0" or "1"
specifying ULPI and UTMI respectively.
- mode : Should be "3" to represent OTG. "1" signifies HOST and "2"
......@@ -29,14 +29,14 @@ usb_otg_hs: usb_otg_hs@4a0ab000 {
ti,hwmods = "usb_otg_hs";
ti,has-mailbox;
multipoint = <1>;
num_eps = <16>;
ram_bits = <12>;
num-eps = <16>;
ram-bits = <12>;
ctrl-module = <&omap_control_usb>;
};
Board specific device node entry
&usb_otg_hs {
interface_type = <1>;
interface-type = <1>;
mode = <3>;
power = <50>;
};
......
......@@ -526,10 +526,10 @@ static int omap2430_probe(struct platform_device *pdev)
}
of_property_read_u32(np, "mode", (u32 *)&pdata->mode);
of_property_read_u32(np, "interface_type",
of_property_read_u32(np, "interface-type",
(u32 *)&data->interface_type);
of_property_read_u32(np, "num_eps", (u32 *)&config->num_eps);
of_property_read_u32(np, "ram_bits", (u32 *)&config->ram_bits);
of_property_read_u32(np, "num-eps", (u32 *)&config->num_eps);
of_property_read_u32(np, "ram-bits", (u32 *)&config->ram_bits);
of_property_read_u32(np, "power", (u32 *)&pdata->power);
config->multipoint = of_property_read_bool(np, "multipoint");
pdata->has_mailbox = of_property_read_bool(np,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment