net: axienet: Move reset before 64-bit DMA detection

64-bit DMA detection will fail if axienet was started before (by boot
loader, boot ROM, etc). In this state axienet will not start properly.
XAXIDMA_TX_CDESC_OFFSET + 4 register (MM2S_CURDESC_MSB) is used to detect
64-bit DMA capability here. But datasheet says: When DMACR.RS is 1
(axienet is in enabled state), CURDESC_PTR becomes Read Only (RO) and
is used to fetch the first descriptor. So iowrite32()/ioread32() trick
to this register to detect 64-bit DMA will not work.
So move axienet reset before 64-bit DMA detection.

Fixes: f735c40e ("net: axienet: Autodetect 64-bit DMA capability")
Signed-off-by: Maxim Kochetkov <fido_max@inbox.ru>
Reviewed-by: Robert Hancock <robert.hancock@calian.com>
Reviewed-by: Radhey Shyam Pandey <radhey.shyam.pandey@amd.com>
Link: https://lore.kernel.org/r/20230622192245.116864-1-fido_max@inbox.ruSigned-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/xilinx/xilinx_axienet_main.c

@@ -2042,6 +2042,11 @@ static int axienet_probe(struct platform_device *pdev)
 		goto cleanup_clk;
 	}
 
+	/* Reset core now that clocks are enabled, prior to accessing MDIO */
+	ret = __axienet_device_reset(lp);
+	if (ret)
+		goto cleanup_clk;
+
 	/* Autodetect the need for 64-bit DMA pointers.
 	 * When the IP is configured for a bus width bigger than 32 bits,
 	 * writing the MSB registers is mandatory, even if they are all 0.
@@ -2096,11 +2101,6 @@ static int axienet_probe(struct platform_device *pdev)
 	lp->coalesce_count_tx = XAXIDMA_DFT_TX_THRESHOLD;
 	lp->coalesce_usec_tx = XAXIDMA_DFT_TX_USEC;
 
-	/* Reset core now that clocks are enabled, prior to accessing MDIO */
-	ret = __axienet_device_reset(lp);
-	if (ret)
-		goto cleanup_clk;
-
 	ret = axienet_mdio_setup(lp);
 	if (ret)
 		dev_warn(&pdev->dev,