net: phy: marvell-88q2xxx: move interrupt configuration

Move interrupt configuration from mv88q222x_revb0_config_init to
mv88q2xxx_config_init. Same register and bits are used for the 88q2xxx
devices.
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Stefan Eichenberger <eichest@gmail.com>
Signed-off-by: Dimitri Fedrau <dima.fedrau@gmail.com>
Link: https://lore.kernel.org/r/20240218075753.18067-15-dima.fedrau@gmail.comSigned-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/phy/marvell-88q2xxx.c

@@ -376,6 +376,14 @@ static int mv88q2xxx_config_init(struct phy_device *phydev)
 	 */
 	phydev->pma_extable = MDIO_PMA_EXTABLE_BT1;
 
+	/* Configure interrupt with default settings, output is driven low for
+	 * active interrupt and high for inactive.
+	 */
+	if (phy_interrupt_is_valid(phydev))
+		return phy_set_bits_mmd(phydev, MDIO_MMD_PCS,
+					MDIO_MMD_PCS_MV_GPIO_INT_CTRL,
+					MDIO_MMD_PCS_MV_GPIO_INT_CTRL_TRI_DIS);
+
 	return 0;
 }
 
@@ -701,14 +709,6 @@ static int mv88q222x_revb0_config_init(struct phy_device *phydev)
 			return ret;
 	}
 
-	/* Configure interrupt with default settings, output is driven low for
-	 * active interrupt and high for inactive.
-	 */
-	if (phy_interrupt_is_valid(phydev))
-		return phy_set_bits_mmd(phydev, MDIO_MMD_PCS,
-					MDIO_MMD_PCS_MV_GPIO_INT_CTRL,
-					MDIO_MMD_PCS_MV_GPIO_INT_CTRL_TRI_DIS);
-
 	return mv88q2xxx_config_init(phydev);
 }