ethoc: Write bus addresses to registers

The ethoc driver should be writing bus addresses to the ethoc registers, not
virtual addresses.  This patch adds an array to store the virtual addresses
in and references that array when manipulating the contents of the buffer
descriptors.
Signed-off-by: Jonas Bonn <jonas@southpole.se>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethoc.c

@@ -180,6 +180,7 @@ MODULE_PARM_DESC(buffer_size, "DMA buffer allocation size");
  * @dty_tx:	last buffer actually sent
  * @num_rx:	number of receive buffers
  * @cur_rx:	current receive buffer
+ * @vma:        pointer to array of virtual memory addresses for buffers
  * @netdev:	pointer to network device structure
  * @napi:	NAPI structure
  * @stats:	network device statistics
@@ -203,6 +204,8 @@ struct ethoc {
 	unsigned int num_rx;
 	unsigned int cur_rx;
 
+	void** vma;
+
 	struct net_device *netdev;
 	struct napi_struct napi;
 	struct net_device_stats stats;
@@ -285,18 +288,20 @@ static inline void ethoc_disable_rx_and_tx(struct ethoc *dev)
 	ethoc_write(dev, MODER, mode);
 }
 
-static int ethoc_init_ring(struct ethoc *dev)
+static int ethoc_init_ring(struct ethoc *dev, void* mem_start)
 {
 	struct ethoc_bd bd;
 	int i;
+	void* vma;
 
 	dev->cur_tx = 0;
 	dev->dty_tx = 0;
 	dev->cur_rx = 0;
 
 	/* setup transmission buffers */
-	bd.addr = virt_to_phys(dev->membase);
+	bd.addr = mem_start;
 	bd.stat = TX_BD_IRQ | TX_BD_CRC;
+	vma = dev->membase;
 
 	for (i = 0; i < dev->num_tx; i++) {
 		if (i == dev->num_tx - 1)
@@ -304,6 +309,9 @@ static int ethoc_init_ring(struct ethoc *dev)
 
 		ethoc_write_bd(dev, i, &bd);
 		bd.addr += ETHOC_BUFSIZ;
+
+		dev->vma[i] = vma;
+		vma += ETHOC_BUFSIZ;
 	}
 
 	bd.stat = RX_BD_EMPTY | RX_BD_IRQ;
@@ -314,6 +322,9 @@ static int ethoc_init_ring(struct ethoc *dev)
 
 		ethoc_write_bd(dev, dev->num_tx + i, &bd);
 		bd.addr += ETHOC_BUFSIZ;
+
+		dev->vma[dev->num_tx + i] = vma;
+		vma += ETHOC_BUFSIZ;
 	}
 
 	return 0;
@@ -415,7 +426,7 @@ static int ethoc_rx(struct net_device *dev, int limit)
 			skb = netdev_alloc_skb_ip_align(dev, size);
 
 			if (likely(skb)) {
-				void *src = phys_to_virt(bd.addr);
+				void *src = priv->vma[entry];
 				memcpy_fromio(skb_put(skb, size), src, size);
 				skb->protocol = eth_type_trans(skb, dev);
 				priv->stats.rx_packets++;
@@ -667,7 +678,7 @@ static int ethoc_open(struct net_device *dev)
 
 	ethoc_write(priv, TX_BD_NUM, priv->num_tx);
 
-	ethoc_init_ring(priv);
+	ethoc_init_ring(priv, (void*)dev->mem_start);
 	ethoc_reset(priv);
 
 	if (netif_queue_stopped(dev)) {
@@ -831,7 +842,7 @@ static netdev_tx_t ethoc_start_xmit(struct sk_buff *skb, struct net_device *dev)
 	else
 		bd.stat &= ~TX_BD_PAD;
 
-	dest = phys_to_virt(bd.addr);
+	dest = priv->vma[entry];
 	memcpy_toio(dest, skb->data, skb->len);
 
 	bd.stat &= ~(TX_BD_STATS | TX_BD_LEN_MASK);
@@ -978,6 +989,12 @@ static int ethoc_probe(struct platform_device *pdev)
 	priv->num_tx = max(2, num_bd / 4);
 	priv->num_rx = num_bd - priv->num_tx;
 
+	priv->vma = devm_kzalloc(&pdev->dev, num_bd*sizeof(void*), GFP_KERNEL);
+	if (!priv->vma) {
+		ret = -ENOMEM;
+		goto error;
+	}
+
 	/* Allow the platform setup code to pass in a MAC address. */
 	if (pdev->dev.platform_data) {
 		struct ethoc_platform_data *pdata =