Input: xpad - add constants for GIP interface numbers

Wired GIP devices present multiple interfaces with the same USB identification
other than the interface number. This adds constants for differentiating two of
them and uses them where appropriate
Signed-off-by: Vicki Pfau <vi@endrift.com>
Link: https://lore.kernel.org/r/20230411031650.960322-2-vi@endrift.comSigned-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

drivers/input/joystick/xpad.c

@@ -561,6 +561,9 @@ struct xboxone_init_packet {
 #define GIP_MOTOR_LT BIT(3)
 #define GIP_MOTOR_ALL (GIP_MOTOR_R | GIP_MOTOR_L | GIP_MOTOR_RT | GIP_MOTOR_LT)
 
+#define GIP_WIRED_INTF_DATA 0
+#define GIP_WIRED_INTF_AUDIO 1
+
 /*
  * This packet is required for all Xbox One pads with 2015
  * or later firmware installed (or present from the factory).
@@ -2004,7 +2007,7 @@ static int xpad_probe(struct usb_interface *intf, const struct usb_device_id *id
 	}
 
 	if (xpad->xtype == XTYPE_XBOXONE &&
-	    intf->cur_altsetting->desc.bInterfaceNumber != 0) {
+	    intf->cur_altsetting->desc.bInterfaceNumber != GIP_WIRED_INTF_DATA) {
 		/*
 		 * The Xbox One controller lists three interfaces all with the
 		 * same interface class, subclass and protocol. Differentiate by