pinctrl: sunxi: Add I/O bias setting for H6 R-PIO

H6 requires I/O bias configuration on both of its PIO devices.
Previously it was only done for the main PIO.

The setting for Port L is at bit 0, so the bank calculation needs to
account for the pin base. Otherwise the wrong bit is used.

Fixes: cc62383f ("pinctrl: sunxi: Support I/O bias voltage setting on H6")
Reviewed-by: Jernej Skrabec <jernej.skrabec@gmail.com>
Tested-by: Heiko Stuebner <heiko@sntech.de>
Signed-off-by: Samuel Holland <samuel@sholland.org>
Link: https://lore.kernel.org/r/20220713025233.27248-3-samuel@sholland.orgSigned-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/sunxi/pinctrl-sun50i-h6-r.c

@@ -106,6 +106,7 @@ static const struct sunxi_pinctrl_desc sun50i_h6_r_pinctrl_data = {
 	.npins = ARRAY_SIZE(sun50i_h6_r_pins),
 	.pin_base = PL_BASE,
 	.irq_banks = 2,
+	.io_bias_cfg_variant = BIAS_VOLTAGE_PIO_POW_MODE_SEL,
 };
 
 static int sun50i_h6_r_pinctrl_probe(struct platform_device *pdev)

drivers/pinctrl/sunxi/pinctrl-sunxi.c

@@ -622,7 +622,7 @@ static int sunxi_pinctrl_set_io_bias_cfg(struct sunxi_pinctrl *pctl,
 					 unsigned pin,
 					 struct regulator *supply)
 {
-	unsigned short bank = pin / PINS_PER_BANK;
+	unsigned short bank;
 	unsigned long flags;
 	u32 val, reg;
 	int uV;
@@ -638,6 +638,9 @@ static int sunxi_pinctrl_set_io_bias_cfg(struct sunxi_pinctrl *pctl,
 	if (uV == 0)
 		return 0;
 
+	pin -= pctl->desc->pin_base;
+	bank = pin / PINS_PER_BANK;
+
 	switch (pctl->desc->io_bias_cfg_variant) {
 	case BIAS_VOLTAGE_GRP_CONFIG:
 		/*
@@ -655,8 +658,6 @@ static int sunxi_pinctrl_set_io_bias_cfg(struct sunxi_pinctrl *pctl,
 		else
 			val = 0xD; /* 3.3V */
 
-		pin -= pctl->desc->pin_base;
-
 		reg = readl(pctl->membase + sunxi_grp_config_reg(pin));
 		reg &= ~IO_BIAS_MASK;
 		writel(reg | val, pctl->membase + sunxi_grp_config_reg(pin));