wifi: wilc1000: use correct sequence of RESET for chip Power-UP/Down

For power-up sequence, WILC expects RESET set to high 5ms after making
chip_en(enable) so corrected chip power-up sequence by making RESET high.
For Power-Down sequence, the correct sequence make RESET and CHIP_EN low
without any extra delay.

Fixes: ec031ac4 ("wilc1000: Add reset/enable GPIO support to SPI driver")
Signed-off-by: Ajay Singh <ajay.kathat@microchip.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220524120606.9675-1-ajay.kathat@microchip.com

drivers/net/wireless/microchip/wilc1000/spi.c

@@ -191,11 +191,11 @@ static void wilc_wlan_power(struct wilc *wilc, bool on)
 		/* assert ENABLE: */
 		gpiod_set_value(gpios->enable, 1);
 		mdelay(5);
-		/* deassert RESET: */
-		gpiod_set_value(gpios->reset, 0);
-	} else {
 		/* assert RESET: */
 		gpiod_set_value(gpios->reset, 1);
+	} else {
+		/* deassert RESET: */
+		gpiod_set_value(gpios->reset, 0);
 		/* deassert ENABLE: */
 		gpiod_set_value(gpios->enable, 0);
 	}