qcom: ipq4019: add crypto nodes to ipq4019 SoC and DK01 device tree

This adds the crypto nodes to the ipq4019 device tree, it also adds the
BAM node used by crypto as well which the driver currently requires to
operate properly

The crypto driver itself depends on some other patches to qcom_bam_dma
to function properly:

https://lkml.org/lkml/2015/12/1/113

CC: Stanimir Varbanov <svarbanov@mm-sol.com>
Signed-off-by: Matthew McClintock <mmcclint@codeaurora.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1.dtsi

@@ -93,6 +93,14 @@ serial@78af000 {
 			status = "ok";
 		};
 
+		cryptobam: dma@8e04000 {
+			status = "ok";
+		};
+
+		crypto@8e3a000 {
+			status = "ok";
+		};
+
 		watchdog@b017000 {
 			status = "ok";
 		};

arch/arm/boot/dts/qcom-ipq4019.dtsi

@@ -147,6 +147,31 @@ i2c_0: i2c@78b7000 {
 			status = "disabled";
 		};
 
+
+		cryptobam: dma@8e04000 {
+			compatible = "qcom,bam-v1.7.0";
+			reg = <0x08e04000 0x20000>;
+			interrupts = <GIC_SPI 207 0>;
+			clocks = <&gcc GCC_CRYPTO_AHB_CLK>;
+			clock-names = "bam_clk";
+			#dma-cells = <1>;
+			qcom,ee = <1>;
+			qcom,controlled-remotely;
+			status = "disabled";
+		};
+
+		crypto@8e3a000 {
+			compatible = "qcom,crypto-v5.1";
+			reg = <0x08e3a000 0x6000>;
+			clocks = <&gcc GCC_CRYPTO_AHB_CLK>,
+				 <&gcc GCC_CRYPTO_AXI_CLK>,
+				 <&gcc GCC_CRYPTO_CLK>;
+			clock-names = "iface", "bus", "core";
+			dmas = <&cryptobam 2>, <&cryptobam 3>;
+			dma-names = "rx", "tx";
+			status = "disabled";
+		};
+
                 acc0: clock-controller@b088000 {
                         compatible = "qcom,kpss-acc-v1";
                         reg = <0x0b088000 0x1000>, <0xb008000 0x1000>;