media: rcar-csi2: Move setting of Field Detection Control Register

Later datasheet versions (rev 1.00) clarifies that the FLD register
should be set after LINKCNT.
Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Reviewed-by: Ulrich Hecht <uli+renesas@fpond.eu>
Reviewed-by: Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@kernel.org>

drivers/media/platform/rcar-vin/rcar-csi2.c

@@ -519,8 +519,6 @@ static int rcsi2_start_receiver(struct rcar_csi2 *priv)
 	rcsi2_write(priv, PHTC_REG, 0);
 
 	/* Configure */
-	rcsi2_write(priv, FLD_REG, FLD_FLD_NUM(2) | FLD_FLD_EN4 |
-		    FLD_FLD_EN3 | FLD_FLD_EN2 | FLD_FLD_EN);
 	rcsi2_write(priv, VCDT_REG, vcdt);
 	if (vcdt2)
 		rcsi2_write(priv, VCDT2_REG, vcdt2);
@@ -551,6 +549,8 @@ static int rcsi2_start_receiver(struct rcar_csi2 *priv)
 	rcsi2_write(priv, PHYCNT_REG, phycnt);
 	rcsi2_write(priv, LINKCNT_REG, LINKCNT_MONITOR_EN |
 		    LINKCNT_REG_MONI_PACT_EN | LINKCNT_ICLK_NONSTOP);
+	rcsi2_write(priv, FLD_REG, FLD_FLD_NUM(2) | FLD_FLD_EN4 |
+		    FLD_FLD_EN3 | FLD_FLD_EN2 | FLD_FLD_EN);
 	rcsi2_write(priv, PHYCNT_REG, phycnt | PHYCNT_SHUTDOWNZ);
 	rcsi2_write(priv, PHYCNT_REG, phycnt | PHYCNT_SHUTDOWNZ | PHYCNT_RSTZ);