Commit fe808f3c authored by Hans Verkuil's avatar Hans Verkuil Committed by Mauro Carvalho Chehab

[media] adv7842: set LLC DLL phase from platform_data

The correct LLC DLL phase depends on the board layout, so this
should be part of the platform_data.

Also updated the platform_data in ezkit to ensure that what was the old
default value is now explicitly specified, so the behavior for that board
is unchanged.
Tested-by: default avatarMartin Bugge <marbugge@cisco.com>
Signed-off-by: default avatarHans Verkuil <hans.verkuil@cisco.com>
Cc: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: default avatarMauro Carvalho Chehab <m.chehab@samsung.com>
parent 834a8be1
......@@ -1027,6 +1027,7 @@ static struct adv7842_platform_data adv7842_data = {
.vid_std_select = ADV7842_SDP_VID_STD_CVBS_SD_4x1,
.hdmi_free_run_enable = 1,
.sdp_free_run_auto = 1,
.llc_dll_phase = 0x10,
.i2c_sdp_io = 0x40,
.i2c_sdp = 0x41,
.i2c_cp = 0x42,
......
......@@ -1593,9 +1593,6 @@ static void select_input(struct v4l2_subdev *sd,
afe_write(sd, 0x00, 0x00); /* power up ADC */
afe_write(sd, 0xc8, 0x00); /* phase control */
io_write(sd, 0x19, 0x83); /* LLC DLL phase */
io_write(sd, 0x33, 0x40); /* LLC DLL enable */
io_write(sd, 0xdd, 0x90); /* Manual 2x output clock */
/* script says register 0xde, which don't exist in manual */
......@@ -2609,8 +2606,7 @@ static int adv7842_core_init(struct v4l2_subdev *sd)
io_write_and_or(sd, 0x20, 0xcf, 0x00);
/* LLC */
/* Set phase to 16. TODO: get this from platform_data */
io_write(sd, 0x19, 0x90);
io_write(sd, 0x19, 0x80 | pdata->llc_dll_phase);
io_write(sd, 0x33, 0x40);
/* interrupts */
......
......@@ -192,6 +192,12 @@ struct adv7842_platform_data {
unsigned sync:2;
} drive_strength;
/*
* IO register 0x19: Adjustment to the LLC DLL phase in
* increments of 1/32 of a clock period.
*/
unsigned llc_dll_phase:5;
/* External RAM for 3-D comb or frame synchronizer */
unsigned sd_ram_size; /* ram size in MB */
unsigned sd_ram_ddr:1; /* ddr or sdr sdram */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment