The softdog watchdog timer has a bug that can create an oops:

1.  Load the module without the nowayout option.
2.  Open the driver and close it without writing 'V' before close.
3.  Unload the module.  The timer will continue to run...
4.  Oops happens when timer fires.

Reported Sun, 10 Oct 2004, by Michael Schierl <schierlm@gmx.de>

Fix is easy: always take a reference on the module on open.
Release it only when the device is closed and no timer is running.
Tested on 2.6.13-rc6 using the soft_noboot option.  While the
timer is running and the device is closed, the module use count
stays at 1.  After the timer fires, it drops to 0.  Repeatedly
opening and closing the driver caused no problems.  Please apply.
Signed-off-by: Chuck Ebbert <76306.1226@compuserve.com>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

Attached is a small update to the w83627hf watchdog driver
to initialise appropriately if it was already initialised
in the BIOS. On tyan motherboards for e.g. you can init
the watchdog to 4 mins, then when the driver is loaded it
sets the watchdog to "seconds" mode, and then machine will
reboot within 4 seconds. So this patch resets the timeout
to the configured value if the watchdog is already running.
Signed-off-by: P@draig Brady <P@draigBrady.com>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

Patch from Dimitry Andric <dimitry.andric@tomtom.com>

Change to using platfrom driver's .shutdown method instead
of an reboot notifier
Signed-off-by: Dimitry Andric <dimitry.andric@tomtom.com>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

Patch from Dimitry Andric <dimitry.andric@tomtom.com>, updated
by Ben Dooks <ben-linux@fluff.org>. Patch is against 2.6.11-mm2

Add power management support to the s3c2410 watchdog, so that
it is shut-down over suspend, and re-initialised on resume.

Also add Dimitry to the list of authors.
Signed-off-by: Dimitry Andric <dimitry.andric@tomtom.com>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

While looking for possible candidates for our udev.rules package,
I found a few odd ->name properties. /dev/watchdog has minor 130
according to devices.txt. Since all watchdog drivers use the
misc_register() call, they will end up in /sys/class/misc/$foo.
udev may create the /dev/watchdog node if the driver is loaded.
I dont have such a device, so I cant test it.
The drivers below provide names with spaces and even with / in it.
Not a big deal, but apps may expect /dev/watchdog.
Signed-off-by: Olaf Hering <olh@suse.de>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

Clean the Kconfig+Makefile according to a sorted list
of the drivers of each architecture (and sub-architecture).
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

Re-arrange Makefile according to what we want to probe first.
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>

Merge refs/heads/ieee80211-wifi from master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/netdev-2.6 

This patch is against 2.6.10, but still applies cleanly. It's just
s/driverfs/sysfs/ in this file.
Signed-off-by: Rolf Eike Beer <eike-kernel@sf-tec.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch is against 2.6.10, but still applies cleanly. It's just
s/driverfs/sysfs/ in these two files.
Signed-off-by: Rolf Eike Beer <eike-kernel@sf-tec.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Miles Bader <miles@gnu.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Miles Bader <miles@gnu.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Miles Bader <miles@gnu.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Use MAP_PRIVATE when calling mmap to get memory for the code region.
The flat loader was using MAP_SHARED, but underlying changes to the
MMUless mmap means this is now wrong.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Updated defconfig for m68knommu arch.
Patch originaly submitted by Jan Dittmer <jdittmer@ppp0.net>
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

. add support for the M5235EVB board
. add support for the SOM5282 board
. add support for the MOD5272 board
. fix end of memory define for eLITE board
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Need pfn_valid macro, even on MMUless platforms.
Enclose the macro args of __pa and __va in parentheses.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Use the THREAD_SIZE define when manipulating the stack instead of
hard coded values (for the 68328 and 68360 sub-architectures).
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

New architecture and board configuration support for m68knommu.

. add 523x ColdFire support
. add support for SOM5282 and MOD5272 boards
. break up the 527x to be separate 5271 and 5275. There is some
  subtle differences that (like RAM config) that need to be dealt with
. add option to support selecting 4k kernel stack
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add support for the 523x ColdFire family of processors
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Make show_stack() consistent with other architectures.
Put the vector string names in the .rodata section.
Patch originally submitted by Philippe De Muyter <phdm@macqel.be>.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Modify maintainers for uClinux (MMUless). Neither Dave nor Jeff
manitain the 2.6 code in mainline, so no point emailing them about
problems.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Correctly determine the end of ram for ram setups that do not
start at base address of 0. Add support for the MOD5272 board,
which doesn not have a ram base of 0.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

. setup for the new 523x ColdFire family
. break up of 527x to be 5271 and 5275
. some white space cleanup
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Low level initialization code for the 523x ColdFire processor family.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Merge refs/heads/ieee80211-wifi from master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/netdev-2.6 

We weren't explicitly setting the page table bits we desired
in user_prot in the protection table, which resulted in the
user mappings for v6 CPUs being marked global.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

We run into problems if we blindly enable L2 prefetching without
checking that the L2 cache is actually enabled.  Additionaly, if we
disable the L2 cache we need to ensure that we disable L2 prefetching.
Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This fixes a problem with pci_map_rom() which doesn't properly
update the ROM BAR value with the address thas allocated for it by the
PCI code. This problem, among other, breaks boot on Mac laptops.

It'ss a new version based on Linus latest one with better error
checking.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

In adjusting the logic for SLB miss for the dynamic hugepage stuff, I
messed up the !CONFIG_HUGETLB_PAGE case, failing to set the SLB flags
properly.

This fixes it.  It also streamlines the logic for the HUGETLB_PAGE case
(removing a couple of branches) while we're at it.

Booted, and roughly tested on POWER5 (with and without HUGETLB_PAGE),
iSeries/RS64 (no hugepage available), and G5 (with and without
HUGETLB_PAGE).
Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This fixes the following compile error:

	...
	  LD      .tmp_vmlinux1
	drivers/built-in.o: In function `frontend_init':
	budget-av.c:(.text+0xb9448): undefined reference to `tda10046_attach'
	budget-av.c:(.text+0xb9518): undefined reference to `tda10021_attach'
	drivers/built-in.o: In function `philips_tu1216_request_firmware':
	budget-av.c:(.text+0xb937b): undefined reference to `request_firmware'
	make: *** [.tmp_vmlinux1] Error 1
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Acked-by: Johannes Stezenbach <js@linuxtv.org>
Acked-by: Michael Krufky <mkrufky@linuxtv.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>