- 05 Feb, 2021 18 commits
-
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
Alexandre Belloni <alexandre.belloni@bootlin.com> Link: https://lore.kernel.org/r/20210202112219.3610853-10-alexandre.belloni@bootlin.com
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
Baruch Siach <baruch@tkos.co.il> Link: https://lore.kernel.org/r/20210202112219.3610853-6-alexandre.belloni@bootlin.com
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
Florian Fainelli <f.fainelli@gmail.com> Link: https://lore.kernel.org/r/20210202112219.3610853-5-alexandre.belloni@bootlin.com
-
Alexandre Belloni authored
When CONFIG_OF is disabled then the matching table is not referenced. Signed-off-by:
-
Alexandre Belloni authored
The driver will compile with warning without OF because armada38x_data and armada8k_data will be defined but not used. It would be possible to move then in the #ifdef CONFIG_OF section but then their members will be defined but not used. Instead of moving most of the driver in the #ifdef, simply depend on OF. Signed-off-by:
-
Alexandre Belloni authored
rtc_device_unregister is gone since commit fdcfd854 ("rtc: rework rtc_register_device() resource management"). Remove its documentation. Signed-off-by:
-
Alexandre Belloni authored
The NXP pcf2127 supports reset-source. Signed-off-by:
-
Alexandre Belloni authored
Remove voltage low messages as userspace has a proper way to get the information and react on it. Signed-off-by:
-
Alexandre Belloni authored
The PORF bit is cleared on interrupts which prevents the driver to know when the time and date are invalid. Stop clearing PORF in the interrupt handler. Signed-off-by:
-
Xiaofei Tan authored
It is redundant to do irqsave and irqrestore in hardIRQ context, where it has been in a irq-disabled context. Signed-off-by:
Xiaofei Tan <tanxiaofei@huawei.com> Signed-off-by:
-
Xiaofei Tan authored
It is redundant to do irqsave and irqrestore in hardIRQ context, where it has been in a irq-disabled context. Signed-off-by:
-
Xiaofei Tan authored
It is redundant to do irqsave and irqrestore in hardIRQ context, where it has been in a irq-disabled context. Signed-off-by:
-
Xiaofei Tan authored
It is redundant to do irqsave and irqrestore in hardIRQ context, where it has been in a irq-disabled context. Signed-off-by:
-
Xiaofei Tan authored
It is redundant to do irqsave and irqrestore in hardIRQ context, where it has been in a irq-disabled context. Signed-off-by:
-
Xiaofei Tan authored
It is redundant to do irqsave and irqrestore in hardIRQ context, where it has been in a irq-disabled context. Signed-off-by:
-
- 02 Feb, 2021 1 commit
-
-
David Gow authored
The Xilinx zynqmp RTC driver makes use of IOMEM functions like devm_platform_ioremap_resource(), which are only available if CONFIG_HAS_IOMEM is defined. This causes the driver not to be enable under make ARCH=um allyesconfig, even though it won't build. By adding a dependency on HAS_IOMEM, the driver will not be enabled on architectures which don't support it. Fixes: 09ef18bc ("rtc: use devm_platform_ioremap_resource() to simplify code") Signed-off-by:
David Gow <davidgow@google.com> Signed-off-by:
-
- 25 Jan, 2021 17 commits
-
-
Philipp Rosenberger authored
The datasheet of the PCF2127 states, it is recommended to process an OTP refresh once the power is up and the oscillator is operating stable. The OTP refresh takes less than 100 ms to complete. Signed-off-by:
Philipp Rosenberger <p.rosenberger@kunbus.com> Signed-off-by:
-
Philipp Rosenberger authored
To resume normal operation after a total power loss (no or empty battery) the "Power-On Reset Override (PORO)" facility needs to be disabled. The register reset value sets the PORO enabled and the data sheet recommends setting it to disabled for normal operation. From what I've seen on the PCF2127 and PCF2129 there is no event generated at the interrupt pin (INT), as long the PORO bit is set. This behavior is not documented in the manual. Signed-off-by:
-
Dmitry Osipenko authored
TPS65910 is a PMIC MFD device and RTC is one of its functions. The wakeup-source DT property is specified for the parent MFD device and we need to use this property for the RTC in order to allow to use RTC alarm for waking up system from suspend by default, instead of requiring user to enable wakeup manually via sysfs. Tested-by:
Peter Geis <pgwipeout@gmail.com> Tested-by:
Matt Merhar <mattmerhar@protonmail.com> Signed-off-by:
Dmitry Osipenko <digetx@gmail.com> Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
Joshua Kinard <kumba@gentoo.org> Link: https://lore.kernel.org/r/20210119220653.677750-5-alexandre.belloni@bootlin.com
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
Alexandre Belloni authored
Avoid accessing directly rtc->ops_lock and use the RTC core helpers. Signed-off-by:
-
- 23 Jan, 2021 3 commits
-
-
Arnd Bergmann authored
The ST-Ericsson U300 platform is getting removed, so this driver is no longer needed. Cc: Linus Walleij <linus.walleij@linaro.org> Signed-off-by:
Arnd Bergmann <arnd@arndb.de> Reviewed-by:
Linus Walleij <linus.walleij@linaro.org> Signed-off-by:
-
Arnd Bergmann authored
The ST-Ericsson U300 platform is getting removed, so this driver is no longer needed. Cc: Linus Walleij <linus.walleij@linaro.org> Signed-off-by:
-
Arnd Bergmann authored
The CSR SiRF prima2/atlas platforms are getting removed, so this driver is no longer needed. Cc: Barry Song <baohua@kernel.org> Signed-off-by:
Barry Song <baohua@kernel.org> Signed-off-by:
-
- 16 Jan, 2021 1 commit
-
-
Alexandre Belloni authored
Clear RTC_FEATURE_ALARM to signal that alarms are not available instead of having a supplementary struct rtc_class_ops without alarm callbacks. Signed-off-by:
-
