- 26 Jul, 2010 30 commits
-
-
Eric Bénard authored
i.MX25's EHCI is the same as i.MX35's one. Signed-off-by:
Eric Bénard <eric@eukrea.com> Signed-off-by:
Sascha Hauer <s.hauer@pengutronix.de>
-
Eric Bénard authored
usb drivers need to get the right value for otg clock so calculate and return it Signed-off-by:
-
Eric Bénard authored
i.MX25's OTG has the same USBCTRL registers than i.MX35 so reuse most of the i.MX35's defines. Signed-off-by:
-
Eric Bénard authored
the standard place for this define is include/mach/mx25.h Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
when CONFIG_USB_ULPI is not defined we actually get : warning: 'otg_pdata' defined but not used warning: 'usbh2_pdata' defined but not used Signed-off-by:
-
Eric Bénard authored
without this patch, ipu_clk's value is 0 thus preventing mx3fb from calculating the right divisor for pixel clock generator. Signed-off-by:
-
Dinh Nguyen authored
Add device registration and setup IOMUX pins in the mx51_babbage board feil. Signed-off-by:
Dinh Nguyen <Dinh.Nguyen@freescale.com> Signed-off-by:
-
Dinh Nguyen authored
This patch adds I2C functionality to the Freescale MX51 Babbage HW. The patch adds device structures, i2c board slave device defines, IOMUX pin defines, and clocks. Signed-off-by:
-
Amit Kucheria authored
This patch fixes the clock refcounting when reparenting is used. Boot-tested on imx51 babbage board. Sascha pointed out a good explanation of refcounting here: http://www.spinics.net/lists/arm-kernel/msg85879.htmlSigned-off-by:
Amit Kucheria <amit.kucheria@canonical.com> Signed-off-by:
-
Baruch Siach authored
The keymap is taken from the Freescale supplied kernel. Signed-off-by:
Baruch Siach <baruch@tkos.co.il> Signed-off-by:
-
Baruch Siach authored
Signed-off-by:
-
Baruch Siach authored
Signed-off-by:
-
Sascha Hauer authored
The OOB handling in the mxc_nand driver is broken for v1 type controllers (i.MX27/31) with 512 byte page size. This perhaps did not show up because ubi does not use OOB. Update the driver to always read/write a whole page even if only OOB is requested. With this patch the driver passes the mtd_oobtest on i.MX27 with 512 byte page size. Also tested with 2048 byte page size and on i.MX35 (v2 type controller) Signed-off-by:
Wolfram Sang <w.sang@pengutronix.de> Tested-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Based on work from Alberto Panizzo for MX3X Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
support copied from mach-pca100.c Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Eric Bénard authored
Signed-off-by:
-
Wolfram Sang authored
Like this one (if CONFIG_USB_ULPI is not set): arch/arm/mach-mx3/mach-pcm043.c:312: warning: 'otg_pdata' defined but not used arch/arm/mach-mx3/mach-pcm043.c:317: warning: 'usbh1_pdata' defined but not used Signed-off-by:
-
Daniel Mack authored
This makes the resistive touch interface work. Signed-off-by:
Daniel Mack <daniel@caiaq.de> Signed-off-by:
-
- 26 May, 2010 1 commit
-
-
Daniel Mack authored
CC arch/arm/mach-mx3/mach-pcm037.o arch/arm/mach-mx3/mach-pcm037.c: In function 'mxc_board_init': arch/arm/mach-mx3/mach-pcm037.c:584: warning: unused variable 'tmp' Signed-off-by:
-
- 25 May, 2010 9 commits
-
-
git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6Linus Torvalds authored
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (63 commits) drivers/net/usb/asix.c: Fix pointer cast. be2net: Bug fix to avoid disabling bottom half during firmware upgrade. proc_dointvec: write a single value hso: add support for new products Phonet: fix potential use-after-free in pep_sock_close() ath9k: remove VEOL support for ad-hoc ath9k: change beacon allocation to prefer the first beacon slot sock.h: fix kernel-doc warning cls_cgroup: Fix build error when built-in macvlan: do proper cleanup in macvlan_common_newlink() V2 be2net: Bug fix in init code in probe net/dccp: expansion of error code size ath9k: Fix rx of mcast/bcast frames in PS mode with auto sleep wireless: fix sta_info.h kernel-doc warnings wireless: fix mac80211.h kernel-doc warnings iwlwifi: testing the wrong variable in iwl_add_bssid_station() ath9k_htc: rare leak in ath9k_hif_usb_alloc_tx_urbs() ath9k_htc: dereferencing before check in hif_usb_tx_cb() rt2x00: Fix rt2800usb TX descriptor writing. rt2x00: Fix failed SLEEP->AWAKE and AWAKE->SLEEP transitions. ...
-
git://git.kernel.org/pub/scm/linux/kernel/git/mattst88/alpha-2.6Linus Torvalds authored
* 'alpha-next' of git://git.kernel.org/pub/scm/linux/kernel/git/mattst88/alpha-2.6: alpha: simplify and optimize sched_find_first_bit alpha: invoke oom-killer from page fault Convert alpha to use clocksources instead of arch_gettimeoffset
-
git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core-2.6Linus Torvalds authored
* git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core-2.6: driver core: add devname module aliases to allow module on-demand auto-loading
-
Linus Torvalds authored
This reverts commit 480b02df, since Rafael reports that it causes occasional kernel paging request faults in load_module(). Dropping the module lock and re-taking it deep in the call-chain is definitely not the right thing to do. That just turns the mutex from a lock into a "random non-locking data structure" that doesn't actually protect what it's supposed to protect. Requested-and-tested-by:
Rafael J. Wysocki <rjw@sisk.pl> Cc: Rusty Russell <rusty@rustcorp.com.au> Cc: Brandon Philips <brandon@ifup.org> Cc: Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
Linus Torvalds <torvalds@linux-foundation.org>
-
David S. Miller authored
Stephen Rothwell reports the following new warning: drivers/net/usb/asix.c: In function 'asix_rx_fixup': drivers/net/usb/asix.c:325: warning: cast from pointer to integer of different size drivers/net/usb/asix.c:354: warning: cast from pointer to integer of different size The code just cares about the low alignment bits, so use an "unsigned long" cast instead of one to "u32". Signed-off-by:David S. Miller <davem@davemloft.net>
-
Sarveshwar Bandi authored
Certain firmware commands/operations to upgrade firmware could take several seconds to complete. The code presently disables bottom half during these operations which could lead to unpredictable behaviour in certain cases. This patch now does all firmware upgrade operations asynchronously using a completion variable. Signed-off-by:
Sarveshwar Bandi <sarveshwarb@serverengines.com> Signed-off-by:
-
J. R. Okajima authored
The commit 00b7c339 "sysctl: refactor integer handling proc code" modified the behaviour of writing to /proc. Before the commit, write("1\n") to /proc/sys/kernel/printk succeeded. But now it returns EINVAL. This commit supports writing a single value to a multi-valued entry. Signed-off-by:
J. R. Okajima <hooanon05@yahoo.co.jp> Reviewed-and-tested-by:
WANG Cong <amwang@redhat.com> Signed-off-by:
-
Filip Aben authored
This patch adds a few new product id's for the hso driver. Signed-off-by:
Filip Aben <f.aben@option.com> Signed-off-by:
-
Rémi Denis-Courmont authored
sk_common_release() might destroy our last reference to the socket. So an extra temporary reference is needed during cleanup. Signed-off-by:
Rémi Denis-Courmont <remi.denis-courmont@nokia.com> Signed-off-by:
-
