1. 19 Apr, 2013 16 commits
    • Patrick McHardy's avatar
      netlink: implement memory mapped sendmsg() · 5fd96123
      Patrick McHardy authored
      Add support for mmap'ed sendmsg() to netlink. Since the kernel validates
      received messages before processing them, the code makes sure userspace
      can't modify the message contents after invoking sendmsg(). To do that
      only a single mapping of the TX ring is allowed to exist and the socket
      must not be shared. If either of these two conditions does not hold, it
      falls back to copying.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      5fd96123
    • Patrick McHardy's avatar
      netlink: add mmap'ed netlink helper functions · 9652e931
      Patrick McHardy authored
      Add helper functions for looking up mmap'ed frame headers, reading and
      writing their status, allocating skbs with mmap'ed data areas and a poll
      function.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      9652e931
    • Patrick McHardy's avatar
      netlink: mmaped netlink: ring setup · ccdfcc39
      Patrick McHardy authored
      Add support for mmap'ed RX and TX ring setup and teardown based on the
      af_packet.c code. The following patches will use this to add the real
      mmap'ed receive and transmit functionality.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      ccdfcc39
    • Patrick McHardy's avatar
      netlink: add netlink_skb_set_owner_r() · cf0a018a
      Patrick McHardy authored
      For mmap'ed I/O a netlink specific skb destructor needs to be invoked
      after the final kfree_skb() to clean up state. This doesn't work currently
      since the skb's ownership is transfered to the receiving socket using
      skb_set_owner_r(), which orphans the skb, thereby invoking the destructor
      prematurely.
      
      Since netlink doesn't account skbs to the originating socket, there's no
      need to orphan the skb. Add a netlink specific skb_set_owner_r() variant
      that does not orphan the skb and use a netlink specific destructor to
      call sock_rfree().
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      cf0a018a
    • Patrick McHardy's avatar
      netlink: don't orphan skb in netlink_trim() · 1298ca46
      Patrick McHardy authored
      Netlink doesn't account skbs to the sending socket, so the there's no
      need to orphan the skb before trimming it.
      
      Removing the skb_orphan() call is required for mmap'ed netlink, which uses
      a netlink specific skb destructor that must not be invoked before the
      final freeing of the skb.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      1298ca46
    • Patrick McHardy's avatar
      net: add function to allocate sk_buff head without data area · 0ebd0ac5
      Patrick McHardy authored
      Add a function to allocate a sk_buff head without any data. This will
      be used by memory mapped netlink to attach data from the mmaped area
      to the skb.
      
      Additionally change skb_release_all() to check whether the skb has a
      data area to allow the skb destructor to clear the data pointer in case
      only a head has been allocated.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      0ebd0ac5
    • Patrick McHardy's avatar
      netlink: rename ssk to sk in struct netlink_skb_params · e32123e5
      Patrick McHardy authored
      Memory mapped netlink needs to store the receiving userspace socket
      when sending from the kernel to userspace. Rename 'ssk' to 'sk' to
      avoid confusion.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      e32123e5
    • Patrick McHardy's avatar
      cd967e05
    • David S. Miller's avatar
      Merge branch '8021ad' · 447b816f
      David S. Miller authored
      Patrick McHardy says:
      
      ====================
      The following patches add support for 802.1ad (provider tagging) to the
      VLAN driver. The patchset consists of the following parts:
      
      - renaming of the NET_F_HW_VLAN feature flags to indicate that they only
        operate on CTAGs
      
      - preparation for 802.1ad VLAN filtering offload by adding a proto argument
        to the rx_{add,kill}_vid net_device_ops callbacks
      
      - preparation of the VLAN code to support multiple protocols by making the
        protocol used for tagging a property of the VLAN device and converting
        the device lookup functions accordingly
      
      - second step of preparation of the VLAN code by making the packet tagging
        functions take a protocol argument
      
      - introducation of 802.1ad support in the VLAN code, consisting mainly of
        checking for ETH_P_8021AD in a couple of places and testing the netdevice
        offload feature checks to take the protocol into account
      
      - announcement of STAG offloading capabilities in a couple of drivers for
        virtual network devices
      
      The patchset is based on net-next.git and has been tested with single and
      double tagging with and without HW acceleration (for CTAGs).
      ====================
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      447b816f
    • Patrick McHardy's avatar
      net: vlan: announce STAG offload capability in some drivers · 28d2b136
      Patrick McHardy authored
      - macvlan: propagate STAG filtering capabilities from underlying device
      - ifb: announce STAG tagging support in addition to CTAG tagging support
      - veth: announce STAG tagging/stripping support in addition to CTAG support
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      28d2b136
    • Patrick McHardy's avatar
      net: vlan: add 802.1ad support · 8ad227ff
      Patrick McHardy authored
      Add support for 802.1ad VLAN devices. This mainly consists of checking for
      ETH_P_8021AD in addition to ETH_P_8021Q in a couple of places and check
      offloading capabilities based on the used protocol.
      
      Configuration is done using "ip link":
      
      # ip link add link eth0 eth0.1000 \
      	type vlan proto 802.1ad id 1000
      # ip link add link eth0.1000 eth0.1000.1000 \
      	type vlan proto 802.1q id 1000
      
      52:54:00:12:34:56 > 92:b1:54:28:e4:8c, ethertype 802.1Q (0x8100), length 106: vlan 1000, p 0, ethertype 802.1Q, vlan 1000, p 0, ethertype IPv4, (tos 0x0, ttl 64, id 0, offset 0, flags [DF], proto ICMP (1), length 84)
          20.1.0.2 > 20.1.0.1: ICMP echo request, id 3003, seq 8, length 64
      92:b1:54:28:e4:8c > 52:54:00:12:34:56, ethertype 802.1Q-QinQ (0x88a8), length 106: vlan 1000, p 0, ethertype 802.1Q, vlan 1000, p 0, ethertype IPv4, (tos 0x0, ttl 64, id 47944, offset 0, flags [none], proto ICMP (1), length 84)
          20.1.0.1 > 20.1.0.2: ICMP echo reply, id 3003, seq 8, length 64
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      8ad227ff
    • Patrick McHardy's avatar
      net: vlan: add protocol argument to packet tagging functions · 86a9bad3
      Patrick McHardy authored
      Add a protocol argument to the VLAN packet tagging functions. In case of HW
      tagging, we need that protocol available in the ndo_start_xmit functions,
      so it is stored in a new field in the skb. The new field fits into a hole
      (on 64 bit) and doesn't increase the sks's size.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      86a9bad3
    • Patrick McHardy's avatar
      net: vlan: prepare for 802.1ad support · 1fd9b1fc
      Patrick McHardy authored
      Make the encapsulation protocol value a property of VLAN devices and change
      the device lookup functions to take the protocol value into account.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      1fd9b1fc
    • Patrick McHardy's avatar
      net: vlan: prepare for 802.1ad VLAN filtering offload · 80d5c368
      Patrick McHardy authored
      Change the rx_{add,kill}_vid callbacks to take a protocol argument in
      preparation of 802.1ad support. The protocol argument used so far is
      always htons(ETH_P_8021Q).
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      80d5c368
    • Patrick McHardy's avatar
      net: vlan: rename NETIF_F_HW_VLAN_* feature flags to NETIF_F_HW_VLAN_CTAG_* · f646968f
      Patrick McHardy authored
      Rename the hardware VLAN acceleration features to include "CTAG" to indicate
      that they only support CTAGs. Follow up patches will introduce 802.1ad
      server provider tagging (STAGs) and require the distinction for hardware not
      supporting acclerating both.
      Signed-off-by: default avatarPatrick McHardy <kaber@trash.net>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      f646968f
    • David S. Miller's avatar
      Merge branch 'intel' · c2962897
      David S. Miller authored
      Jeff Kirsher says:
      
      ====================
      This series contains updates to ixgbe and igb.
      
      The ixgbe changes contains 2 patches from the community, one which is a
      fix from akepner to fix a issue where netif_running() in shutdown was
      not done under rtnl_lock.  The other community fix from Joe Perches
      cleans up #ifdef CONFIG_DEBUG_FS which is no longer necessary.  The
      last ixgbe patch, from Jacob Keller, adds support for WoL on 82559
      SFP+ LOM.
      
      The remaining patches are against igb, 10 of which were previously
      submitted in a pull request where changes were requested.
      
      The following igb patches:
       igb: Support for 100base-fx SFP
       igb: Support to read and export SFF-8472/8079 data
      are v2 based on feedback from Dan Carpenter and Ben Hutchings in
      the previous pull request.
      
      The largest set of changes are in my patch to cleanup code comments
      and whitespace to align the igb driver with the networking style of
      code comments.  While cleaning up the code comments, fixed several
      other whitespace/checkpatch.pl code formatting issues.
      
      Other notable igb patches are EEE capable devices query the PHY to
      determine what the link partner is advertising, added support for
      i354 devices and added support for spoofchk config.
      ====================
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      c2962897
  2. 18 Apr, 2013 24 commits