- 24 Nov, 2021 40 commits
-
-
Nicholas Piggin authored
The P9 path uses vc->dpdes only for msgsndp / SMT emulation. This adds an ordering requirement between vcpu->doorbell_request and vc->dpdes for no real benefit. Use vcpu->doorbell_request directly. Signed-off-by:
Nicholas Piggin <npiggin@gmail.com> Signed-off-by:
Michael Ellerman <mpe@ellerman.id.au> Link: https://lore.kernel.org/r/20211123095231.1036501-53-npiggin@gmail.com
-
Nicholas Piggin authored
This goes further to removing vcores from the P9 path. Also avoid the memset in favour of explicitly initialising all fields. Signed-off-by:
-
Nicholas Piggin authored
The P9 path always uses one vcpu per vcore, so none of the vcore, locks, stolen time, blocking logic, shared waitq, etc., is required. Remove most of it. Signed-off-by:
-
Nicholas Piggin authored
cpu_in_guest is set to determine if a CPU needs to be IPI'ed to exit the guest and notice the need_tlb_flush bit. This can be implemented as a global per-CPU pointer to the currently running guest instead of per-guest cpumasks, saving 2 atomics per entry/exit. P7/8 doesn't require cpu_in_guest, nor does a nested HV (only the L0 does), so move it to the P9 HV path. Signed-off-by:
-
Nicholas Piggin authored
The mmu will almost always be ready. Signed-off-by:
-
Nicholas Piggin authored
kvm_hstate.in_guest provides the equivalent of MSR[RI]=0 protection, and it covers the existing MSR[RI]=0 section in late entry and early exit, so clearing and setting MSR[RI] in those cases does not actually do anything useful. Remove the RI manipulation and replace it with comments. Make the in_guest memory accesses a bit closer to a proper critical section pattern. This speeds up guest entry/exit performance. This also removes the MSR[RI] warnings which aren't very interesting and would cause crashes if they hit due to causing an interrupt in non-recoverable code. Signed-off-by:
-
Nicholas Piggin authored
slbmfee/slbmfev instructions are very expensive, moreso than a regular mfspr instruction, so minimising them significantly improves hash guest exit performance. The slbmfev is only required if slbmfee found a valid SLB entry. Signed-off-by:
-
Nicholas Piggin authored
Rearrange the MSR saving on entry so it does not follow the mtmsrd to disable interrupts, avoiding a possible RAW scoreboard stall. Signed-off-by:
-
Nicholas Piggin authored
mftb() is expensive and one can be avoided on nested guest dispatch. If the time checking code distinguishes between the L0 timer and the nested HV timer, then both can be tested in the same place with the same mftb() value. This also nicely illustrates the relationship between the L0 and nested HV timers. Signed-off-by:
-
Nicholas Piggin authored
Use the existing TLB flushing logic to IPI the previous CPU and run the necessary barriers before running a guest vCPU on a new physical CPU, to do the necessary radix GTSE barriers for handling the case of an interrupted guest tlbie sequence. This requires the vCPU TLB flush sequence that is currently just done on one thread, to be expanded to ensure the other threads execute a ptesync, because causing them to exit the guest will no longer cause a ptesync by itself. This results in more IPIs than the TLB flush logic requires, but it's a significant win for common case scheduling when the vCPU remains on the same physical CPU. This saves about 520 cycles (nearly 10%) on a guest entry+exit micro benchmark on a POWER9. Signed-off-by:
-
Nicholas Piggin authored
This creates separate functions for old and new paths for vCPU TLB flushing, which will reduce complexity of the next change. Signed-off-by:
-
Nicholas Piggin authored
This also moves the PSSCR update in nested entry to avoid a SPR scoreboard stall. Signed-off-by:
-
Nicholas Piggin authored
Some of the DAWR SPR access is already predicated on dawr_enabled(), apply this to the remainder of the accesses. Signed-off-by:
-
Nicholas Piggin authored
Tighten up partition switching code synchronisation and comments. In particular, hwsync ; isync is required after the last access that is performed in the context of a partition, before the partition is switched away from. Signed-off-by:
-
Nicholas Piggin authored
Linux implements SPR save/restore including storage space for registers in the task struct for process context switching. Make use of this similarly to the way we make use of the context switching fp/vec save restore. This improves code reuse, allows some stack space to be saved, and helps with avoiding VRSAVE updates if they are not required. Signed-off-by:
-
Nicholas Piggin authored
Use HFSCR facility disabling to implement demand faulting for TM, with a hysteresis counter similar to the load_fp etc counters in context switching that implement the equivalent demand faulting for userspace facilities. This speeds up guest entry/exit by avoiding the register save/restore when a guest is not frequently using them. When a guest does use them often, there will be some additional demand fault overhead, but these are not commonly used facilities. Signed-off-by:
Fabiano Rosas <farosas@linux.ibm.com> Signed-off-by:
-
Nicholas Piggin authored
Use HFSCR facility disabling to implement demand faulting for EBB, with a hysteresis counter similar to the load_fp etc counters in context switching that implement the equivalent demand faulting for userspace facilities. This speeds up guest entry/exit by avoiding the register save/restore when a guest is not frequently using them. When a guest does use them often, there will be some additional demand fault overhead, but these are not commonly used facilities. Signed-off-by:
-
Nicholas Piggin authored
This avoids more scoreboard stalls and reduces mtSPRs. Signed-off-by:
-
Nicholas Piggin authored
Use CPU_FTR_P9_RADIX_PREFETCH_BUG to apply the workaround, to test for DD2.1 and below processors. This saves a mtSPR in guest entry. Signed-off-by:
-
Nicholas Piggin authored
This moves PMU switch to guest as late as possible in entry, and switch back to host as early as possible at exit. This helps the host get the most perf coverage of KVM entry/exit code as possible. This is slightly suboptimal for SPR scheduling point of view when the PMU is enabled, but when perf is disabled there is no real difference. Signed-off-by:
-
Nicholas Piggin authored
If TM is not active, only TM register state needs to be saved and restored, avoiding several mfmsr/mtmsrd instructions and improving performance. Signed-off-by:
-
Nicholas Piggin authored
Move register saving and loading from kvmhv_p9_guest_entry() into the HV and nested entry handlers. Accesses are scheduled to reduce mtSPR / mfSPR interleaving which reduces SPR scoreboard stalls. Signed-off-by:
-
Nicholas Piggin authored
Move the part of the guest entry which is specific to nested HV into its own function. This is just refactoring. Signed-off-by:
-
Nicholas Piggin authored
Move the P9 guest/host register switching functions to the built-in P9 entry code, and export it for nested to use as well. This allows more flexibility in scheduling these supervisor privileged SPR accesses with the HV privileged and PR SPR accesses in the low level entry code. Signed-off-by:
-
Nicholas Piggin authored
This should be no functional difference but makes the caller easier to read. Signed-off-by:
-
Nicholas Piggin authored
This juggles SPR switching on the entry and exit sides to be more symmetric, which makes the next refactoring patch possible with no functional change. Signed-off-by:
-
Nicholas Piggin authored
Keep better track of the current SPR value in places where they are to be loaded with a new context, to reduce expensive mtSPR operations. Signed-off-by:
-
Nicholas Piggin authored
Avoid interleaving mfSPR and mtSPR to reduce SPR scoreboard stalls. Signed-off-by:
-
Nicholas Piggin authored
Reduce the number of mfTB executed by passing the current timebase around entry and exit code rather than read it multiple times. Signed-off-by:
-
Nicholas Piggin authored
Move the TB updates between saving and loading guest and host SPRs, to improve scheduling by keeping issue-NTC operations together as much as possible. Signed-off-by:
-
Nicholas Piggin authored
Change dec_expires to be relative to the guest timebase, and allow it to be moved into low level P9 guest entry functions, to improve SPR access scheduling. Signed-off-by:
-
Nicholas Piggin authored
Small cleanup makes it a bit easier to match up entry and exit operations. Signed-off-by:
-
Nicholas Piggin authored
Moving the mtmsrd after the host SPRs are saved and before the guest SPRs start to be loaded can prevent an SPR scoreboard stall (because the mtmsrd is L=1 type which does not cause context synchronisation. This is also now more convenient to combined with the mtmsrd L=0 instruction to enable facilities just below, but that is not done yet. Signed-off-by:
-
Nicholas Piggin authored
This reduces the number of mtmsrd required to enable facility bits when saving/restoring registers, by having the KVM code set all bits up front rather than using individual facility functions that set their particular MSR bits. Signed-off-by:
-
Nicholas Piggin authored
Move the SPR update into its relevant helper function. This will help with SPR scheduling improvements in later changes. Signed-off-by:
-
Nicholas Piggin authored
Processors that support KVM HV do not require read-modify-write of the CTRL SPR to set/clear their thread's runlatch. Just write 1 or 0 to it. Signed-off-by:
-
Nicholas Piggin authored
Factor duplicated code into a helper function. Signed-off-by:
-
Nicholas Piggin authored
The pmcregs_in_use field in the guest VPA can not be trusted to reflect what the guest is doing with PMU SPRs, so the PMU must always be managed (stopped) when exiting the guest, and SPR values set when entering the guest to ensure it can't cause a covert channel or otherwise cause other guests or the host to misbehave. So prevent guest access to the PMU with HFSCR[PM] if pmcregs_in_use is clear, and avoid the PMU SPR access on every partition switch. Guests that set pmcregs_in_use incorrectly or when first setting it and using the PMU will take a hypervisor facility unavailable interrupt that will bring in the PMU SPRs. Signed-off-by:
Athira Jajeev <atrajeev@linux.vnet.ibm.com> Signed-off-by:
-
Nicholas Piggin authored
Rather than guest/host save/retsore functions, implement context switch functions that take care of details like the VPA update for nested. The reason to split these kind of helpers into explicit save/load functions is mainly to schedule SPR access nicely, but PMU is a special case where the load requires mtSPR (to stop counters) and other difficulties, so there's less possibility to schedule those nicely. The SPR accesses also have side-effects if the PMU is running, and in later changes we keep the host PMU running as long as possible so this code can be better profiled, which also complicates scheduling. Signed-off-by:
-
Nicholas Piggin authored
Implement the P9 path PMU save/restore code in C, and remove the POWER9/10 code from the P7/8 path assembly. Signed-off-by:
-
