- 07 Sep, 2010 13 commits
-
-
Santiago Leon authored
ibmveth can scatter gather up to 6 segments. If we go over this then we have no option but to call skb_linearize, like other drivers with similar limitations do. Signed-off-by:
Anton Blanchard <anton@samba.org> Signed-off-by:
Santiago Leon <santil@linux.vnet.ibm.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Anton Blanchard authored
We want to order the read in ibmveth_rxq_pending_buffer and the read of ibmveth_rxq_buffer_valid which are both cacheable memory. smp_rmb() is good enough for this. Signed-off-by:
-
Santiago Leon authored
For small packets, create a new skb and copy the packet into it so we avoid tearing down and creating a TCE entry. Signed-off-by:
-
Santiago Leon authored
Use the existing bounce buffer if we send a buffer under a certain size. This saves the overhead of a TCE map/unmap. I can't see any reason for the wmb() in the bounce buffer case, if we need a barrier it will be before we call h_send_logical_lan but we have nothing in the common case. Remove it. Signed-off-by:
-
Santiago Leon authored
The ibmveth adapter needs locking in the transmit routine to protect the bounce_buffer but it sets LLTX and forgets to add any of its own locking. Just remove the deprecated LLTX option. Remove the stats lock in the process. Signed-off-by:
-
Santiago Leon authored
At the moment we try and replenish the receive ring on every rx interrupt. We even have a pool->threshold but aren't using it. To limit the maximum latency incurred when refilling, change the threshold from 1/2 to 7/8 and reduce the largest rx pool from 768 buffers to 512 which should be more than enough. Signed-off-by:
-
Santiago Leon authored
Replace some modulus operators with an increment and compare to avoid an integer divide. Signed-off-by:
-
Denis Kirjanov authored
Signed-off-by:
Denis Kirjanov <dkirjanov@kernel.org> Signed-off-by:
-
Denis Kirjanov authored
Signed-off-by:
-
Denis Kirjanov authored
Signed-off-by:
-
Allan Stephens authored
Cause TIPC to return EAGAIN if it is unable to enable a new Ethernet bearer because one or more recently disabled Ethernet bearers are temporarily consuming resources during shut down. (The previous error code, EDQUOT, is now returned only if all available Ethernet bearer data structures are fully enabled at the time the request to enable an additional bearer is received.) Signed-off-by:
Allan Stephens <allan.stephens@windriver.com> Signed-off-by:
Paul Gortmaker <paul.gortmaker@windriver.com> Signed-off-by:
-
Allan Stephens authored
Add code to expand the headroom of an outgoing TIPC message if the sk_buff has insufficient room to hold the header for the associated Ethernet device. This change is necessary to ensure that messages TIPC does not create itself (eg. incoming messages that are being routed to another node) do not cause problems, since TIPC has no control over the amount of headroom available in such messages. Signed-off-by:
-
Allan Stephens authored
Optimizes TIPC's name table translation code to avoid unnecessary manipulation of the node address field of the resulting port id when name translation fails. This change is possible because a valid port id cannot have a reference field of zero, so examining the reference only is sufficient to determine if the translation was successful. Signed-off-by:
-
- 06 Sep, 2010 2 commits
-
-
stephen hemminger authored
Change several wan drivers to make strings and other initialize only parameters const. Compile tested only (with no new warnings) Signed-off-by:
Stephen Hemminger <shemminger@vyatta.com> Signed-off-by:
-
Eric Dumazet authored
While porting GRO to r8169, I found this driver has a bug in its rx path. All skbs given to network stack had their ip_summed set to CHECKSUM_NONE, while hardware said they had correct TCP/UDP checksums. The reason is driver sets skb->ip_summed on the original skb before the copy eventually done by copybreak. The fresh skb gets the ip_summed = CHECKSUM_NONE value, forcing network stack to recompute checksum, and preventing my GRO patch to work. Fix is to make the ip_summed setting after skb copy. Note : rx_copybreak current value is 16383, so all frames are copied... Signed-off-by:
Eric Dumazet <eric.dumazet@gmail.com> Acked-by:
Francois Romieu <romieu@fr.zoreil.com> Signed-off-by:
-
- 03 Sep, 2010 10 commits
-
-
Casey Leedom authored
Don't call flush_workqueue() on the cxgb3 Work Queue in cxgb_down() when we're being called from the fatal error task ... which is executing on the cxgb3 Work Queue. Signed-off-by:
Casey Leedom <leedom@chelsio.com> Signed-off-by:
-
Casey Leedom authored
Platform code needs to deal with them now. Signed-off-by:
Dimitris Michailidis <dm@chelsio.com> Signed-off-by:
-
Casey Leedom authored
Signed-off-by:
-
Casey Leedom authored
Signed-off-by:
-
Eric Dumazet authored
__alloc_skb() uses a memset() to clear all the beginning of skb, including bitfields contained in 'flags1' & 'flags2'. We dont need any more to use kmemcheck_annotate_bitfield() on these fields. However, we still need it for the clone part, which is not cleared. Signed-off-by:
-
Eric Dumazet authored
struct tulip_private is a bit large (order-1 allocation even on 32bit arch), try to shrink it, remove its net_device_stats field. Signed-off-by:
-
Thomas Graf authored
Documentation for recent changes to the tunables accept_ra and forwarding. Signed-off-by:
Thomas Graf <tgraf@infradead.org> Signed-off-by:
-
Thomas Graf authored
Similar to accepting router advertisement, the IPv6 stack does not send router solicitations if forwarding is enabled. This patch enables this behavior to be overruled by setting forwarding to the special value 2. Signed-off-by:
-
Thomas Graf authored
The current IPv6 behavior is to not accept router advertisements while forwarding, i.e. configured as router. This does make sense, a router is typically not supposed to be auto configured. However there are exceptions and we should allow the current behavior to be overwritten. Therefore this patch enables the user to overrule the "if forwarding enabled then don't listen to RAs" rule by setting accept_ra to the special value of 2. An alternative would be to ignore the forwarding switch alltogether and solely accept RAs based on the value of accept_ra. However, I found that if not intended, accepting RAs as a router can lead to strange unwanted behavior therefore we it seems wise to only do so if the user explicitely asks for this behavior. Signed-off-by:
-
Eric Dumazet authored
fresh skbs have ip_summed set to CHECKSUM_NONE (0) We can avoid setting again skb->ip_summed to CHECKSUM_NONE in drivers. Introduce skb_checksum_none_assert() helper so that we keep this assertion documented in driver sources. Change most occurrences of : skb->ip_summed = CHECKSUM_NONE; by : skb_checksum_none_assert(skb); Signed-off-by:
-
- 02 Sep, 2010 11 commits
-
-
David S. Miller authored
Merge branch 'for-davem' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-next-2.6
-
Eric Dumazet authored
get_stats() method incorrectly clears a global array before folding various stats. This can break SNMP applications. Switch to 64 bit flavor to work on a user supplied buffer, and provide 64bit counters even on 32bit arches. Fix a bug in bnad_netdev_hwstats_fill(), for rx_fifo_errors, missing a folding (only the last counter was taken into account) Signed-off-by:
Rasesh Mody <rmody@brocade.com> Signed-off-by:
-
John W. Linville authored
Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-next-2.6 into for-davem
-
Changli Gao authored
Clean the code up according to Documentation/CodingStyle. Don't initialize the variable dont_send in arp_process(). Remove the temporary varialbe flags in arp_state_to_flags(). Signed-off-by:
Changli Gao <xiaosuo@gmail.com> Signed-off-by:
-
Eric Dumazet authored
Add a small helper ptype_head() to get the head to manipulate dev_add_pack() & __dev_remove_pack() can use a spinlock without blocking BH, since softirq use RCU, and these functions are run from process context only. Signed-off-by:
-
Peter Meerwald authored
Correct state range of PHY bus addresses (i.e. 0-31) in comment, make spelling of PHY consistent in comments. Signed-off-by:
Peter Meerwald <pmeerw@pmeerw.net> Signed-off-by:
-
Julian Anastasov authored
Use correctly the in_pkts packet counter also for SCTP Signed-off-by:
Julian Anastasov <ja@ssi.bg> Signed-off-by:
Simon Horman <horms@verge.net.au> Signed-off-by:
-
Eric Dumazet authored
Kill last_rx use in l2tp and two net drivers Signed-off-by:
-
David S. Miller authored
Add a dma_addr_t 64-bit case for powerpc with 64-bit phys addresses. Reported-by:
Stephen Rothwell <sfr@canb.auug.org.au> Signed-off-by:
-
Gerrit Renker authored
Thanks to Ilpo Jarvinen, this updates also the initial window setting for tcp_output with regard to RFC 5681. Signed-off-by:
Gerrit Renker <gerrit@erg.abdn.ac.uk> Signed-off-by:
-
stephen hemminger authored
Signed-off-by:
-
- 01 Sep, 2010 4 commits
-
-
Huang Weiyi authored
Remove duplicated #include('s) in drivers/net/pxa168_eth.c Signed-off-by:Huang Weiyi <weiyi.huang@gmail.com> Signed-off-by:
-
John W. Linville authored
Otherwise the hardware scan handler could access an invalid scan request structure. The driver should cancel any pending hardware scans during the suspend process anyway, so also add a warning if the hardware scan is still pending when the device resumes. Signed-off-by:John W. Linville <linville@tuxdriver.com>
-
Eric Dumazet authored
(skb->data - skb->head) can be changed by skb_headroom(skb) Remove some uses of NET_SKBUFF_DATA_USES_OFFSET, using (skb_end_pointer(skb) - skb->head) or (skb_tail_pointer(skb) - skb->head) : compiler does the right thing, and this is more readable for us ;) (struct skb_shared_info *) casts in pskb_expand_head() to help memcpy() to use aligned moves. Signed-off-by:
-
Eric Dumazet authored
- napi_gro_flush() is exported from net/core/dev.c, to avoid an irq_save/irq_restore in the packet receive path. - use napi_gro_receive() instead of netif_receive_skb() - use napi_gro_flush() before calling __napi_complete() - turn on NETIF_F_GRO by default - Tested on a Marvell 88E8001 Gigabit NIC Signed-off-by:
-
