- 24 Jun, 2004 40 commits
-
-
Bartlomiej Zolnierkiewicz authored
- setup hwgroup->handler/timer in ->prehandler() (after checking drive status) and in do_rw_taskfile() only send a command - make pre_task_mulout_intr() transfer first data block itself instead of calling ->handler() so we don't have to play tricks with hwgroup->handler/timer in task_mulout_intr() Signed-off-by:
Bartlomiej Zolnierkiewicz <bzolnier@elka.pw.edu.pl> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
Bartlomiej Zolnierkiewicz authored
- update rq counters directly in task_buffer_sectors() - use task_buffer[_multi]_sectors() in taskfile PIO handlers (CONFIG_IDE_TASKFILE_IO=n and flagged ones) so: (a) rq->hard_cur_sectors is used for rq mapping (b) in case of error valid rq->sector is reported (c) we can s/rq->current_nr_sectors/rq->nr_sectors/ later - uninline task_buffer_sectors() - remove not needed !rq->bio code from ide_[un]map_buffer() (it is used only for fs requests which are always bio based) - remove no longer needed task_rq_offset() Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
REQ_DRIVE_TASKFILE requests aren't retried so don't clear rq->errors in CONFIG_IDE_TASKFILE_IO=n PIO handlers and in CONFIG_IDE_TASKFILE_IO=y PIO handlers clear rq->errors only for fs requests, flagged_* PIO handlers were already okay. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
- split __task_sectors() out of task_sectors() - add bio and buffer versions of task[_multi]_sectors() - use task_bio_sectors() instead of task_sectors() in pdc4030.c - move task[_buffer]_sectors() to ide-taskfile.c - uninline task[_multi]_sectors() Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
Move common code from task_mulin_intr() and task_mulout_intr() (CONFIG_IDE_TASKFILE_IO=y) to a task_multi_sectors() helper. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
They are off by default and conflict with the future changes. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
We should wait for the last IRQ after all data is sent. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
Check drive->mult_count in flagged_taskfile() and fail request early if necessary so there is no need to do it later in the PIO handlers. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
If the drive times out the final status check we should fail the request instead of setting another handler for the next IRQ. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
ide_end_drive_cmd() should only be called for "flagged" taskfiles which have separate PIO handlers so use driver->end_request() instead. Signed-off-by:
-
Bartlomiej Zolnierkiewicz authored
Remove checks for hwgroup->handler == NULL from task_[in,mulin,out]_intr() (CONFIG_IDE_TASKFILE_IO=n versions). These functions can be called only from ide_intr() or ide_timer_expiry() and both set hwgroup->handler to NULL first. Signed-off-by:
-
Alexander Viro authored
Low-level drivers' ->ioctl() gets a userland pointer from scsi_ioctl(); prototype annotated, so is scsi_debug instance.
-
Alexander Viro authored
-
Alexander Viro authored
Fixes for direct dereferencing of userland pointers in i2o_config.c
-
Alexander Viro authored
-
Alexander Viro authored
isdn_writebuf_stub() was always called for userland pointers. Killed the argument telling whether it's kernel or userland pointer, killed dead code, updated callers.
-
Alexander Viro authored
-
Alexander Viro authored
- trivial annotation in several places in drivers/mtd - a bunch of debugging printks switched from %x to %llx (they get 64bit values) - in doc200[01].c fixed type of (unused) last argument in their doc_read_ecc().
-
Alexander Viro authored
-
Alexander Viro authored
DVD_LU_SEND_{AGID,TITLE_KEY} can be legitimately rejected; in that case we should not spew into logs. -
Andries E. Brouwer authored
Updating my source to 2.6.7 I see that you applied some nonsense garbage patch. Please undo. [ Note by Linus: the fact that DOS_EXTENDED_PARTITION is 5, and we're iterating over slots 1-4 in the partition table, are two totally unrelated things. Using the symbolic constant does indeed not make any sense at all here, as Andries so eloquently points out. ]
-
Benjamin Herrenschmidt authored
The exception rewrite contains a small bug that prevents bring up of CPUs on logically partitioned machines. The kernel is trying to zero the backlink on the new stack while running with relocation disabled, which potentially cause it to try to access an address outside of the region allowed in real mode. This seem to be a leftover from previous code as we also zero the backlink later after turning off the MMU. This patch removes the offending bit.
-
Paul Mackerras authored
The whitespace in arch/ppc64/kernel/head.S is a bit all over the place. This patch fixes it up. This patch changes nothing other than whitespace. Signed-off-by:
Paul Mackerras <paulus@samba.org> Signed-off-by:
-
Paul Mackerras authored
Anton noticed in some traces that we were spending an awfully long time doing a memset. The ppc64 memset is basically unchanged from the ppc32 version, and it only does 4-byte stores and doesn't unroll the loop. Here's a memset that performs a bit better. I have been using it for 3 weeks now, and Anton has tested it on a variety of machines, without problems. Signed-off-by:
-
Paul Mackerras authored
Somebody back in the mists of time decided that call_prom and rtas_call should return longs even though both of those bits of firmware run in 32-bit mode and produce a 32-bit result. To make life more interesting, the 32-bit result gets zero-extended to 64 bits, which makes checking for a -1 return value more complicated than it should be. This patch changes call_prom and rtas_call to return an int, and makes the corresponding changes to use ints for the variables used to hold those return values. While I was doing this I finally got annoyed enough with the strings of prom_print() and prom_print_hex() calls that we do to write a simple prom_printf. I deliberately didn't use snprintf because the execution environment is weird at this point - we aren't running at the address we are linked at just yet - and I didn't want to inflict that on any code outside this file. I also did a prom_debug() macro, which eliminated a few ifdefs. There are also a bunch of other minor cleanups. This patch makes very few algorithmic changes but does get rid of a lot of casts. :) I have been running with this patch for a couple of weeks, and Anton has tested it too. Signed-off-by:
-
Roland McGrath authored
When I made get_user_pages support looking up a pte for the "gate" area, I assumed it would be part of the kernel's fixed mappings. On x86-64 running a 32-bit task, the 32-bit vsyscall DSO page still has no vma but has its pte allocated in the user mm in the normal fashion. This patch makes it use the generic page-table lookup calls rather than the shortcuts. With this, ptrace on x86-64 can access a 32-bit process's vsyscall page. The behavior on x86 is unchanged. Signed-off-by:
Roland McGrath <roland@redhat.com> Signed-off-by:
-
Andrew Morton authored
From: Darren Williams <dsw@gelato.unsw.edu.au> include/asm/checksum.h:75: warning: `struct in6_addr' declared inside parameter list include/asm/checksum.h:75 Signed-off-by:
Andrew Morton <akpm@osdl.org> Signed-off-by:
-
Andrew Morton authored
arch/i386/kernel/io_apic.c: In function `balanced_irq': arch/i386/kernel/io_apic.c:582: warning: no return statement in function returning non-void and clean things up a bit Signed-off-by:
-
Andrew Morton authored
mm/vmscan.c: In function `kswapd': mm/vmscan.c:1139: warning: no return statement in function returning non-void Signed-off-by:
-
Andrew Morton authored
From: NeilBrown <neilb@cse.unsw.edu.au> From: Josh Litherland <josh@emperorlinux.com> The XOR routine selection process is often confusing as it often doesn't choose the routine that measures the fastest, as sometime one routine is known to have better cache performance. This patch avoids the comparison when there is a known best choice, and makes the report more meaningful. Signed-off-by:
Neil Brown <neilb@cse.unsw.edu.au> Signed-off-by:
-
Andrew Morton authored
From: NeilBrown <neilb@cse.unsw.edu.au> There is severe bit-rot in this code, which is to say that it doesn't work at all: an io error during read will do bad things. It should work better with this patch. Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> Nothing really interesting here, with the addition of several other Renesas boards, we just move the systemh directory to the renesas one to fit in better with the directory structure. Signed-off-by:
Paul Mundt <lethal@linux-sh.org> Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This merges the remaining sh changes, random bug fixes, added syscalls, cache fixups, etc. Nothing really eventful. Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This adds support for the SM501/VoyagerGX companion chip, used by the RTS7751R2D. Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This adds support for the SH7705 and SH7300 subtypes and also updates some ST40-specific FRQCR handling code. Signed-off-by:
Alex Bennee <kernel-hacker@bennee.com> Signed-off-by:
Hiroshi DOYU <Hiroshi_DOYU@montavista.co.jp> Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This updates the pci-auto code, as well as adding ops and fixups for the RTS7751R2D board. Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This adds support for the Renesas Technology Sales RTS7751R2D board. Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This adds support for the SH7300 solution engine board (a forward port of the 2.4 code). Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This adds support for the SH7300 as well as the SH5-101/103 processors as well as specific board support for the RTS7751R2D. In addition to this, the sh early printk code is gutted so that we use the generic CONFIG_EARLY_PRINTK interfaces instead. Signed-off-by:
-
Andrew Morton authored
From: Paul Mundt <lethal@Linux-SH.ORG> This fixes up a compile error occuring with ptep_get_and_clear() existing in pgalloc.h. We move it to a somewhat more sensible location instead, and take this opportunity to make some cleanups for use of generic code in the SH-3 case, etc. Signed-off-by:
-
