- 18 Jun, 2006 21 commits
-
-
Ben Dooks authored
Patch from Ben Dooks Platform devices for the LEDs on all the SMDK24XX boards Signed-off-by:
Ben Dooks <ben-linux@fluff.org> Signed-off-by:
Russell King <rmk+kernel@arm.linux.org.uk>
-
David Brownell authored
Patch from David Brownell This adds the platform device for SSP/SPI controller, and declares the ads7846 device hooked up to it. Not all Lubbock boards appear to populate the connector needed to use this instead of the ucb1400 chip, but it can always be used as a temperature sensor. In short, this is probably most useful as an example of how to provide the configuration data used by the pxa2xx_spi driver. (Last tested against a slightly earlier version of that driver.) Signed-off-by:
David Brownell <dbrownell@users.sourceforge.net> Signed-off-by:
-
Tony Lindgren authored
Patch from Tony Lindgren This patch fixes some dyntick locking issues on ARM as pointed out by Russell King. Signed-off-by:
Tony Lindgren <tony@atomide.com> Signed-off-by:
-
Ben Dooks authored
Patch from Ben Dooks Move the printk of the CPU information and IDCODE before the checking of the table entry validity to aide in debugging new cpu entries. Signed-off-by:
-
Ben Dooks authored
Patch from Ben Dooks Using the low-level debug routines early in the kernel debug cause the 1:1 mapping to get into the TLB, which is not flushed until after the CPU detection process (which needs the GPIO VA). This patch moves the VA for the GPIO to the same offset as the physical offset of the UART to the GPIO. Signed-off-by:
-
Ben Dooks authored
Patch from Ben Dooks If CONFIG_CPU_DCACHE_WRITETHOUGH is set, then the S3C24XX PM code fails to compile, as there is no need to flush the D-cache, the flush function arm920_flush_kern_cache_all() is not compiled. Fix the code to not use this if the config is set. Signed-off-by:
-
Ben Dooks authored
Patch from Ben Dooks The default serial port-mapping for the Osiris has the port 2 mapped onto the first serial port, and no port1. Correct this so port 1 is port. Signed-off-by:
-
Catalin Marinas authored
Patch from Catalin Marinas This code was still using the old format for the ARMv6 CPU id and it wasn't flushing the caches on the MPCore CPU (and other ARM1176 cores). The patch changes the mask bits to cope with the new id format. Signed-off-by:
Catalin Marinas <catalin.marinas@arm.com> Signed-off-by:
-
Paul Brook authored
Patch from Paul Brook The old-abi sys_syscall syscall is broken when called from Thumb mode. It assumes the syscall number is an Arm syscall number (ie. starts from __NR_OABI_SYSCALL_BASE). In thumb mode syscall numbers start from zero. The patch below fixes this by clearing the nigh bits of the syscall number instead of inverting them. Technically this means we accept some invalid syscall numbers, but I can't see how that could be a problem. The two sets of numbers far apart that unimplemented syscalls should still be rejected. Signed-off-by:
Paul Brook <paul@codesourcery.com> Signed-off-by:
-
Vitaly Wool authored
Patch from Vitaly Wool This patch adds default configuration file PNX4008 ARM platform. It\'s basically the same as the previos one. Signed-off-by:
Vitaly Wool <vwool@ru.mvista.com> Signed-off-by:
Dmitry Pervushin <dpervushin@gmail.com> Signed-off-by:
-
Vitaly Wool authored
Patch from Vitaly Wool This patch adds basic chip support for PNX4008 ARM platform. It's basically the same as the previous one, but with the rmk's comments taken into account. Signed-off-by:
-
Vitaly Wool authored
Patch from Vitaly Wool This patch adds kernel headers for PNX4008 ARM platform. It's basically the same as the previos one, but with the rmk's comments taken into account. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer New documentation for the touchscreen controllers and LCD panels. Signed-off-by:
Marc Singer <elf@buici.com> Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer Reworking of the adaptation macros to allow driver to compile again for the lpd7x's. Also, support added for the lh79520 so it may use the smc91x. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer Driver for operating SSP devices through LPD7A40X CPLD chip. This driver is used by the audio codecs. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer Board support and LCD panel configurations to integrate lh7a40x's with the amba clcd driver. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer Revised default configuration files. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer The serial driver now sets up the third UART when it is to be used. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer Updates to the lpd7a40x_platform files. Includes support for new architecture, lpd7a400. Signed-off-by:
-
Marc Singer authored
Patch from Marc Singer Updates to the lpd7a40x platform headers. Includes support for new architecture, lpd7a400. Signed-off-by:
-
Linus Torvalds authored
Being named "Crazed Snow-Weasel" instills a lot of confidence in this release, so I'm sure this will be one of the better ones.
-
- 17 Jun, 2006 8 commits
-
-
Arnd Bergmann authored
Reflect the fact that the Cell Broadband Engine supports 64k pages by adding the bit to the CPU features. Signed-off-by:
Arnd Bergmann <arnd.bergmann@de.ibm.com> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
Arnd Bergmann authored
The page size encoding passed to tlbie is incorrect for new-style large pages. This fixes it. This doesn't affect anything on older machines because mmu_psize_defs[psize].penc (the page size encoding) is 0 for 4k and 16M pages (the two are distinguished by a separate "is a large page" bit). Signed-off-by:
Benjamin Herrenschmidt <benh@kernel.crashing.org> Signed-off-by:
Paul Mackerras <paulus@samba.org> Signed-off-by:
-
Oleg Nesterov authored
arm_timer() checks PF_EXITING to prevent BUG_ON(->exit_state) in run_posix_cpu_timers(). However, for some reason it does so only for CPUCLOCK_PERTHREAD case (which is imho wrong). Also, this check is not reliable, PF_EXITING could be set on another cpu without any locks/barriers just after the check, so it can't prevent from attaching the timer to the exiting task. The previous patch makes this check unneeded. Signed-off-by:
Oleg Nesterov <oleg@tv-sign.ru> Signed-off-by:
-
Oleg Nesterov authored
do_exit() clears ->it_##clock##_expires, but nothing prevents another cpu to attach the timer to exiting process after that. arm_timer() tries to protect against this race, but the check is racy. After exit_notify() does 'write_unlock_irq(&tasklist_lock)' and before do_exit() calls 'schedule() local timer interrupt can find tsk->exit_state != 0. If that state was EXIT_DEAD (or another cpu does sys_wait4) interrupted task has ->signal == NULL. At this moment exiting task has no pending cpu timers, they were cleanuped in __exit_signal()->posix_cpu_timers_exit{,_group}(), so we can just return from irq. John Stultz recently confirmed this bug, see http://marc.theaimsgroup.com/?l=linux-kernel&m=115015841413687Signed-off-by: -
Oleg Nesterov authored
If the local timer interrupt happens just after do_exit() sets PF_EXITING (and before it clears ->it_xxx_expires) run_posix_cpu_timers() will call check_process_timers() with tasklist_lock + ->siglock held and check_process_timers: t = tsk; do { .... do { t = next_thread(t); } while (unlikely(t->flags & PF_EXITING)); } while (t != tsk); the outer loop will never stop. Actually, the window is bigger. Another process can attach the timer after ->it_xxx_expires was cleared (see the next commit) and the 'if (PF_EXITING)' check in arm_timer() is racy (see the one after that). Signed-off-by: -
Stephen Hemminger authored
A couple of fixes that should prevent crashes when using netconsole and suspend/resume. First, netconsole poll routine shouldn't run unless the device is up; second, the NAPI poll should be disabled during suspend. This is only an issue on sky2, because it has to have one NAPI poll routine for both ports on dual port boards. Normal drivers use netif_rx_schedule_prep and that checks for netif_running. Signed-off-by:
Stephen Hemminger <shemminger@osdl.org> Signed-off-by:
-
Jens Axboe authored
If get_user_pages() returns less pages than what we asked for, we jump to out_unmap which will return ERR_PTR(ret). But ret can contain a positive number just smaller than local_nr_pages, so be sure to set it to -EFAULT always. Problem found and diagnosed by Damien Le Moal <damien@sdl.hitachi.co.jp> Signed-off-by:
Jens Axboe <axboe@suse.de> Signed-off-by:
-
Jens Axboe authored
Some time ago the cdrom open routine was changed so that we call the driver's open routine before checking to see if it is read only. However, if we discovered that a read write open was not possible and the open flags required a writable open, we just returned -EROFS without calling the driver's release routine. This seems to work for most cdrom drivers, but breaks the Powerpc iSeries virtual cdrom rather badly. This just inserts the release call in the error path to balance the call to "->open()" done by "open_for_data()". Signed-off-by:
Stephen Rothwell <sfr@canb.auug.org.au> Signed-off-by:
-
- 14 Jun, 2006 2 commits
-
-
Jens Axboe authored
We don't clear the seek stat values in cfq_alloc_io_context(), and if ->seek_mean is unlucky enough to be set to -36 by chance, the first invocation of cfq_update_io_seektime() will oops with a divide by zero in do_div(). Just memset the entire cic instead of filling invididual values independently. Signed-off-by:
-
Kirill Korotaev authored
If flock_lock_file() failed to allocate flock with locks_alloc_lock() then "error = 0" is returned. Need to return some non-zero. Signed-off-by:
Pavel Emelianov <xemul@openvz.org> Signed-off-by:
Kirill Korotaev <dev@openvz.org> Signed-off-by:
-
- 13 Jun, 2006 5 commits
-
-
Stephen Hemminger authored
The resume bug was caused not by an early interrupt but because the idle timeout was not being stopped on suspend. Also disable hardware IRQ's on suspend. Will need to revisit this with hotplug? Signed-off-by:
-
Stephen Hemminger authored
The hardware should be fully shut off during suspend, and the base irq mask restored during resume. Signed-off-by:
-
Stephen Hemminger authored
If the poll routine detects no hardware available, it needs to dequeue it self from the network poll list. Linus didn't understand NAPI. Signed-off-by:
-
Stephen Hemminger authored
It is cleaner, to not loop over both ports if only one exists. Signed-off-by:
-
Stephen Hemminger authored
The set power state function is cleaner if it doesn't return anything. The only caller that could fail is in suspend() and it can check the argument there. Signed-off-by:
-
- 12 Jun, 2006 4 commits
-
-
Randy Dunlap authored
From: Randy Dunlap <rdunlap@xenotime.net> According to include/asm-alpha/bitops.h, only ALPHA_EV67 has hardware hweight support, so ALPHA_EV6 needs to use GENERIC_HWEIGHT. Signed-off-by:
Randy Dunlap <rdunlap@xenotime.net> Cc: Richard Henderson <rth@twiddle.net> Cc: Ivan Kokshaysky <ink@jurassic.park.msu.ru> Cc: Ernst Herzberg <earny@net4u.de> Signed-off-by:
Andrew Morton <akpm@osdl.org> Signed-off-by:
-
Sergey Vlasov authored
shmem_rmdir() must undo the increment of i_nlink done in shmem_get_inode() for directories, otherwise at least IN_DELETE_SELF inotify event generation is broken. Signed-off-by:
Sergey Vlasov <vsu@altlinux.ru> Signed-off-by:
Hugh Dickins <hugh@veritas.com> Signed-off-by:
-
Robin H. Johnson authored
I noticed a strange behavior in a tmpfs file system the other day, while building packages - occasionally, and seemingly at random, make decided to rebuild a target. However, only on tmpfs. A file would be created, and if checked, it had a sub-second timestamp. However, after an utimes related call where sub-seconds should be set, they were zeroed instead. In the case that a file was created, and utimes(...,NULL) was used on it in the same second, the timestamp on the file moved backwards. After some digging, I found that this was being caused by tmpfs not having a time granularity set, thus inheriting the default 1 second granularity. Hugh adds: yes, we missed tmpfs when the s_time_gran mods went into 2.6.11. Unfortunately, the granularity of CURRENT_TIME, often used in filesystems, does not match the default granularity set by alloc_super. A few more such discrepancies have been found, but this is the most important to fix now. Signed-off-by:
Robin H. Johnson <robbat2@gentoo.org> Acked-by:
Andi Kleen <ak@suse.de> Signed-off-by:
-
Linus Torvalds authored
* master.kernel.org:/pub/scm/linux/kernel/git/davem/sparc-2.6: [SPARC64]: Do not double-export sys_close() when CONFIG_SOLARIS_EMUL_MODULE
-
