- 08 Jan, 2009 40 commits
-
-
Oliver Neukum authored
This converts the pegasus driver to use of the new net_device_ops structure Signed-off-by:
Oliver Neukum <oneukum@suse.de> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Eilon Greenstein authored
Signed-off-by:
Eilon Greenstein <eilong@broadcom.com> Signed-off-by:
-
Oliver Neukum authored
This converts the kaweth ethernet USB driver to netdevops. Signed-off-by:
-
Stephen Hemminger authored
The link check watchdog timer on this driver fires every two seconds, but since not aligned it causes extra wakeups. It is more important on this driver than most because it is the hardware that is emulated by default when using network interfaces on VMware. Signed-off-by:
Stephen Hemminger <shemminger@vyatta.com> Signed-off-by:
-
Inaky Perez-Gonzalez authored
Current code was assuming PM was always enabled, which is not correct. Code which accesses members in the struct usb_device that are dependant on CONFIG_PM must be protected the same. Reported by Randy Dunlap from a build error in the linux-next tree on 07/01/2009. Signed-off-by:
Inaky Perez-Gonzalez <inaky@linux.intel.com> Signed-off-by:
-
Inaky Perez-Gonzalez authored
Current WiMAX rfkill code is missing the case where rfkill is compiled in as modules and works only when rfkill is compiled in. This is not correct. Fixed to test for CONFIG_RFKILL or CONFIG_RKILL_MODULE. Signed-off-by:
-
Inaky Perez-Gonzalez authored
WiMAX can work without RFKILL, but it was missing a check to make sure RFKILL is not being made a module with wimax compiled into the kernel. This caused failed builds in s390, where CONFIG_INPUT is always off. When RFKILL is enabled, the code uses the input layer to report hardware switch changes; thus, if RFKILL is enabled, INPUT has to be too. It also needs to display some message when INPUT is disabled that explains why WiMAX is not selectable. (issues found by Randy Dunlap in the linux-next tree). Signed-off-by:
-
Inaky Perez-Gonzalez authored
Reported by Randy Dunlap: > Also, this warning needs to be fixed: > > linux-next-20090106/net/wimax/id-table.c:133: warning: ISO C90 > forbids mixed declarations and code Move the return on #defined(CONFIG_BUG) below the variable declarations so it doesn't violate ISO C90. On wimax_id_table_release() we want to do a debug check if CONFIG_BUG is enabled. However, we also want the debug code to be always compiled to ensure there is no bitrot. It will be optimized out by the compiler when CONFIG_BUG is disabled. Added a note to the function header stating this. Signed-off-by:
-
David S. Miller authored
-
Florian Fainelli authored
This patch bumps release number to 0.20 and 07Jan2009. Signed-off-by:
Florian Fainelli <florian@openwrt.org> Signed-off-by:
-
Florian Fainelli authored
Some bootloader/BIOSes do not set the MAC address, warn about that. Signed-off-by:
-
Florian Fainelli authored
This patch makes the driver properly initialize the PHY status if not correctly set by the bootloader/BIOS. It prevents some boards to bring up the link on boot. Signed-off-by:
-
Florian Fainelli authored
This patch fixes some printks which were not prefixed with DRV_NAME, useful when having multiple cards/drivers on the system. Signed-off-by:
-
Kumar Gala authored
Commit b31a1d8b ("gianfar: Convert gianfar to an of_platform_driver") went back to using BUS_ID_SIZE instead of sizeof() as per the larger patch series that will remove "char bus_id[20]" from struct device. Signed-off-by:
Kumar Gala <galak@kernel.crashing.org> Signed-off-by:
-
Yevgeny Petrilin authored
Signed-off-by:
Yevgeny Petrilin <yevgenyp@mellanox.co.il> Signed-off-by:
-
Yevgeny Petrilin authored
Was trying to unmap work queue entries that had inline packets, so naturally weren't mapped. Signed-off-by:
-
Sonic Zhang authored
Signed-off-by:
Sonic Zhang <sonic.zhang@analog.com> Signed-off-by:
Bryan Wu <cooloney@kernel.org> Signed-off-by:
-
Frank Blaschka authored
qeth_l2, qeth_l3 convert to net_device_ops. qeth_l3 remove vlan neigh_setup hack since it does not work any longer with the new net_device_ops. Signed-off-by:
Frank Blaschka <frank.blaschka@de.ibm.com> Signed-off-by:
-
Frank Blaschka authored
In case the real device has a neigh_setup function, this neigh_setup function should be used for the vlan device. Signed-off-by:
-
Wu Fengguang authored
Add warnings on invalid mac address to help disclose/debug problems. Signed-off-by:
Wu Fengguang <fengguang.wu@intel.com> Acked-by:
Peter Korsgaard <jacmet@sunsite.dk> Signed-off-by:
-
Wu Fengguang authored
Otherwise unicast RX will only work in promisc mode. Signed-off-by:
-
Herbert Xu authored
This patch adds GRO support for TCP over IPv6. The code is exactly the same as the IPv4 version except for the pseudo-header checksum computation. Note that I've removed the unused tcphdr argument from tcp_v6_check rather than invent a bogus value for GRO. Signed-off-by:
Herbert Xu <herbert@gondor.apana.org.au> Signed-off-by:
-
Herbert Xu authored
This patch adds GRO support for IPv6. IPv6 GRO supports extension headers in the same way as GSO (by using the same infrastructure). It's also simpler compared to IPv4 since we no longer have to worry about fragmentation attributes or header checksums. Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
David Vrabel <david.vrabel@csr.com> Signed-off-by:
-
Stephen Hemminger authored
Convert to net_device_ops Signed-off-by:
-
Stephen Hemminger authored
Convert to net_device_ops and internal net_device_stats Signed-off-by:
-
Stephen Hemminger authored
Convert to net_device_ops and internal net_device_stats Signed-off-by:
-
Stephen Hemminger authored
Add net_device_ops and use interal stats Signed-off-by:
Karsten Keil <kkeil@suse.de> Signed-off-by:
-
Stephen Hemminger authored
Several API problems fixed: * use proper allocation * handle renames * convert to net_device_ops * use internal net_device_stats This driver is putrid (as in old and rotten), so I doubt any one uses it. Signed-off-by:
-
Stephen Hemminger authored
Use internal network_device_stats that exist in network device and net_device_ops. Compile tested only. Signed-off-by:
-
Stephen Hemminger authored
Convert to net_device_ops and internal net_device_stats Signed-off-by:
-
Stephen Hemminger authored
Convert to net_device_ops and internal net_device_stats Signed-off-by:
-
Stephen Hemminger authored
Convert to internal net_device-stats and net_device_ops Signed-off-by:
-
Stephen Hemminger authored
Convert to net_device_ops and internal net_device_stats Signed-off-by:
-
Stephen Hemminger authored
Signed-off-by:
-
