- 30 Oct, 2012 13 commits
-
-
Alexander Duyck authored
This change fixes a sparse warning triggered by us casting the timestamp in the packet as a u64 instead of as a __le64. This change corrects that in order to resolve the sparse warning. Signed-off-by:
Alexander Duyck <alexander.h.duyck@intel.com> Tested-by:
Aaron Brown <aaron.f.brown@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com>
-
Carolyn Wyborny authored
There are multiple places in our device nvm where the version is stored. This update fixes some output errors with some types of images and refactors the way the version data is gathered and stored for ethtool output. Signed-off-by:
Carolyn Wyborny <carolyn.wyborny@intel.com> Tested-by:
-
Matthew Vick authored
Newer devices supported by igb can support auto-crossover detection in forced operation modes. Enable this in the driver, rather than clobbering this functionality in forced operation. Signed-off-by:
Matthew Vick <matthew.vick@intel.com> Tested-by:
-
Greg Rose authored
Ignoring the return value from a call to the kernel dma_map API functions can cause data corruption and system instability. Check the return value and take appropriate action. Signed-off-by:
Greg Rose <gregory.v.rose@intel.com> Tested-by:
Sibai Li <sibai.li@intel.com> Signed-off-by:
-
Greg Rose authored
The driver should not forward LLDP type frames. Inspect the ether type and do not send if it is an LLDP ethertype frame. Signed-off-by:
-
Jiri Benc authored
Hw timestamping code caused performance regression in ixgbe driver when the timestamping is not enabled. The culprit is IXGBE_READ_REG call in the Rx path which is executed for every received skb. This call is not needed when the timestamping is disabled or for non-ptp packets. netperf results: The ixgbe side of the connection was acting as a server, the netperf command line on the other side was: netperf -H 192.168.1.23 -T0,0 -t UDP_STREAM -l 20 The values below mean throughput as reported by netperf (local/remote), for 3 runs, with timestamping not enabled. 3.7.0-rc1+ with CONFIG_IXGBE_PTP off: 5373.83 / 3329.32 5721.88 / 3033.89 5653.42 / 3112.38 3.7.0-rc1+ with CONFIG_IXGBE_PTP on: 5233.64 / 1226.85 5448.67 / 1039.32 5421.36 / 1095.66 Patched 3.7.0-rc1+ with CONFIG_IXGBE_PTP on: 5594.72 / 2942.53 5428.95 / 3110.16 5343.56 / 3200.48 Reported-by:
Jesper Brouer <jbrouer@redhat.com> Signed-off-by:
Jiri Benc <jbenc@redhat.com> Signed-off-by:
Andy Gospodarek <gospo@redhat.com> Tested-by:
Phil Schmitt <phillip.j.schmitt@intel.com> Signed-off-by:
-
Josh Hay authored
Adds/updates ASCII descriptor maps for 82598 and 82599 Tx/Rx descriptors. Current descriptor maps were out of date for 82598 and incorrect for 82599. Signed-off-by:
Josh Hay <joshua.a.hay@intel.com> Tested-by:
-
Alexander Duyck authored
This change makes it so that compare the total_rx_packets cleaned to budget instead of decrementing budget. The advantage to this approach is that budget can now be const and we only end up modifying total_rx_packets instead of modifying both it and budget. Signed-off-by:
-
Greg Rose authored
When setting a MAC filter for the VF the function should return a success or failure code, not the index of the new filter. It causes spurious NACK returns to the VF driver. Signed-off-by:
-
Emil Tantilov authored
This patch simplifies the check for calling en/disable_tx_laser() function pointer. The pointer is only set on parts that can use it. Signed-off-by:
Emil Tantilov <emil.s.tantilov@intel.com> Tested-by:
-
John Fastabend authored
In SR-IOV mode the PF driver acts as the uplink port and is used to send control packets e.g. lldpad, stp, etc. eth0.1 eth0.2 eth0 VF VF PF | | | <-- stand-in for uplink | | | -------------------------- | Embedded Switch | -------------------------- | MAC <-- uplink But the embedded switch is setup to forward multicast addresses to all interfaces both VFs and PF and onto the physical link. This results in reserved MAC addresses used by control protocols to be forwarded over the switch onto the VF. In the LLDP case the PF sends an LLDPDU and it is currently being forwarded to all the VFs who then see the PF as a peer. This is incorrect. This patch adds the multicast addresses to the RAR table in the hardware to prevent this behavior. Signed-off-by:John Fastabend <john.r.fastabend@intel.com> Tested-by:
-
Greg Rose authored
The function to set the macvlan filter should return success or failure instead of the index of the filter. The message processing function was misinterpreting the index as a non-zero return code indicating failure and NACKing MAC filter set messages that actually succeeded. Signed-off-by:
-
Don Skidmore authored
Calling the ixgbe_reset_pipeline_82599 function will ensure a full pipeline reset on all 82599 devices. This is necessary to avoid possible link issues. Since this patch accomplishes this by modifying AUTOC.LMS we need to wrap all AUTOC writes when LESM is enabled. v2- fix LMS behaviour based on feedback by Martin Josefsson CC: Martin Josefsson <gandalf@mjufs.se> Signed-off-by:
Don Skidmore <donald.c.skidmore@intel.com> Tested-by:
-
- 28 Oct, 2012 8 commits
-
-
Bjørn Mork authored
Removes the warnings drivers/net/usb/sierra_net.c:343:45: warning: incorrect type in assignment (different base types) drivers/net/usb/sierra_net.c:343:45: expected unsigned short [unsigned] [short] [usertype] <noident> drivers/net/usb/sierra_net.c:343:45: got restricted __be16 [usertype] <noident> and drivers/net/usb/sierra_net.c:658:18: warning: cast to restricted __le16 Signed-off-by:
Bjørn Mork <bjorn@mork.no> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Bjørn Mork authored
Fixes the sparse warning drivers/net/usb/cdc_ncm.c:836:9: warning: context imbalance in 'cdc_ncm_txpath_bh' - different lock contexts for basic block Signed-off-by:
-
Bjørn Mork authored
Probably doesn't matter much since the value is used as a boolean anyway, but it removes the sparse warning: drivers/net/usb/cdc_ncm.c:1090:32: warning: incorrect type in assignment (different base types) drivers/net/usb/cdc_ncm.c:1090:32: expected unsigned short [unsigned] [usertype] connected drivers/net/usb/cdc_ncm.c:1090:32: got restricted __le16 [usertype] wValue Signed-off-by:
-
Nicolas Dichtel authored
This message allows to get the devconf for an interface. Signed-off-by:
Nicolas Dichtel <nicolas.dichtel@6wind.com> Signed-off-by:
-
Nicolas Dichtel authored
Signed-off-by:
-
Nicolas Dichtel authored
This message allows to get the devconf for an interface. Signed-off-by:
-
Nicolas Dichtel authored
Signed-off-by:
-
Nicolas Dichtel authored
A new type is added to allow userland to monitor protocol configuration, like IPv4 or IPv6. For example, monitoring the state of the forwarding status of an interface of the system. Signed-off-by:
-
- 26 Oct, 2012 19 commits
-
-
git://1984.lsi.us.es/nf-nextDavid S. Miller authored
Pablo Neira Ayuso says: ==================== The following changeset contains updates for IPVS from Jesper Dangaard Brouer that did not reach the previous merge window in time. More specifically, updates to improve IPv6 support in IPVS. More relevantly, some of the existing code performed wrong handling of the extensions headers and better fragmentation handling. Jesper promised more follow-up patches to refine this after this batch hits net-next. Yet to come. ==================== Signed-off-by: -
David S. Miller authored
Only the real implementation got updated. Signed-off-by: -
Alan Cox authored
Signed-off-by:
Alan Cox <alan@linux.intel.com> Signed-off-by:
-
Alan Cox authored
multi is assigned to 0 and then acts as a constant. Remove the dead code. Signed-off-by:
-
Daniel Wagner authored
The cgroup logic part of net_cls is very similar as the one in net_prio. Let's stream line the net_cls logic with the net_prio one. The net_prio update logic was changed by following commit (note there were some changes necessary later on) commit 406a3c63 Author: John Fastabend <john.r.fastabend@intel.com> Date: Fri Jul 20 10:39:25 2012 +0000 net: netprio_cgroup: rework update socket logic Instead of updating the sk_cgrp_prioidx struct field on every send this only updates the field when a task is moved via cgroup infrastructure. This allows sockets that may be used by a kernel worker thread to be managed. For example in the iscsi case today a user can put iscsid in a netprio cgroup and control traffic will be sent with the correct sk_cgrp_prioidx value set but as soon as data is sent the kernel worker thread isssues a send and sk_cgrp_prioidx is updated with the kernel worker threads value which is the default case. It seems more correct to only update the field when the user explicitly sets it via control group infrastructure. This allows the users to manage sockets that may be used with other threads. Since classid is now updated when the task is moved between the cgroups, we don't have to call sock_update_classid() from various places to ensure we always using the latest classid value. [v2: Use iterate_fd() instead of open coding] Signed-off-by:
Daniel Wagner <daniel.wagner@bmw-carit.de> Cc: Li Zefan <lizefan@huawei.com> Cc: "David S. Miller" <davem@davemloft.net> Cc: "Michael S. Tsirkin" <mst@redhat.com> Cc: Jamal Hadi Salim <jhs@mojatatu.com> Cc: Joe Perches <joe@perches.com> Cc: John Fastabend <john.r.fastabend@intel.com> Cc: Neil Horman <nhorman@tuxdriver.com> Cc: Stanislav Kinsbursky <skinsbursky@parallels.com> Cc: Tejun Heo <tj@kernel.org> Cc: <netdev@vger.kernel.org> Cc: <cgroups@vger.kernel.org> Acked-by:
Neil Horman <nhorman@tuxdriver.com> Signed-off-by:
-
Daniel Wagner authored
sock_update_classid() assumes that the update operation always are applied on the current task. sock_update_classid() needs to know on which tasks to work on in order to be able to migrate task between cgroups using the struct cgroup_subsys attach() callback. Signed-off-by:
-
Daniel Wagner authored
As Eric pointed out: "Hey task_cls_classid() has its own rcu protection since commit 3fb5a991 (cls_cgroup: Fix rcu lockdep warning) So we can safely revert Paul commit (1144182a) (We no longer need rcu_read_lock/unlock here)" Signed-off-by:
-
Daniel Wagner authored
The classid type used throughout the kernel is u32. Signed-off-by:
-
Daniel Wagner authored
net_prio_attach() is only access via cgroup_subsys callbacks, therefore we can reduce the visibility of this function. Signed-off-by:
-
Ming Lei authored
Acked-by:
Oliver Neukum <oneukum@suse.de> Signed-off-by:
Ming Lei <ming.lei@canonical.com> Signed-off-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
Ming Lei authored
Acked-by:
-
