Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

This second version of the bridge loop avoidance for batman-adv
avoids loops between the mesh and a backbone (usually a LAN).

By connecting multiple batman-adv mesh nodes to the same ethernet
segment a loop can be created when the soft-interface is bridged
into that ethernet segment. A simple visualization of the loop
involving the most common case - a LAN as ethernet segment:

node1  <-- LAN  -->  node2
  |                   |
wifi   <-- mesh -->  wifi

Packets from the LAN (e.g. ARP broadcasts) will circle forever from
node1 or node2 over the mesh back into the LAN.

With this patch, batman recognizes backbone gateways, nodes which are
part of the mesh and backbone/LAN at the same time. Each backbone
gateway "claims" clients from within the mesh to handle them
exclusively. By restricting that only responsible backbone gateways
may handle their claimed clients traffic, loops are effectively
avoided.
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

The functionality is to be replaced by an improved implementation,
so first clean up.
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

Signed-off-by: Sven Eckelmann <sven@narfation.org>
Acked-by: Antonio Quartulli <ordex@autistici.org>
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

bitarray.c consists mostly of functionality that is already available as part
of the standard kernel API. batman-adv could use architecture optimized code
and reduce the binary size by switching to the standard functions.
Signed-off-by: Sven Eckelmann <sven@narfation.org>
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

In packet.h the numeric constant 6 is used instead of the more portable ETH_ALEN
define. This patch substitute any hardcoded value with such define.
Signed-off-by: Antonio Quartulli <ordex@autistici.org>
Acked-by: Sven Eckelmann <sven@narfation.org>

Signed-off-by: Antonio Quartulli <ordex@autistici.org>

Add myself as maintainer for net/batman-adv as announced by Marek Linder
Signed-off-by: Antonio Quartulli <ordex@autistici.org>

Both drivers need to depend upon HAS_IOMEM, otherwise we
get a build failure on platforms like S390.

All the driver specific config options need to depend upon
the drivers themselves.
Reported-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Everything has been set up in the PCI probe function.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Stanislav Yakovlev <stas.yakovlev@gmail.com>

No net_device.irq removal yet. The driver probe, remove and failure
paths need some care beforehand.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Stanislav Yakovlev <stas.yakovlev@gmail.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Stanislav Yakovlev <stas.yakovlev@gmail.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Jon Mason <mason@myri.com>
Acked-by: Andrew Gallatin <gallatin@myri.com>

- pci_resource_start() can be removed from sis900_get_mac_addr() because
  the IO range is maped and stored into the device private struct early
  in the device probe function.
- the driver contains a few direct accesses to low IO ports that forbid
  to re(#)define the usual out{l, w, b} macros.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Daniele Venzano <venza@brownhat.org>

This is a pure PCI driver, no ISA here.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Acked-by: Grant Grundler <grundler@parisc-linux.org>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

The bulk of the patch comes from the __iomem changes.

- the phy read and write operations were carrying the chip id deep
  down the call chain. Let's waste a pointer and contain the flying
  spaghetti monster.
- phy_{read, write}_1bit only need to access the DCR9 register. The loss
  of generality here should not hurt.
- removed a leftover printk of the EISA era. This is a pure PCI device.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Acked-by: Grant Grundler <grundler@parisc-linux.org>

The eeprom registers always use the same PCI bar whereas the general
registers may either use the same mapping as the eeprom registers or
a different one. It is thus possible to simplify parse_eeprom().
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

It's useless to check mem_start on a newly allocated device.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Tim Hockin <thockin@hockin.org>

The device private data pointer can not be NULL in smsc9420_open().
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Steve Glendinning <steve.glendinning@smsc.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Acked-by: Grant Grundler <grundler@parisc-linux.org>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Acked-by: Grant Grundler <grundler@parisc-linux.org>

- unbalanced pci_disable_device
- PCI ressources were not released
- mismatching pci_alloc_.../kfree pairs are replaced by DMA alloc helpers.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Ack-by: Grant Grundler <grundler@parisc-linux.org>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Ack-by: Grant Grundler <grundler@parisc-linux.org>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Ack-by: Grant Grundler <grundler@parisc-linux.org>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Acked-by: Michael Chan <mchan@broadcom.com>

Some settings are duplicated between ethtool link management and module
options. The latter is trimmed. The half duplex, speed and autonegotiation
defaults are kept unchanged.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Ion Badulescu <ionut@badula.org>

It's useless to check mem_start on a newly allocated device as well.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Ion Badulescu <ionut@badula.org>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Cc: Jon Mason <jdmason@kudzu.us>