Skip to content

L
linux
Switch branch/tag
  1. 19 Nov, 2018 9 commits
    • Arthur Kiyanovski's avatar
      net: ena: fix crash during failed resume from hibernation · e76ad21d
      Arthur Kiyanovski authored 
      During resume from hibernation if ena_restore_device fails,
ena_com_dev_reset() is called, and uses the readless read mechanism,
which was already destroyed by the call to
ena_com_mmio_reg_read_request_destroy(). This causes a NULL pointer
reference.

In this commit we switch the call order of the above two functions
to avoid this crash.

Fixes: d7703ddb ("net: ena: fix rare bug when failed restart/resume is followed by driver removal")
Signed-off-by: default avatarArthur Kiyanovski <akiyano@amazon.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      e76ad21d
    • Xin Long's avatar
      sctp: not increase stream's incnt before sending addstrm_in request · e1e46479
      Xin Long authored 
      Different from processing the addstrm_out request, The receiver handles
an addstrm_in request by sending back an addstrm_out request to the
sender who will increase its stream's in and incnt later.

Now stream->incnt has been increased since it sent out the addstrm_in
request in sctp_send_add_streams(), with the wrong stream->incnt will
even cause crash when copying stream info from the old stream's in to
the new one's in sctp_process_strreset_addstrm_out().

This patch is to fix it by simply removing the stream->incnt change
from sctp_send_add_streams().

Fixes: 242bd2d5 ("sctp: implement sender-side procedures for Add Incoming/Outgoing Streams Request Parameter")
Reported-by: default avatarJianwen Ji <jiji@redhat.com>
Signed-off-by: default avatarXin Long <lucien.xin@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      e1e46479
    • Xin Long's avatar
      Revert "sctp: remove sctp_transport_pmtu_check" · 69fec325
      Xin Long authored 
      This reverts commit 22d7be26.

The dst's mtu in transport can be updated by a non sctp place like
in xfrm where the MTU information didn't get synced between asoc,
transport and dst, so it is still needed to do the pmtu check
in sctp_packet_config.
Acked-by: default avatarNeil Horman <nhorman@tuxdriver.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      69fec325
    • Xin Long's avatar
      sctp: not allow to set asoc prsctp_enable by sockopt · cc3ccf26
      Xin Long authored 
      As rfc7496#section4.5 says about SCTP_PR_SUPPORTED:

   This socket option allows the enabling or disabling of the
   negotiation of PR-SCTP support for future associations.  For existing
   associations, it allows one to query whether or not PR-SCTP support
   was negotiated on a particular association.

It means only sctp sock's prsctp_enable can be set.

Note that for the limitation of SCTP_{CURRENT|ALL}_ASSOC, we will
add it when introducing SCTP_{FUTURE|CURRENT|ALL}_ASSOC for linux
sctp in another patchset.

v1->v2:
  - drop the params.assoc_id check as Neil suggested.

Fixes: 28aa4c26 ("sctp: add SCTP_PR_SUPPORTED on sctp sockopt")
Reported-by: default avatarYing Xu <yinxu@redhat.com>
Signed-off-by: default avatarXin Long <lucien.xin@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      cc3ccf26
    • Xin Long's avatar
      sctp: count sk_wmem_alloc by skb truesize in sctp_packet_transmit · 02968ccf
      Xin Long authored 
      Now sctp increases sk_wmem_alloc by 1 when doing set_owner_w for the
skb allocked in sctp_packet_transmit and decreases by 1 when freeing
this skb.

But when this skb goes through networking stack, some subcomponents
might change skb->truesize and add the same amount on sk_wmem_alloc.
However sctp doesn't know the amount to decrease by, it would cause
a leak on sk->sk_wmem_alloc and the sock can never be freed.

Xiumei found this issue when it hit esp_output_head() by using sctp
over ipsec, where skb->truesize is added and so is sk->sk_wmem_alloc.

Since sctp has used sk_wmem_queued to count for writable space since
Commit cd305c74 ("sctp: use sk_wmem_queued to check for writable
space"), it's ok to fix it by counting sk_wmem_alloc by skb truesize
in sctp_packet_transmit.

Fixes: cac2661c ("esp4: Avoid skb_cow_data whenever possible")
Reported-by: default avatarXiumei Mu <xmu@redhat.com>
Signed-off-by: default avatarXin Long <lucien.xin@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      02968ccf
    • Heiner Kallweit's avatar
      MAINTAINERS: Add myself as third phylib maintainer · a36b5444
      Heiner Kallweit authored 
      Add myself as third phylib maintainer.
Signed-off-by: default avatarHeiner Kallweit <hkallweit1@gmail.com>
Acked-by: default avatarAndrew Lunn <andrew@lunn.ch>
Acked-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      a36b5444
    • Linus Torvalds's avatar
      Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net · f2ce1065
      Linus Torvalds authored 
      Pull networking fixes from David Miller:

 1) Fix some potentially uninitialized variables and use-after-free in
    kvaser_usb can drier, from Jimmy Assarsson.

 2) Fix leaks in qed driver, from Denis Bolotin.

 3) Socket leak in l2tp, from Xin Long.

 4) RSS context allocation fix in bnxt_en from Michael Chan.

 5) Fix cxgb4 build errors, from Ganesh Goudar.

 6) Route leaks in ipv6 when removing exceptions, from Xin Long.

 7) Memory leak in IDR allocation handling of act_pedit, from Davide
    Caratti.

 8) Use-after-free of bridge vlan stats, from Nikolay Aleksandrov.

 9) When MTU is locked, do not force DF bit on ipv4 tunnels. From
    Sabrina Dubroca.

10) When NAPI cached skb is reused, we must set it to the proper initial
    state which includes skb->pkt_type. From Eric Dumazet.

11) Lockdep and non-linear SKB handling fix in tipc from Jon Maloy.

12) Set RX queue properly in various tuntap receive paths, from Matthew
    Cover.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (61 commits)
  tuntap: fix multiqueue rx
  ipv6: Fix PMTU updates for UDP/raw sockets in presence of VRF
  tipc: don't assume linear buffer when reading ancillary data
  tipc: fix lockdep warning when reinitilaizing sockets
  net-gro: reset skb->pkt_type in napi_reuse_skb()
  tc-testing: tdc.py: Guard against lack of returncode in executed command
  tc-testing: tdc.py: ignore errors when decoding stdout/stderr
  ip_tunnel: don't force DF when MTU is locked
  MAINTAINERS: Add entry for CAKE qdisc
  net: bridge: fix vlan stats use-after-free on destruction
  socket: do a generic_file_splice_read when proto_ops has no splice_read
  net: phy: mdio-gpio: Fix working over slow can_sleep GPIOs
  Revert "net: phy: mdio-gpio: Fix working over slow can_sleep GPIOs"
  net: phy: mdio-gpio: Fix working over slow can_sleep GPIOs
  net/sched: act_pedit: fix memory leak when IDR allocation fails
  net: lantiq: Fix returned value in case of error in 'xrx200_probe()'
  ipv6: fix a dst leak when removing its exception
  net: mvneta: Don't advertise 2.5G modes
  drivers/net/ethernet/qlogic/qed/qed_rdma.h: fix typo
  net/mlx4: Fix UBSAN warning of signed integer overflow
  ...
      f2ce1065
    • Matthew Cover's avatar
      tuntap: fix multiqueue rx · 8ebebcba
      Matthew Cover authored 
      When writing packets to a descriptor associated with a combined queue, the
packets should end up on that queue.

Before this change all packets written to any descriptor associated with a
tap interface end up on rx-0, even when the descriptor is associated with a
different queue.

The rx traffic can be generated by either of the following.
  1. a simple tap program which spins up multiple queues and writes packets
     to each of the file descriptors
  2. tx from a qemu vm with a tap multiqueue netdev

The queue for rx traffic can be observed by either of the following (done
on the hypervisor in the qemu case).
  1. a simple netmap program which opens and reads from per-queue
     descriptors
  2. configuring RPS and doing per-cpu captures with rxtxcpu

Alternatively, if you printk() the return value of skb_get_rx_queue() just
before each instance of netif_receive_skb() in tun.c, you will get 65535
for every skb.

Calling skb_record_rx_queue() to set the rx queue to the queue_index fixes
the association between descriptor and rx queue.
Signed-off-by: default avatarMatthew Cover <matthew.cover@stackpath.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      8ebebcba
    • David Ahern's avatar
      ipv6: Fix PMTU updates for UDP/raw sockets in presence of VRF · 7ddacfa5
      David Ahern authored 
      Preethi reported that PMTU discovery for UDP/raw applications is not
working in the presence of VRF when the socket is not bound to a device.
The problem is that ip6_sk_update_pmtu does not consider the L3 domain
of the skb device if the socket is not bound. Update the function to
set oif to the L3 master device if relevant.

Fixes: ca254490 ("net: Add VRF support to IPv6 stack")
Reported-by: default avatarPreethi Ramachandra <preethir@juniper.net>
Signed-off-by: default avatarDavid Ahern <dsahern@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      7ddacfa5
  3. 18 Nov, 2018 31 commits
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7