Patch from Ben Dooks

The patch does a number of updates, which are inter-dependant
on each other, for the s3c2440 support and some clean-ups for
all s3c24xx architecture in general.
1) Remove the s3c24xx_{fclk,hclk,pclk} variables, and pass
   these values to the clock core on initialisation. This
   removes the needless double copy, as only the timer code
   uses these directly (see point 4).
   Add an over-all xtal clock to the clock core
2) Add a sysdev driver to the clock code to ensure all the
   s3c2440 clocks are added if an s3c2440 is present.
3) Add the new IRQs to irq.c, and initialise them if the
   sysdev for the s3c2440 is present.
4) Change the timer code to request the timer clk and
   use it to get the frequency.
Depends on patch 2467/1
Thanks to Guillaume Gourat for the original patches that
prompted this re-write.

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Lennert Buytenhek

This patch makes the ixp2000 port use section mappings for on-chip
registers.  This has two advantages:
1. It saves some TLB entries.
2. It enables us to work around ixp2400 erratum #66, for which the
   suggested (and only) fix involves mapping all on-chip registers
   using XCB=101 instead of XCB=000.
This patch was derived from an older patch for the same erratum
(ARM patch ID 2265/1), made by Deepak Saxena.
Note that this patch does not actually constitute a workaround for
erratum #66, it merely lays the foundation for such a workaround.

Signed-off-by: Lennert BuytenhekSigned-off-by: Deepak Saxena
Signed-off-by: Russell King

Patch from John Lenz

Adds support for the Sharp Zaurus SL-5600
Add the ability to compile any collection of poodle and
corgi support under the PXA_SHARPSL option.
arch/arm/boot/compressed/head-sharpsl.S already has code
to detect the poodle machine.

Signed-off-by: John Lenz
Signed-off-by: Russell King

Patch from Ben Dooks

Use slab allocator instead of kmalloc() to allocate the
dma buffer descriptors. This should allow the tracking
of dma descriptors, and to check if they are being freed
correctly.

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Brief documentation for Documents/arm/Samsung-S3C24XX for the
HP IPAQ H1940

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Enable the watchdog at the start of the kernel uncompression
stage, so that if any errors occur before the kernel reaches
the stage where it can start running processes then the system
will be reset.

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

S3C2410 ADC register definitions
Patch from Shannon Holland

Signed-off-by: Shannon Holland

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

21285 serial driver has a couple of sparse errors from zero
initialiser, as well as an unused label.

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Cliff Brake

Changes to machine specific files and add defconfig so the CONFIG_ARCH_PXA_IDP machine will build and run.  Changes are mostly related to the 2.6 driver model.  Also removed code that is no longer required -- support for older versions of hardware, etc.

Signed-off-by: Cliff Brake
Signed-off-by: Russell King

Patch from Ben Dooks

Eliminate NULL initiated fields in the port structures
which where causing errors from sparse.

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

fix the following problems:
lib/iomap.c:140: warning: passing arg 1 of `__raw_readsb' makes pointer from integer without a cast
lib/iomap.c:156: warning: passing arg 1 of `__raw_writesb' makes pointer from integer without a cast
include/asm-arm/arch-ixp2000/io.h modified to have (void __iomem *) in front of the alignment code
include/asm/arch/system.h:22: warning: `cli' is deprecated (declared at include/linux/interrupt.h:65)
cli() replace by local_irq_disable
arch/arm/mach-ixp2000/ixdp2x01.c:116: warning: passing arg 1 of `ixp2000_reg_write' from incompatible pointer type
arch/arm/mach-ixp2000/ixdp2x01.c:117: warning: passing arg 1 of `ixp2000_reg_write' from incompatible pointer type
fixed definition of the cpld registers IXDP2X01_CPLD_VIRT_REG()

Signed-off-by: Ben DooksLooks okay.  Test-booted on ENP-2611, no problem.
Signed-off-by: Lennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: Russell King

Patch from Ben Dooks

Add Guillaume Gourat to list of port contributors

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Add missing S3C2410_TCFG1_MUX4_SHIFT
Patch from Guillaume Gourat

Signed-off-by: Guillaume GOURAT

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Add s3c2440 camera interface device definition
Patch from Guillaume GOURAT

Signed-off-by: Guillaume GOURAT

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Add PM hook to power board down when requested

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from John Lenz

Add the list of devices on the locomo chip, and change around
how resources and struct resource are used.  There is only one
struct resource for the entire locomo, but each driver will
call request_mem_region on the pieces it is using.
Secondly, add a few helper functions to locomo.c to control
GPIOs and DAC.

Signed-off-by: John Lenz
Signed-off-by: Russell King

Patch from Deepak Saxena

Patch 2449/1 depends on this since it removes REG_OFFSET from the
individual board implementations.

Signed-off-by: Deepak Saxena
Signed-off-by: Russell King

Patch from Deepak Saxena

Signed-off-by: Deepak Saxena
Signed-off-by: Russell King

Patch from Deepak Saxena

No longer maintained, not sure one can even buy one of these.

Signed-off-by: Deepak Saxena
Signed-off-by: Russell King

Add __iomem annotations and use iomem functions where appropriate.
Separate out expansion card allocation/initialisation and freeing.
Convert device attributes to be handled by driver core.
Clean up deprecated function warnings for internal ecard_address
usage.
Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

This eliminates the final usage of deprecated elements in scsi_host by
Acorn SCSI drivers.
Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Make these "naked" functions.  This allows us to eliminate the
clobbers which later gcc versions complain about.
Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Add demultiplexed socket and ipc syscalls.  Add key syscalls.

Leave the new numbers for the demultiplexed socket and ipc syscalls
commented out in asm-arm/unistd.h for the time being.
Signed-off-by: Russell King <rmk@arm.linux.org.uk>

You really don't want -2 (which was just a cut-and-paste of the initial
value for the parameter) for the file mode in sysfs.
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Send audit repsonse to socket which request came from, rather than pid that
request came from.
Signed-off-by: Chris Wright <chrisw@osdl.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into ppc970.osdl.org:/home/torvalds/v2.6/linux

count is size_t, fill_write_buffer() may return a negative number
which would evade the 'count > 0' checks and do bad things.

found by the Coverity tool
Signed-off-by: Alexander Nyberg <alexn@dsv.su.se>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Remember to release the PCI regions on an error path.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Audit inode filter drops high bits on inode number by cut 'n paste mistake.
Signed-off-by: Chris Wright <chrisw@osdl.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>