allow to compile MAVSDK v0.39.0

CAstral/CAstral.h

@@ -11,7 +11,7 @@
 #endif
 
 #undef MAVLINK_THIS_XML_HASH
-#define MAVLINK_THIS_XML_HASH -7221795381553568663
+#define MAVLINK_THIS_XML_HASH 6031851515892169057
 
 #ifdef __cplusplus
 extern "C" {
@@ -276,7 +276,8 @@ typedef enum MAV_SYS_STATUS_SENSOR
    MAV_SYS_STATUS_TERRAIN=4194304, /* 0x400000 Terrain subsystem health | */
    MAV_SYS_STATUS_REVERSE_MOTOR=8388608, /* 0x800000 Motors are reversed | */
    MAV_SYS_STATUS_LOGGING=16777216, /* 0x1000000 Logging | */
-   MAV_SYS_STATUS_SENSOR_ENUM_END=16777217, /*  | */
+   MAV_SYS_STATUS_PREARM_CHECK=268435456, /* 0x10000000 pre-arm check status. Always healthy when armed | */
+   MAV_SYS_STATUS_SENSOR_ENUM_END=268435457, /*  | */
 } MAV_SYS_STATUS_SENSOR;
 #endif
 
@@ -429,6 +430,7 @@ typedef enum MAV_CMD
    MAV_CMD_DO_REPEAT_SERVO=184, /* Cycle a between its nominal setting and a desired PWM for a desired number of cycles with a desired period. |Servo number| PWM (microseconds, 1000 to 2000 typical)| Cycle count| Cycle time (seconds)| Empty| Empty| Empty|  */
    MAV_CMD_DO_FLIGHTTERMINATION=185, /* Terminate flight immediately |Flight termination activated if > 0.5| Empty| Empty| Empty| Empty| Empty| Empty|  */
    MAV_CMD_DO_CHANGE_ALTITUDE=186, /* Change altitude set point. |Altitude in meters| Mav frame of new altitude (see MAV_FRAME)| Empty| Empty| Empty| Empty| Empty|  */
+   MAV_CMD_DO_SET_ACTUATOR=187, /* Sets actuators (e.g. servos) to a desired value. The actuator numbers are mapped to specific outputs (e.g. on any MAIN or AUX PWM or UAVCAN) using a flight-stack specific mechanism (i.e. a parameter). |Actuator 1 value, scaled from [-1 to 1]. NaN to ignore.| Actuator 2 value, scaled from [-1 to 1]. NaN to ignore.| Actuator 3 value, scaled from [-1 to 1]. NaN to ignore.| Actuator 4 value, scaled from [-1 to 1]. NaN to ignore.| Actuator 5 value, scaled from [-1 to 1]. NaN to ignore.| Actuator 6 value, scaled from [-1 to 1]. NaN to ignore.| Index of actuator set (i.e if set to 1, Actuator 1 becomes Actuator 7)|  */
    MAV_CMD_DO_LAND_START=189, /* Mission command to perform a landing. This is used as a marker in a mission to tell the autopilot where a sequence of mission items that represents a landing starts. It may also be sent via a COMMAND_LONG to trigger a landing, in which case the nearest (geographically) landing sequence in the mission will be used. The Latitude/Longitude is optional, and may be set to 0/0 if not needed. If specified then it will be used to help find the closest landing sequence. |Empty| Empty| Empty| Empty| Latitude| Longitude| Empty|  */
    MAV_CMD_DO_RALLY_LAND=190, /* Mission command to perform a landing from a rally point. |Break altitude (meters)| Landing speed (m/s)| Empty| Empty| Empty| Empty| Empty|  */
    MAV_CMD_DO_GO_AROUND=191, /* Mission command to safely abort an autonmous landing. |Altitude (meters)| Empty| Empty| Empty| Empty| Empty| Empty|  */
@@ -1365,7 +1367,7 @@ typedef enum TUNE_FORMAT
 
 
 #undef MAVLINK_THIS_XML_HASH
-#define MAVLINK_THIS_XML_HASH -7221795381553568663
+#define MAVLINK_THIS_XML_HASH 6031851515892169057
 
 #if MAVLINK_THIS_XML_HASH == MAVLINK_PRIMARY_XML_HASH
 # define MAVLINK_MESSAGE_INFO {MAVLINK_MESSAGE_INFO_HEARTBEAT, MAVLINK_MESSAGE_INFO_SYS_STATUS, MAVLINK_MESSAGE_INFO_SYSTEM_TIME, MAVLINK_MESSAGE_INFO_PING, MAVLINK_MESSAGE_INFO_CHANGE_OPERATOR_CONTROL, MAVLINK_MESSAGE_INFO_CHANGE_OPERATOR_CONTROL_ACK, MAVLINK_MESSAGE_INFO_AUTH_KEY, MAVLINK_MESSAGE_INFO_SET_MODE, MAVLINK_MESSAGE_INFO_PARAM_REQUEST_READ, MAVLINK_MESSAGE_INFO_PARAM_REQUEST_LIST, MAVLINK_MESSAGE_INFO_PARAM_VALUE, MAVLINK_MESSAGE_INFO_PARAM_SET, MAVLINK_MESSAGE_INFO_GPS_RAW_INT, MAVLINK_MESSAGE_INFO_GPS_STATUS, MAVLINK_MESSAGE_INFO_SCALED_IMU, MAVLINK_MESSAGE_INFO_RAW_IMU, MAVLINK_MESSAGE_INFO_RAW_PRESSURE, MAVLINK_MESSAGE_INFO_SCALED_PRESSURE, MAVLINK_MESSAGE_INFO_ATTITUDE, MAVLINK_MESSAGE_INFO_ATTITUDE_QUATERNION, MAVLINK_MESSAGE_INFO_LOCAL_POSITION_NED, MAVLINK_MESSAGE_INFO_GLOBAL_POSITION_INT, MAVLINK_MESSAGE_INFO_RC_CHANNELS_SCALED, MAVLINK_MESSAGE_INFO_RC_CHANNELS_RAW, MAVLINK_MESSAGE_INFO_SERVO_OUTPUT_RAW, MAVLINK_MESSAGE_INFO_MISSION_REQUEST_PARTIAL_LIST, MAVLINK_MESSAGE_INFO_MISSION_WRITE_PARTIAL_LIST, MAVLINK_MESSAGE_INFO_MISSION_ITEM, MAVLINK_MESSAGE_INFO_MISSION_REQUEST, MAVLINK_MESSAGE_INFO_MISSION_SET_CURRENT, MAVLINK_MESSAGE_INFO_MISSION_CURRENT, MAVLINK_MESSAGE_INFO_MISSION_REQUEST_LIST, MAVLINK_MESSAGE_INFO_MISSION_COUNT, MAVLINK_MESSAGE_INFO_MISSION_CLEAR_ALL, MAVLINK_MESSAGE_INFO_MISSION_ITEM_REACHED, MAVLINK_MESSAGE_INFO_MISSION_ACK, MAVLINK_MESSAGE_INFO_SET_GPS_GLOBAL_ORIGIN, MAVLINK_MESSAGE_INFO_GPS_GLOBAL_ORIGIN, MAVLINK_MESSAGE_INFO_PARAM_MAP_RC, MAVLINK_MESSAGE_INFO_MISSION_REQUEST_INT, MAVLINK_MESSAGE_INFO_SAFETY_SET_ALLOWED_AREA, MAVLINK_MESSAGE_INFO_SAFETY_ALLOWED_AREA, MAVLINK_MESSAGE_INFO_ATTITUDE_QUATERNION_COV, MAVLINK_MESSAGE_INFO_NAV_CONTROLLER_OUTPUT, MAVLINK_MESSAGE_INFO_GLOBAL_POSITION_INT_COV, MAVLINK_MESSAGE_INFO_LOCAL_POSITION_NED_COV, MAVLINK_MESSAGE_INFO_RC_CHANNELS, MAVLINK_MESSAGE_INFO_REQUEST_DATA_STREAM, MAVLINK_MESSAGE_INFO_DATA_STREAM, MAVLINK_MESSAGE_INFO_MANUAL_CONTROL, MAVLINK_MESSAGE_INFO_RC_CHANNELS_OVERRIDE, MAVLINK_MESSAGE_INFO_MISSION_ITEM_INT, MAVLINK_MESSAGE_INFO_VFR_HUD, MAVLINK_MESSAGE_INFO_COMMAND_INT, MAVLINK_MESSAGE_INFO_COMMAND_LONG, MAVLINK_MESSAGE_INFO_COMMAND_ACK, MAVLINK_MESSAGE_INFO_MANUAL_SETPOINT, MAVLINK_MESSAGE_INFO_SET_ATTITUDE_TARGET, MAVLINK_MESSAGE_INFO_ATTITUDE_TARGET, MAVLINK_MESSAGE_INFO_SET_POSITION_TARGET_LOCAL_NED, MAVLINK_MESSAGE_INFO_POSITION_TARGET_LOCAL_NED, MAVLINK_MESSAGE_INFO_SET_POSITION_TARGET_GLOBAL_INT, MAVLINK_MESSAGE_INFO_POSITION_TARGET_GLOBAL_INT, MAVLINK_MESSAGE_INFO_LOCAL_POSITION_NED_SYSTEM_GLOBAL_OFFSET, MAVLINK_MESSAGE_INFO_HIL_STATE, MAVLINK_MESSAGE_INFO_HIL_CONTROLS, MAVLINK_MESSAGE_INFO_HIL_RC_INPUTS_RAW, MAVLINK_MESSAGE_INFO_HIL_ACTUATOR_CONTROLS, MAVLINK_MESSAGE_INFO_OPTICAL_FLOW, MAVLINK_MESSAGE_INFO_GLOBAL_VISION_POSITION_ESTIMATE, MAVLINK_MESSAGE_INFO_VISION_POSITION_ESTIMATE, MAVLINK_MESSAGE_INFO_VISION_SPEED_ESTIMATE, MAVLINK_MESSAGE_INFO_VICON_POSITION_ESTIMATE, MAVLINK_MESSAGE_INFO_HIGHRES_IMU, MAVLINK_MESSAGE_INFO_OPTICAL_FLOW_RAD, MAVLINK_MESSAGE_INFO_HIL_SENSOR, MAVLINK_MESSAGE_INFO_SIM_STATE, MAVLINK_MESSAGE_INFO_RADIO_STATUS, MAVLINK_MESSAGE_INFO_FILE_TRANSFER_PROTOCOL, MAVLINK_MESSAGE_INFO_TIMESYNC, MAVLINK_MESSAGE_INFO_CAMERA_TRIGGER, MAVLINK_MESSAGE_INFO_HIL_GPS, MAVLINK_MESSAGE_INFO_HIL_OPTICAL_FLOW, MAVLINK_MESSAGE_INFO_HIL_STATE_QUATERNION, MAVLINK_MESSAGE_INFO_SCALED_IMU2, MAVLINK_MESSAGE_INFO_LOG_REQUEST_LIST, MAVLINK_MESSAGE_INFO_LOG_ENTRY, MAVLINK_MESSAGE_INFO_LOG_REQUEST_DATA, MAVLINK_MESSAGE_INFO_LOG_DATA, MAVLINK_MESSAGE_INFO_LOG_ERASE, MAVLINK_MESSAGE_INFO_LOG_REQUEST_END, MAVLINK_MESSAGE_INFO_GPS_INJECT_DATA, MAVLINK_MESSAGE_INFO_GPS2_RAW, MAVLINK_MESSAGE_INFO_POWER_STATUS, MAVLINK_MESSAGE_INFO_SERIAL_CONTROL, MAVLINK_MESSAGE_INFO_GPS_RTK, MAVLINK_MESSAGE_INFO_GPS2_RTK, MAVLINK_MESSAGE_INFO_SCALED_IMU3, MAVLINK_MESSAGE_INFO_DATA_TRANSMISSION_HANDSHAKE, MAVLINK_MESSAGE_INFO_ENCAPSULATED_DATA, MAVLINK_MESSAGE_INFO_DISTANCE_SENSOR, MAVLINK_MESSAGE_INFO_TERRAIN_REQUEST, MAVLINK_MESSAGE_INFO_TERRAIN_DATA, MAVLINK_MESSAGE_INFO_TERRAIN_CHECK, MAVLINK_MESSAGE_INFO_TERRAIN_REPORT, MAVLINK_MESSAGE_INFO_SCALED_PRESSURE2, MAVLINK_MESSAGE_INFO_ATT_POS_MOCAP, MAVLINK_MESSAGE_INFO_SET_ACTUATOR_CONTROL_TARGET, MAVLINK_MESSAGE_INFO_ACTUATOR_CONTROL_TARGET, MAVLINK_MESSAGE_INFO_ALTITUDE, MAVLINK_MESSAGE_INFO_RESOURCE_REQUEST, MAVLINK_MESSAGE_INFO_SCALED_PRESSURE3, MAVLINK_MESSAGE_INFO_FOLLOW_TARGET, MAVLINK_MESSAGE_INFO_CONTROL_SYSTEM_STATE, MAVLINK_MESSAGE_INFO_BATTERY_STATUS, MAVLINK_MESSAGE_INFO_AUTOPILOT_VERSION, MAVLINK_MESSAGE_INFO_LANDING_TARGET, MAVLINK_MESSAGE_INFO_CAP_STATUS, MAVLINK_MESSAGE_INFO_SERIAL_PASSTHROUGH, MAVLINK_MESSAGE_INFO_SERIAL_PASSTHROUGH_ACK, MAVLINK_MESSAGE_INFO_MISSION_HASH, MAVLINK_MESSAGE_INFO_TERRAIN_ELEVATION, MAVLINK_MESSAGE_INFO_CAP_STATUS_FREQUENT, MAVLINK_MESSAGE_INFO_ESTIMATOR_STATUS, MAVLINK_MESSAGE_INFO_WIND_COV, MAVLINK_MESSAGE_INFO_GPS_INPUT, MAVLINK_MESSAGE_INFO_GPS_RTCM_DATA, MAVLINK_MESSAGE_INFO_HIGH_LATENCY, MAVLINK_MESSAGE_INFO_VIBRATION, MAVLINK_MESSAGE_INFO_HOME_POSITION, MAVLINK_MESSAGE_INFO_SET_HOME_POSITION, MAVLINK_MESSAGE_INFO_MESSAGE_INTERVAL, MAVLINK_MESSAGE_INFO_EXTENDED_SYS_STATE, MAVLINK_MESSAGE_INFO_ADSB_VEHICLE, MAVLINK_MESSAGE_INFO_COLLISION, MAVLINK_MESSAGE_INFO_V2_EXTENSION, MAVLINK_MESSAGE_INFO_MEMORY_VECT, MAVLINK_MESSAGE_INFO_DEBUG_VECT, MAVLINK_MESSAGE_INFO_NAMED_VALUE_FLOAT, MAVLINK_MESSAGE_INFO_NAMED_VALUE_INT, MAVLINK_MESSAGE_INFO_STATUSTEXT, MAVLINK_MESSAGE_INFO_DEBUG, MAVLINK_MESSAGE_INFO_CAMERA_INFORMATION, MAVLINK_MESSAGE_INFO_CAMERA_SETTINGS, MAVLINK_MESSAGE_INFO_STORAGE_INFORMATION, MAVLINK_MESSAGE_INFO_CAMERA_CAPTURE_STATUS, MAVLINK_MESSAGE_INFO_CAMERA_IMAGE_CAPTURED, MAVLINK_MESSAGE_INFO_FLIGHT_INFORMATION, MAVLINK_MESSAGE_INFO_MOUNT_ORIENTATION, MAVLINK_MESSAGE_INFO_VIDEO_STREAM_INFORMATION, MAVLINK_MESSAGE_INFO_VIDEO_STREAM_STATUS, MAVLINK_MESSAGE_INFO_CAMERA_TRACKING_IMAGE_STATUS, MAVLINK_MESSAGE_INFO_GIMBAL_MANAGER_INFORMATION, MAVLINK_MESSAGE_INFO_GIMBAL_MANAGER_STATUS, MAVLINK_MESSAGE_INFO_GIMBAL_MANAGER_SET_ATTITUDE, MAVLINK_MESSAGE_INFO_GIMBAL_DEVICE_ATTITUDE_STATUS, MAVLINK_MESSAGE_INFO_PARAM_EXT_REQUEST_READ, MAVLINK_MESSAGE_INFO_PARAM_EXT_VALUE, MAVLINK_MESSAGE_INFO_PARAM_EXT_SET, MAVLINK_MESSAGE_INFO_PARAM_EXT_ACK, MAVLINK_MESSAGE_INFO_ODOMETRY, MAVLINK_MESSAGE_INFO_UTM_GLOBAL_POSITION, MAVLINK_MESSAGE_INFO_ACTUATOR_OUTPUT_STATUS, MAVLINK_MESSAGE_INFO_PLAY_TUNE_V2}

CAstral/mavlink.h

@@ -6,7 +6,7 @@
 #ifndef MAVLINK_H
 #define MAVLINK_H
 
-#define MAVLINK_PRIMARY_XML_HASH -7221795381553568663
+#define MAVLINK_PRIMARY_XML_HASH 6031851515892169057
 
 #ifndef MAVLINK_STX
 #define MAVLINK_STX 253