Issues that need to be handled:
* Handle PIC interrupts on any CPU irrespective of the apic mode
* In the apic lowest priority logical flat delivery mode, be prepared to
  handle the interrupt on any CPU irrespective of what the IO-APIC RTE says.
* Because of above, when the IO-APIC starts handling the legacy PIC interrupt,
  use the same vector that is being used by the PIC while programming the
  corresponding IO-APIC RTE.

Start with all the cpu's in the legacy PIC interrupts cfg->domain.

By the time IO-APIC starts taking over the PIC interrupts, apic driver
model is finalized. So depend on the assign_irq_vector() to update the
cfg->domain and retain the same vector that was used by PIC before.

For the logical apic flat mode, cfg->domain is updated (during the first
call to assign_irq_vector()) to contain all the possible online cpu's (0xff).
Vector used for the legacy PIC interrupt doesn't change when the IO-APIC
starts handling the interrupt. Any interrupt migration after that
doesn't change the cfg->domain or the vector used.

For other apic modes like physical mode, cfg->domain is updated
(during the first call to assign_irq_vector()) to the boot cpu (cpu-0),
with the same vector that is being used by the PIC. When that interrupt is
migrated to a different cpu, cfg->domin and the vector assigned will change
accordingly.
Tested-by: Borislav Petkov <bp@alien8.de>
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Link: http://lkml.kernel.org/r/1353970176.21070.51.camel@sbsiddha-desk.sc.intel.comSigned-off-by: H. Peter Anvin <hpa@linux.intel.com>