The MIPI DisCo device properties that are read by the driver from
platform firmware, or hard-coded in the driver, should only be
provided as sysfs entries when a driver probes successfully.

However the device status and device number is updated even when there
is no driver present, and hence can be updated when a Slave device is
detected on the bus without being described in platform firmware and
without any driver registered/probed.

As suggested by GregKH, the attribute group for Slave status and
device number is is added by default upon device registration.

Credits to Vinod Koul for the status_show() function, shared in a
separate patch and used as is here. The status table was modified to
remove an unnecessary enum and status_show() is handled in a different
group attribute than what was suggested by Vinod.
Tested-by: Srinivas Kandgatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Co-developed-by: Vinod Koul <vkoul@kernel.org>
Reviewed-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Link: https://lore.kernel.org/r/20200924194430.121058-3-pierre-louis.bossart@linux.intel.comSigned-off-by: Vinod Koul <vkoul@kernel.org>