On powerpc, watchpoint match range is double-word granular. On a
watchpoint hit, DAR is set to the first byte of overlap between actual
access and watched range. And thus it's quite possible that DAR does
not point inside user specified range. Ex, say user creates a
watchpoint with address range 0x1004 to 0x1007. So hw would be
configured to watch from 0x1000 to 0x1007. If there is a 4 byte access
from 0x1002 to 0x1005, DAR will point to 0x1002 and thus interrupt
handler considers it as extraneous, but it's actually not, because
part of the access belongs to what user has asked.

Instead of blindly ignoring the exception, get actual address range by
analysing an instruction, and ignore only if actual range does not
overlap with user specified range.

Note: The behavior is unchanged for 8xx.
Signed-off-by: Ravi Bangoria <ravi.bangoria@linux.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://lore.kernel.org/r/20191017093204.7511-5-ravi.bangoria@linux.ibm.com