Commit 02c54b35 authored by Abhishek Sahu's avatar Abhishek Sahu Committed by Greg Kroah-Hartman

mtd: nand: qcom: fix config error for BCH

commit 10777de5 upstream.

The configuration for BCH is not correct in the current driver.
The ECC_CFG_ECC_DISABLE bit defines whether to enable or disable the
BCH ECC in which

	0x1 : BCH_DISABLED
	0x0 : BCH_ENABLED

But currently host->bch_enabled is being assigned to BCH_DISABLED.

Fixes: c76b78d8 ("mtd: nand: Qualcomm NAND controller driver")
Signed-off-by: default avatarAbhishek Sahu <absahu@codeaurora.org>
Reviewed-by: default avatarArchit Taneja <architt@codeaurora.org>
Signed-off-by: default avatarBoris Brezillon <boris.brezillon@free-electrons.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent f2339a07
...@@ -1900,7 +1900,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host) ...@@ -1900,7 +1900,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host)
| wide_bus << WIDE_FLASH | wide_bus << WIDE_FLASH
| 1 << DEV0_CFG1_ECC_DISABLE; | 1 << DEV0_CFG1_ECC_DISABLE;
host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE
| 0 << ECC_SW_RESET | 0 << ECC_SW_RESET
| host->cw_data << ECC_NUM_DATA_BYTES | host->cw_data << ECC_NUM_DATA_BYTES
| 1 << ECC_FORCE_CLK_OPEN | 1 << ECC_FORCE_CLK_OPEN
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment