Commit 04abaf07 authored by Dave Gerlach's avatar Dave Gerlach Committed by Tony Lindgren

ARM: OMAP2+: omap_device: Sync omap_device and pm_runtime after probe defer

Starting from commit 5de85b9d ("PM / runtime: Re-init runtime PM
states at probe error and driver unbind") pm_runtime core now changes
device runtime_status back to after RPM_SUSPENDED after a probe defer.
Certain OMAP devices make use of "ti,no-idle-on-init" flag which causes
omap_device_enable to be called during the BUS_NOTIFY_ADD_DEVICE event
during probe, along with pm_runtime_set_active.

This call to pm_runtime_set_active typically will prevent a call to
pm_runtime_get in a driver probe function from re-enabling the
omap_device. However, in the case of a probe defer that happens before
the driver probe function is able to run, such as a missing pinctrl
states defer, pm_runtime_reinit will set the device as RPM_SUSPENDED and
then once driver probe is actually able to run, pm_runtime_get will see
the device as suspended and call through to the omap_device layer,
attempting to enable the already enabled omap_device and causing errors
like this:

omap-gpmc 50000000.gpmc: omap_device: omap_device_enable() called from
invalid state 1
omap-gpmc 50000000.gpmc: use pm_runtime_put_sync_suspend() in driver?

We can avoid this error by making sure the pm_runtime status of a device
matches the omap_device state before a probe attempt. By extending the
omap_device bus notifier to act on the BUS_NOTIFY_BIND_DRIVER event we
can check if a device is enabled in omap_device but with a pm_runtime
status of RPM_SUSPENDED and once again mark the device as RPM_ACTIVE to
avoid a second incorrect call to omap_device_enable.

Fixes: 5de85b9d ("PM / runtime: Re-init runtime PM states at probe
error and driver unbind")
Tested-by: default avatarFranklin S Cooper Jr. <fcooper@ti.com>
Signed-off-by: default avatarDave Gerlach <d-gerlach@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 351b7c49
......@@ -222,6 +222,14 @@ static int _omap_device_notifier_call(struct notifier_block *nb,
dev_err(dev, "failed to idle\n");
}
break;
case BUS_NOTIFY_BIND_DRIVER:
od = to_omap_device(pdev);
if (od && (od->_state == OMAP_DEVICE_STATE_ENABLED) &&
pm_runtime_status_suspended(dev)) {
od->_driver_status = BUS_NOTIFY_BIND_DRIVER;
pm_runtime_set_active(dev);
}
break;
case BUS_NOTIFY_ADD_DEVICE:
if (pdev->dev.of_node)
omap_device_build_from_dt(pdev);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment