Commit 04c46736 authored by Yuval Mintz's avatar Yuval Mintz Committed by David S. Miller

bnx2x: Add additional debug information

Add/Revise several debug prints in the bnx2x driver - on regular flows
as well as error flows.
Signed-off-by: default avatarYuval Mintz <yuvalmin@broadcom.com>
Signed-off-by: default avatarAriel Elior <ariele@broadcom.com>
Signed-off-by: default avatarEilon Greenstein <eilong@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 0926d499
......@@ -3486,9 +3486,10 @@ netdev_tx_t bnx2x_start_xmit(struct sk_buff *skb, struct net_device *dev)
}
DP(NETIF_MSG_TX_QUEUED,
"queue[%d]: SKB: summed %x protocol %x protocol(%x,%x) gso type %x xmit_type %x\n",
"queue[%d]: SKB: summed %x protocol %x protocol(%x,%x) gso type %x xmit_type %x len %d\n",
txq_index, skb->ip_summed, skb->protocol, ipv6_hdr(skb)->nexthdr,
ip_hdr(skb)->protocol, skb_shinfo(skb)->gso_type, xmit_type);
ip_hdr(skb)->protocol, skb_shinfo(skb)->gso_type, xmit_type,
skb->len);
eth = (struct ethhdr *)skb->data;
......@@ -4078,6 +4079,8 @@ static int bnx2x_alloc_fp_mem_at(struct bnx2x *bp, int index)
} else /* if rx_ring_size specified - use it */
rx_ring_size = bp->rx_ring_size;
DP(BNX2X_MSG_SP, "calculated rx_ring_size %d\n", rx_ring_size);
/* Common */
sb = &bnx2x_fp(bp, index, status_blk);
......
......@@ -1731,6 +1731,10 @@ static int bnx2x_set_ringparam(struct net_device *dev,
{
struct bnx2x *bp = netdev_priv(dev);
DP(BNX2X_MSG_ETHTOOL,
"set ring params command parameters: rx_pending = %d, tx_pending = %d\n",
ering->rx_pending, ering->tx_pending);
if (bp->recovery_state != BNX2X_RECOVERY_DONE) {
DP(BNX2X_MSG_ETHTOOL,
"Handling parity error recovery. Try again later\n");
......
......@@ -1027,6 +1027,17 @@ void bnx2x_panic_dump(struct bnx2x *bp, bool disable_int)
}
#ifdef BNX2X_STOP_ON_ERROR
/* event queue */
for (i = 0; i < NUM_EQ_DESC; i++) {
u32 *data = (u32 *)&bp->eq_ring[i].message.data;
BNX2X_ERR("event queue [%d]: header: opcode %d, error %d\n",
i, bp->eq_ring[i].message.opcode,
bp->eq_ring[i].message.error);
BNX2X_ERR("data: %x %x %x\n", data[0], data[1], data[2]);
}
/* Rings */
/* Rx */
for_each_valid_rx_queue(bp, i) {
......@@ -7395,8 +7406,10 @@ static int bnx2x_init_hw_func(struct bnx2x *bp)
/* FLR cleanup - hmmm */
if (!CHIP_IS_E1x(bp)) {
rc = bnx2x_pf_flr_clnup(bp);
if (rc)
if (rc) {
bnx2x_fw_dump(bp);
return rc;
}
}
/* set MSI reconfigure capability */
......@@ -9782,6 +9795,8 @@ static int bnx2x_prev_unload_uncommon(struct bnx2x *bp)
if (bnx2x_prev_is_path_marked(bp))
return bnx2x_prev_mcp_done(bp);
BNX2X_DEV_INFO("Path is unmarked\n");
/* If function has FLR capabilities, and existing FW version matches
* the one required, then FLR will be sufficient to clean any residue
* left by previous driver
......@@ -9917,7 +9932,8 @@ static void bnx2x_prev_interrupted_dmae(struct bnx2x *bp)
if (!CHIP_IS_E1x(bp)) {
u32 val = REG_RD(bp, PGLUE_B_REG_PGLUE_B_INT_STS);
if (val & PGLUE_B_PGLUE_B_INT_STS_REG_WAS_ERROR_ATTN) {
BNX2X_ERR("was error bit was found to be set in pglueb upon startup. Clearing");
DP(BNX2X_MSG_SP,
"'was error' bit was found to be set in pglueb upon startup. Clearing\n");
REG_WR(bp, PGLUE_B_REG_WAS_ERROR_PF_7_0_CLR,
1 << BP_FUNC(bp));
}
......@@ -12488,6 +12504,7 @@ static int bnx2x_init_one(struct pci_dev *pdev,
dev_err(&pdev->dev, "Cannot set interrupts\n");
goto init_one_exit;
}
BNX2X_DEV_INFO("set interrupts successfully\n");
/* register the net device */
rc = register_netdev(dev);
......
......@@ -4241,11 +4241,16 @@ int bnx2x_queue_state_change(struct bnx2x *bp,
unsigned long *pending = &o->pending;
/* Check that the requested transition is legal */
if (o->check_transition(bp, o, params))
rc = o->check_transition(bp, o, params);
if (rc) {
BNX2X_ERR("check transition returned an error. rc %d\n", rc);
return -EINVAL;
}
/* Set "pending" bit */
DP(BNX2X_MSG_SP, "pending bit was=%lx\n", o->pending);
pending_bit = o->set_pending(o, params);
DP(BNX2X_MSG_SP, "pending bit now=%lx\n", o->pending);
/* Don't send a command if only driver cleanup was requested */
if (test_bit(RAMROD_DRV_CLR_ONLY, &params->ramrod_flags))
......@@ -5029,8 +5034,11 @@ static int bnx2x_queue_chk_transition(struct bnx2x *bp,
* Don't allow a next state transition if we are in the middle of
* the previous one.
*/
if (o->pending)
if (o->pending) {
BNX2X_ERR("Blocking transition since pending was %lx\n",
o->pending);
return -EBUSY;
}
switch (state) {
case BNX2X_Q_STATE_RESET:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment