Commit 057d5e98 authored by Linus Torvalds's avatar Linus Torvalds

Merge branch 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c fixes from Wolfram Sang:
 "Some driver bugfixes for the I2C subsystem"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: ismt: initialize DMA buffer
  i2c: designware: 10-bit addressing mode enabling if I2C_DYNAMIC_TAR_UPDATE is set
  i2c: mv64xxx: Do not use writel_relaxed()
  i2c: mv64xxx: Fix some build warnings
  i2c: s3c2410: fix clk_disable/clk_unprepare WARNings
parents ec220be7 bf416910
......@@ -98,6 +98,8 @@
#define DW_IC_ERR_TX_ABRT 0x1
#define DW_IC_TAR_10BITADDR_MASTER BIT(12)
/*
* status codes
*/
......@@ -388,22 +390,34 @@ static int i2c_dw_wait_bus_not_busy(struct dw_i2c_dev *dev)
static void i2c_dw_xfer_init(struct dw_i2c_dev *dev)
{
struct i2c_msg *msgs = dev->msgs;
u32 ic_con;
u32 ic_con, ic_tar = 0;
/* Disable the adapter */
__i2c_dw_enable(dev, false);
/* set the slave (target) address */
dw_writel(dev, msgs[dev->msg_write_idx].addr, DW_IC_TAR);
/* if the slave address is ten bit address, enable 10BITADDR */
ic_con = dw_readl(dev, DW_IC_CON);
if (msgs[dev->msg_write_idx].flags & I2C_M_TEN)
if (msgs[dev->msg_write_idx].flags & I2C_M_TEN) {
ic_con |= DW_IC_CON_10BITADDR_MASTER;
else
/*
* If I2C_DYNAMIC_TAR_UPDATE is set, the 10-bit addressing
* mode has to be enabled via bit 12 of IC_TAR register.
* We set it always as I2C_DYNAMIC_TAR_UPDATE can't be
* detected from registers.
*/
ic_tar = DW_IC_TAR_10BITADDR_MASTER;
} else {
ic_con &= ~DW_IC_CON_10BITADDR_MASTER;
}
dw_writel(dev, ic_con, DW_IC_CON);
/*
* Set the slave (target) address and enable 10-bit addressing mode
* if applicable.
*/
dw_writel(dev, msgs[dev->msg_write_idx].addr | ic_tar, DW_IC_TAR);
/* Enable the adapter */
__i2c_dw_enable(dev, true);
......
......@@ -393,6 +393,9 @@ static int ismt_access(struct i2c_adapter *adap, u16 addr,
desc = &priv->hw[priv->head];
/* Initialize the DMA buffer */
memset(priv->dma_buffer, 0, sizeof(priv->dma_buffer));
/* Initialize the descriptor */
memset(desc, 0, sizeof(struct ismt_desc));
desc->tgtaddr_rw = ISMT_DESC_ADDR_RW(addr, read_write);
......
......@@ -234,9 +234,9 @@ static int mv64xxx_i2c_offload_msg(struct mv64xxx_i2c_data *drv_data)
ctrl_reg |= MV64XXX_I2C_BRIDGE_CONTROL_WR |
(msg->len - 1) << MV64XXX_I2C_BRIDGE_CONTROL_TX_SIZE_SHIFT;
writel_relaxed(data_reg_lo,
writel(data_reg_lo,
drv_data->reg_base + MV64XXX_I2C_REG_TX_DATA_LO);
writel_relaxed(data_reg_hi,
writel(data_reg_hi,
drv_data->reg_base + MV64XXX_I2C_REG_TX_DATA_HI);
} else {
......@@ -697,6 +697,7 @@ static const struct of_device_id mv64xxx_i2c_of_match_table[] = {
MODULE_DEVICE_TABLE(of, mv64xxx_i2c_of_match_table);
#ifdef CONFIG_OF
#ifdef CONFIG_HAVE_CLK
static int
mv64xxx_calc_freq(const int tclk, const int n, const int m)
{
......@@ -726,16 +727,12 @@ mv64xxx_find_baud_factors(const u32 req_freq, const u32 tclk, u32 *best_n,
return false;
return true;
}
#endif /* CONFIG_HAVE_CLK */
static int
mv64xxx_of_config(struct mv64xxx_i2c_data *drv_data,
struct device *dev)
{
const struct of_device_id *device;
struct device_node *np = dev->of_node;
u32 bus_freq, tclk;
int rc = 0;
/* CLK is mandatory when using DT to describe the i2c bus. We
* need to know tclk in order to calculate bus clock
* factors.
......@@ -744,6 +741,11 @@ mv64xxx_of_config(struct mv64xxx_i2c_data *drv_data,
/* Have OF but no CLK */
return -ENODEV;
#else
const struct of_device_id *device;
struct device_node *np = dev->of_node;
u32 bus_freq, tclk;
int rc = 0;
if (IS_ERR(drv_data->clk)) {
rc = -ENODEV;
goto out;
......
......@@ -1178,8 +1178,6 @@ static int s3c24xx_i2c_remove(struct platform_device *pdev)
i2c_del_adapter(&i2c->adap);
clk_disable_unprepare(i2c->clk);
if (pdev->dev.of_node && IS_ERR(i2c->pctrl))
s3c24xx_i2c_dt_gpio_free(i2c);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment