Commit 0c3439bc authored by Andrew Lunn's avatar Andrew Lunn Committed by David S. Miller

net: phy: Marvell: checkpatch - Comments

Use net style comment blocks, and wrap one block with long lines.
Signed-off-by: default avatarAndrew Lunn <andrew@lunn.ch>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent e26925ec
......@@ -257,7 +257,8 @@ static int marvell_config_aneg(struct phy_device *phydev)
/* The Marvell PHY has an errata which requires
* that certain registers get written in order
* to restart autonegotiation */
* to restart autonegotiation
*/
err = phy_write(phydev, MII_BMCR, BMCR_RESET);
if (err < 0)
......@@ -299,8 +300,7 @@ static int marvell_config_aneg(struct phy_device *phydev)
if (phydev->autoneg != AUTONEG_ENABLE) {
int bmcr;
/*
* A write to speed/duplex bits (that is performed by
/* A write to speed/duplex bits (that is performed by
* genphy_config_aneg() call above) must be followed by
* a software reset. Otherwise, the write has no effect.
*/
......@@ -359,8 +359,7 @@ static int m88e1111_config_aneg(struct phy_device *phydev)
}
#ifdef CONFIG_OF_MDIO
/*
* Set and/or override some configuration registers based on the
/* Set and/or override some configuration registers based on the
* marvell,reg-init property stored in the of_node for the phydev.
*
* marvell,reg-init = <reg-page reg mask value>,...;
......@@ -1057,7 +1056,8 @@ static int marvell_update_link(struct phy_device *phydev, int fiber)
int status;
/* Use the generic register for copper link, or specific
* register for fiber case */
* register for fiber case
*/
if (fiber) {
status = phy_read(phydev, MII_M1011_PHY_STATUS);
if (status < 0)
......@@ -1092,7 +1092,8 @@ static int marvell_read_status_page(struct phy_device *phydev, int page)
int fiber;
/* Detect and update the link, but return if there
* was an error */
* was an error
*/
if (page == MII_M1111_FIBER)
fiber = 1;
else
......@@ -1217,12 +1218,13 @@ static int marvell_read_status(struct phy_device *phydev)
if (err < 0)
goto error;
/* If the fiber link is up, it is the selected and used link.
* In this case, we need to stay in the fiber page.
* Please to be careful about that, avoid to restore Copper page
* in other functions which could break the behaviour
* for some fiber phy like 88E1512.
* */
/* If the fiber link is up, it is the selected and
* used link. In this case, we need to stay in the
* fiber page. Please to be careful about that, avoid
* to restore Copper page in other functions which
* could break the behaviour for some fiber phy like
* 88E1512.
*/
if (phydev->link)
return 0;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment