Commit 170df593 authored by Linus Walleij's avatar Linus Walleij Committed by Jonathan Cameron

iio: light: add DT bindings for Capella CM3605

This adds device tree bindings for the Capella Microsystems CM3605
ambient light sensor and short range proximity sensor.

Cc: devicetree@vger.kernel.org
Cc: Capella Microsystems <capellamicro@gmail.com>
Cc: Kevin Tsai <ktsai@capellamicro.com>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
parent 578f8d77
Capella Microsystems CM3605
Ambient Light and Short Distance Proximity Sensor
The CM3605 is an entirely analog part which however require quite a bit of
software logic to interface a host operating system.
This ALS and proximity sensor was one of the very first deployed in mobile
handsets, notably it is used in the very first Nexus One Android phone from
2010.
Required properties:
- compatible: must be: "capella,cm3605"
- aset-gpios: GPIO line controlling the ASET line (drive low
to activate the ALS, should be flagged GPIO_ACTIVE_LOW)
- interrupts: the IRQ line (such as a GPIO) that is connected to
the POUT (proximity sensor out) line. The edge detection must
be set to IRQ_TYPE_EDGE_BOTH so as to detect movements toward
and away from the proximity sensor.
- io-channels: the ADC channel used for converting the voltage from
AOUT to a digital representation.
- io-channel-names: must be "aout"
Optional properties:
- vdd-supply: regulator supplying VDD power to the component.
- capella,aset-resistance-ohms: the sensitivity calibration resistance,
in Ohms. Valid values are: 50000, 100000, 300000 and 600000,
as these are the resistance values that we are supplied with
calibration curves for. If not supplied, 100 kOhm will be assumed
but it is strongly recommended to supply this.
Example:
cm3605 {
compatible = "capella,cm3605";
vdd-supply = <&foo_reg>;
aset-gpios = <&foo_gpio 1 GPIO_ACTIVE_LOW>;
capella,aset-resistance-ohms = <100000>;
interrupts = <1 IRQ_TYPE_EDGE_BOTH>;
io-channels = <&adc 0x01>;
io-channel-names = "aout";
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment