i40evf: Fix a hardware reset support in VF driver

This patch fixes a hardware reset support in VF driver.
It is needed because when a hardware reset is detected
adapter->state is in __I40EVF_RESETTING state before
i40evf_reset_task is called. Without this patch
unloading VF driver after a hardware reset ends
with a system crash.
Signed-off-by: Paweł Jabłoński <pawel.jablonski@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e_main.c

@@ -2840,6 +2840,23 @@ static int i40e_vlan_rx_add_vid(struct net_device *netdev,
 	return ret;
 }
 
+/**
+ * i40e_vlan_rx_add_vid_up - Add a vlan id filter to HW offload in UP path
+ * @netdev: network interface to be adjusted
+ * @proto: unused protocol value
+ * @vid: vlan id to be added
+ **/
+static void i40e_vlan_rx_add_vid_up(struct net_device *netdev,
+				    __always_unused __be16 proto, u16 vid)
+{
+	struct i40e_netdev_priv *np = netdev_priv(netdev);
+	struct i40e_vsi *vsi = np->vsi;
+
+	if (vid >= VLAN_N_VID)
+		return;
+	set_bit(vid, vsi->active_vlans);
+}
+
 /**
  * i40e_vlan_rx_kill_vid - Remove a vlan id filter from HW offload
  * @netdev: network interface to be adjusted
@@ -2882,8 +2899,8 @@ static void i40e_restore_vlan(struct i40e_vsi *vsi)
 		i40e_vlan_stripping_disable(vsi);
 
 	for_each_set_bit(vid, vsi->active_vlans, VLAN_N_VID)
-		i40e_vlan_rx_add_vid(vsi->netdev, htons(ETH_P_8021Q),
-				     vid);
+		i40e_vlan_rx_add_vid_up(vsi->netdev, htons(ETH_P_8021Q),
+					vid);
 }
 
 /**

drivers/net/ethernet/intel/i40evf/i40evf_main.c

@@ -1925,7 +1925,8 @@ static void i40evf_reset_task(struct work_struct *work)
 	 * ndo_open() returning, so we can't assume it means all our open
 	 * tasks have finished, since we're not holding the rtnl_lock here.
 	 */
-	running = (adapter->state == __I40EVF_RUNNING);
+	running = ((adapter->state == __I40EVF_RUNNING) ||
+		   (adapter->state == __I40EVF_RESETTING));
 
 	if (running) {
 		netif_carrier_off(netdev);