Merge tag 'omap-for-v5.0/fixes-rc3' of...

Merge tag 'omap-for-v5.0/fixes-rc3' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into arm/fixes

Device tree fixes for omaps for v5.0-rc cycle

This series of dts fixes for omap devices fixes several device specific
regressions:

- The onenand timings for n950/n9 have been wrong for a while since
  we moved to dts based timings

- A typo for the cpcap pmic is now producing erors during boot as the
  level should be 0 for unconfigurable triggering instead of 1

- Changes for ti-sysc for omap5 left uart3 with debug flags that should
  not be set

- Fix a new dtc warning started showing up for omap3-gta04 grap_port

- With the generic MMC card detection code we need to fix the gpio
  in dts for n900 and am335x-shc

* tag 'omap-for-v5.0/fixes-rc3' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap:
  ARM: dts: am335x-shc.dts: fix wrong cd pin level
  ARM: dts: n900: fix mmc1 card detect gpio polarity
  ARM: dts: omap3-gta04: Fix graph_port warning
  ARM: dts: Remove unnecessary idle flags for omap5 uart3
  ARM: dts: omap4-droid4: Fix typo in cpcap IRQ flags
  ARM: OMAP: dts: N950/N9: fix onenand timings
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arch/arm/boot/dts/am335x-shc.dts

@@ -215,7 +215,7 @@ &mmc1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc1_pins>;
 	bus-width = <0x4>;
-	cd-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>;
+	cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
 	cd-inverted;
 	max-frequency = <26000000>;
 	vmmc-supply = <&vmmcsd_fixed>;

arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi

@@ -105,7 +105,7 @@ cpcap_usb2_phy: phy {
 			interrupts-extended = <
 				&cpcap 15 0 &cpcap 14 0 &cpcap 28 0 &cpcap 19 0
 				&cpcap 18 0 &cpcap 17 0 &cpcap 16 0 &cpcap 49 0
-				&cpcap 48 1
+				&cpcap 48 0
 			>;
 			interrupt-names =
 				"id_ground", "id_float", "se0conn", "vbusvld",

arch/arm/boot/dts/omap3-gta04.dtsi

@@ -714,11 +714,7 @@ &venc {
 
 	vdda-supply = <&vdac>;
 
-	#address-cells = <1>;
-	#size-cells = <0>;
-
 	port {
-		reg = <0>;
 		venc_out: endpoint {
 			remote-endpoint = <&opa_in>;
 			ti,channels = <1>;

arch/arm/boot/dts/omap3-n900.dts

@@ -814,7 +814,7 @@ &mmc1 {
 	/* For debugging, it is often good idea to remove this GPIO.
 	   It means you can remove back cover (to reboot by removing
 	   battery) and still use the MMC card. */
-	cd-gpios = <&gpio6 0 GPIO_ACTIVE_HIGH>; /* 160 */
+	cd-gpios = <&gpio6 0 GPIO_ACTIVE_LOW>; /* 160 */
 };
 
 /* most boards use vaux3, only some old versions use vmmc2 instead */

arch/arm/boot/dts/omap3-n950-n9.dtsi

@@ -370,6 +370,19 @@ onenand@0,0 {
 		compatible = "ti,omap2-onenand";
 		reg = <0 0 0x20000>;	/* CS0, offset 0, IO size 128K */
 
+		/*
+		 * These timings are based on CONFIG_OMAP_GPMC_DEBUG=y reported
+		 * bootloader set values when booted with v4.19 using both N950
+		 * and N9 devices (OneNAND Manufacturer: Samsung):
+		 *
+		 *   gpmc cs0 before gpmc_cs_program_settings:
+		 *   cs0 GPMC_CS_CONFIG1: 0xfd001202
+		 *   cs0 GPMC_CS_CONFIG2: 0x00181800
+		 *   cs0 GPMC_CS_CONFIG3: 0x00030300
+		 *   cs0 GPMC_CS_CONFIG4: 0x18001804
+		 *   cs0 GPMC_CS_CONFIG5: 0x03171d1d
+		 *   cs0 GPMC_CS_CONFIG6: 0x97080000
+		 */
 		gpmc,sync-read;
 		gpmc,sync-write;
 		gpmc,burst-length = <16>;
@@ -379,26 +392,27 @@ onenand@0,0 {
 		gpmc,device-width = <2>;
 		gpmc,mux-add-data = <2>;
 		gpmc,cs-on-ns = <0>;
-		gpmc,cs-rd-off-ns = <87>;
-		gpmc,cs-wr-off-ns = <87>;
+		gpmc,cs-rd-off-ns = <122>;
+		gpmc,cs-wr-off-ns = <122>;
 		gpmc,adv-on-ns = <0>;
-		gpmc,adv-rd-off-ns = <10>;
-		gpmc,adv-wr-off-ns = <10>;
-		gpmc,oe-on-ns = <15>;
-		gpmc,oe-off-ns = <87>;
+		gpmc,adv-rd-off-ns = <15>;
+		gpmc,adv-wr-off-ns = <15>;
+		gpmc,oe-on-ns = <20>;
+		gpmc,oe-off-ns = <122>;
 		gpmc,we-on-ns = <0>;
-		gpmc,we-off-ns = <87>;
-		gpmc,rd-cycle-ns = <112>;
-		gpmc,wr-cycle-ns = <112>;
-		gpmc,access-ns = <81>;
+		gpmc,we-off-ns = <122>;
+		gpmc,rd-cycle-ns = <148>;
+		gpmc,wr-cycle-ns = <148>;
+		gpmc,access-ns = <117>;
 		gpmc,page-burst-access-ns = <15>;
 		gpmc,bus-turnaround-ns = <0>;
 		gpmc,cycle2cycle-delay-ns = <0>;
 		gpmc,wait-monitoring-ns = <0>;
-		gpmc,clk-activation-ns = <5>;
-		gpmc,wr-data-mux-bus-ns = <30>;
-		gpmc,wr-access-ns = <81>;
-		gpmc,sync-clk-ps = <15000>;
+		gpmc,clk-activation-ns = <10>;
+		gpmc,wr-data-mux-bus-ns = <40>;
+		gpmc,wr-access-ns = <117>;
+
+		gpmc,sync-clk-ps = <15000>; /* TBC; Where this value came? */
 
 		/*
 		 * MTD partition table corresponding to Nokia's MeeGo 1.2

arch/arm/boot/dts/omap5-l4.dtsi

@@ -1046,8 +1046,6 @@ SYSC_OMAP2_SOFTRESET |
 					<SYSC_IDLE_SMART>,
 					<SYSC_IDLE_SMART_WKUP>;
 			ti,syss-mask = <1>;
-			ti,no-reset-on-init;
-			ti,no-idle-on-init;
 			/* Domains (V, P, C): core, core_pwrdm, l4per_clkdm */
 			clocks = <&l4per_clkctrl OMAP5_UART3_CLKCTRL 0>;
 			clock-names = "fck";