ASoC: pxa2xx-i2s: remove I2S pin setup

This removes the calls to pxa_gpio_mode from the pxa2xx-i2s driver.
Pin setup should be done during board init via pxa2xx_mfp_config
instead.
Signed-off-by: Philipp Zabel <philipp.zabel@gmail.com>
Acked-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>

sound/soc/pxa/pxa2xx-i2s.c

@@ -25,20 +25,11 @@
 
 #include <mach/hardware.h>
 #include <mach/pxa-regs.h>
-#include <mach/pxa2xx-gpio.h>
 #include <mach/audio.h>
 
 #include "pxa2xx-pcm.h"
 #include "pxa2xx-i2s.h"
 
-struct pxa2xx_gpio {
-	u32 sys;
-	u32	rx;
-	u32 tx;
-	u32 clk;
-	u32 frm;
-};
-
 /*
  * I2S Controller Register and Bit Definitions
  */
@@ -106,21 +97,6 @@ static struct pxa2xx_pcm_dma_params pxa2xx_i2s_pcm_stereo_in = {
 				  DCMD_BURST32 | DCMD_WIDTH4,
 };
 
-static struct pxa2xx_gpio gpio_bus[] = {
-	{ /* I2S SoC Slave */
-		.rx = GPIO29_SDATA_IN_I2S_MD,
-		.tx = GPIO30_SDATA_OUT_I2S_MD,
-		.clk = GPIO28_BITCLK_IN_I2S_MD,
-		.frm = GPIO31_SYNC_I2S_MD,
-	},
-	{ /* I2S SoC Master */
-		.rx = GPIO29_SDATA_IN_I2S_MD,
-		.tx = GPIO30_SDATA_OUT_I2S_MD,
-		.clk = GPIO28_BITCLK_OUT_I2S_MD,
-		.frm = GPIO31_SYNC_I2S_MD,
-	},
-};
-
 static int pxa2xx_i2s_startup(struct snd_pcm_substream *substream,
 			      struct snd_soc_dai *dai)
 {
@@ -181,9 +157,6 @@ static int pxa2xx_i2s_set_dai_sysclk(struct snd_soc_dai *cpu_dai,
 	if (clk_id != PXA2XX_I2S_SYSCLK)
 		return -ENODEV;
 
-	if (pxa_i2s.master && dir == SND_SOC_CLOCK_OUT)
-		pxa_gpio_mode(gpio_bus[pxa_i2s.master].sys);
-
 	return 0;
 }
 
@@ -194,10 +167,6 @@ static int pxa2xx_i2s_hw_params(struct snd_pcm_substream *substream,
 	struct snd_soc_pcm_runtime *rtd = substream->private_data;
 	struct snd_soc_dai *cpu_dai = rtd->dai->cpu_dai;
 
-	pxa_gpio_mode(gpio_bus[pxa_i2s.master].rx);
-	pxa_gpio_mode(gpio_bus[pxa_i2s.master].tx);
-	pxa_gpio_mode(gpio_bus[pxa_i2s.master].frm);
-	pxa_gpio_mode(gpio_bus[pxa_i2s.master].clk);
 	BUG_ON(IS_ERR(clk_i2s));
 	clk_enable(clk_i2s);
 	pxa_i2s_wait();
@@ -398,11 +367,6 @@ static struct platform_driver pxa2xx_i2s_driver = {
 
 static int __init pxa2xx_i2s_init(void)
 {
-	if (cpu_is_pxa27x())
-		gpio_bus[1].sys = GPIO113_I2S_SYSCLK_MD;
-	else
-		gpio_bus[1].sys = GPIO32_SYSCLK_I2S_MD;
-
 	clk_i2s = ERR_PTR(-ENOENT);
 	return platform_driver_register(&pxa2xx_i2s_driver);
 }